Search

To explore the characteristics of rock deformation and failure under cyclic loading and unloading, the MTS815 rock mechanics test system and acoustic emission (AE) signal acquisition system were used to perform cyclic loading and unloading tests on red sandstone samples. The results showed that, compared with the uniaxial compression test, cyclic loading and unloading had a certain strengthening effect on the strength of the samples. The plastic deformation of the rock samples increased as the number of cycles increased. Based on AE signals, the cracking mode classification was analyzed on the basis of the average frequency and the rise angle of the waveforms. It was observed that the Felicity ratio gradually decreased with the increase in the stress level, which showed a cumulative damage effect. From the perspective of energy, the obvious increase of AE energy rate was mainly concentrated in the early and late stages of uniaxial compression, while the significant increase of dissipated energy rate occurred in the late stage of uniaxial compression. During the cyclic loading and unloading, most of the work done by external forces in the compaction stage and the elastic stage was converted into elastic strain energy, and dissipated energy began to gradually increase in the stage of stable fracture development. In addition, it was found that the damage evolution of the rock samples changed from slow to fast, and the dissipated energy ratio increased when failure was approaching.

In order to reveal the influence of prophase stress levels on the fatigue damage characteristics of granite, uniaxial fatigue tests of granite with different prophase stress levels were carried out on the basis of the MTS 815.04 rock mechanics test system. The results show that, under the same number of cycles, the failure degree increases with the increase of the prophase stress level. Under the low upper limit of cyclic stress, the tangent modulus and dissipated energy increase significantly with the increase of prophase stress level at the early stage of the cycle loading, while the increasing trend is not obvious with the increase of prophase stress level at the late stage. Under the high upper limit of cyclic stress, the tangent modulus and dissipated energy are less affected by the prophase stress level. The development trend of elastic release energy is not obvious with the increase of prophase stress level, which is less affected by the number of cycles. From the damage parameters defined by dissipative energy, under the low upper limit of cyclic stress, the initial damage is less affected by the prophase stress level. With the increase of the number of cycles, the influence of the prophase stress level on the development trend of the damage variable increases gradually. And the development trend of damage variables shows “C-shaped” damage.