Search

Abstract: For decades, residential and commercial roofs have been considered a prime location for installation of building integrated solar systems. In climatic conditions of East Tennessee, USA, an experimental solar roof was tested during 2009/2010, by a research team representing Metal Construction Association (MCA), and a consortium of building insulation companies, photovoltaic (PV) manufacturers, and energy research centers. The main objective was to thermally evaluate a new roofing technology utilizing amorphous silicon PV laminates integrated with the metal roof panels. In order to mitigate thermal bridging and reduce roof-generated thermal loads, this novel roof/attic assembly contained a phase change material (PCM) heat sink, a ventilated air cavity over the roof deck, and thermal insulation with an integrated reflective surface. During winter, the experimental roof was expected to work as a passive solar collector storing solar heat absorbed during the day, and increasing overall attic air temperature during the night. During summer, the PCM was expected to act as a heat sink, reducing the heat gained by the attic and consequently, lowering the building cooling-loads. In this paper, field thermal performance data of the experimental PV-PCM roof/attic system are presented and discussed. Performance of the PV-PCM roof/attic is evaluated by comparing it to a control asphalt shingle roof. The test results showed about 30% heating and 50% cooling load reductions are possible with the experimental roof configuration. [Copyright &y& Elsevier]

Abstract: In cooling buildings, the use of solar energy can save around 50% of primary energy. Many studies have demonstrated the interest of such systems. However, developing and improving reliability of new components, design, control, and implementation remain a major concern. The performances of solar cooling systems are greatly influenced by climatic conditions. Indeed they affect both the driving energy of the chiller and the heat rejection. It is important to mention that internal loads and control strategy also have an impact on energy performances. Therefore, assessing the energy performance during the design phase is a key point in evaluating the economic interest of an installation. Moreover, once the commissioning of the installation is accomplished, there is a need to follow through and ensure its performance, since a large number of malfunctions can affect the quality of the system. Actual performances can be very different from those calculated in the design phase. With this aim, the present article deals with the development of an absorption chiller model used in an existing solar cooling system. This installation includes a single effect absorption chiller with a nominal chilling capacity of 30kW (EAW LB30 chiller functioning with water and lithium bromide), and it cools four classrooms of a University building in Reunion Island which is situated under a tropical climate. This pilot plant is very good monitored and can thus be used to develop and validate the absorption chiller model. The present paper first recalls the absorption principle and presents the pilot plant, the metrology, and the control strategy. Secondly, the experimental results are analysed and the steady state chiller model and also the identification method are developed. Thereafter, the simplex method is used to determine the design parameters of the machine. Finally, the simulation results are presented. The good agreement between the prediction and the experimental results allows the use of the model not only to design an installation but also to follow and control its performances. [Copyright &y& Elsevier]