Search

The decrease in costs and dimensions of GNSS receivers has enabled their adoption for a very wide range of users. Formerly mediocre positioning performance is benefiting from recent technology advances, namely the adoption of multi-constellation, multi-frequency receivers. In our study, we evaluate signal characteristics and horizontal accuracies achievable with two low-cost receivers—a Google Pixel 5 smartphone and a u-Blox ZED F9P standalone receiver. The considered conditions include open area with nearly optimal signal reception, but also locations with differing amounts of tree canopy. GNSS data were acquired using ten 20 min observations under leaf-on and leaf-off conditions. Post-processing in static mode was conducted using the Demo5 fork of the RTKLIB open source software, which is adapted for usage with lower quality measurement data. The F9P receiver provided consistent results with sub-decimeter median horizontal errors even under tree canopy. The errors for the Pixel 5 smartphone were under 0.5 m under open-sky conditions and around 1.5 m under vegetation canopy. The adaptation of the post-processing software to lower quality data was proven crucial, especially for the smartphone. In terms of signal quality (carrier-to-noise density, multipath), the standalone receiver provided significantly better data than the smartphone. [ABSTRACT FROM AUTHOR]

The geodetic monitoring of local displacements and deformations is often needed for civil engineering structures and natural phenomena like, for example, landslides. A local permanent GNSS (Global Navigation Satellite Systems) network can be installed: receiver positions in the interest area are estimated and monitored with respect to reference stations. Usually, GNSS geodetic receivers are adopted and provide results with accuracies at the millimeter level: however, they are very expensive and the initial cost and the risk of damage and loss can discourage this approach. In this paper the accuracy and the reliability of low-cost u-blox GNSS receivers are experimentally investigated for local monitoring. Two experiments are analyzed. In the first, a baseline (65 m long) between one geodetic reference receiver and one u-blox is continuously observed for one week: the data are processed by hourly sessions and the results provide comparisons between two processing packages and a preliminary accuracy assessment. Then, a network composed of one geodetic and two u-blox receivers is set up. One u-blox is installed on a device (slide) that allows to apply controlled displacements. The geodetic and the other u-blox (at about 130 m) act as references. The experiment lasts about two weeks. The data are again processed by hourly sessions. The estimated displacements of the u-blox on the slide are analyzed and compared with the imposed displacements. All of the results are encouraging: in the first experiment the standard deviations of the residuals are smaller than 5 mm both in the horizontal and vertical; in the second, they are slightly worse but still satisfactory (5 mm in the horizontal and 13 mm in vertical) and the imposed displacements are almost correctly identified. [ABSTRACT FROM AUTHOR]

Snowpack is an important fresh water storage; the retrieval of snow water equivalents from satellite data permits to estimate potentially available water amounts which is an essential parameter in water management plans running in several application fields (e.g., basic needs, hydroelectric, agriculture, hazard and risk monitoring, climate change studies). The possibility to assess snowpack height from Global Navigation Satellite Systems (GNSS) observations by means of the GNSS reflectometry technique (GNSS-R) has been shown by several studies. However, in general, studies are being conducted using observations collected by continuously operating reference stations (CORS) built for geodetic purposes and equipped with geodetic-grade instruments. Moreover, CORS are located on sites selected according to criteria different from those more suitable for snowpack studies. In this work, beside an overview of key elements of GNSS reflectometry, single-frequency GNSS observations collected by u-blox M8T GNSS receivers and patch antennas from u-blox and Tallysman have been considered for the determination of antenna height from the snowpack surface on a selected test site. Results demonstrate the feasibility of GNSS-R even with non-geodetic-grade instruments, opening the way towards diffuse GNSS-R targeted applications. [ABSTRACT FROM AUTHOR]