Search

The desorption of benzene, 1,3,5-trifluorobenzene (TFB), and hexafluorobenzene (HFB) from a graphene covered Pt(111) substrate was investigated using temperature-programmed desorption (TPD). All three species have well-resolved monolayer and second-layer desorption peaks. The desorption spectra for submonolayer coverages of benzene and HFB are consistent with first-order desorption kinetics. In contrast, the submonolayer TPD spectra for TFB align on a common leading-edge, which is indicative of zero-order desorption kinetics. The desorption behavior of the three molecules can be correlated with the strength of the quadrupole moments. Calculations (second-order Møller-Plesset perturbation and density functional theory) show that the potential minimum for coplanar TFB dimers is more than a factor of 2 greater than that for either benzene or HFB dimers. The calculations support the interpretation that benzene and HFB are less likely to form the two-dimensional islands that are needed for submonolayer zero-order desorption kinetics.

The melting and wetting of nanoscale crystalline ice films on Pt(111) that are transiently heated above the melting point in ultrahigh vacuum (UHV) using nanosecond laser pulses are studied with infrared reflection absorption spectroscopy and Kr temperature-programmed desorption. The as-grown crystalline ice films consist of nanoscale ice crystallites embedded in a hydrophobic water monolayer. Upon heating, these crystallites melt to form nanoscale droplets of liquid water. Rapid cooling after each pulse quenches the films, allowing them to be interrogated with UHV surface science techniques. With each successive heat pulse, these liquid drops spread across the surface until it is entirely covered with a multilayer water film. These results, which show that nanoscale water films completely wet Pt(111), are in contrast to molecular dynamics simulations predicting partial wetting of water drops on a hydrophobic water monolayer. The results provide valuable insights into the wetting characteristics of nanoscale water films on a clean, well-characterized, single-crystal surface.

Inert gas permeation is used to investigate the formation of stable glasses of toluene and ethylbenzene. The effect of deposition temperature (T(dep)) on the kinetic stability of the vapor deposited glasses is determined using Kr desorption spectra from within sandwich layers of either toluene or ethylbenzene. The results for toluene show that the most stable glass is formed at T(dep) = 0.92 T(g), although glasses with a kinetic stability within 50% of the most stable glass were found with deposition temperatures from 0.85 to 0.95 T(g). Similar results were found for ethylbenzene, which formed its most stable glass at 0.91 T(g) and formed stable glasses from 0.81 to 0.96 T(g). These results are consistent with recent calorimetric studies and demonstrate that the inert gas permeation technique provides a direct method to observe the onset of molecular translation motion that accompanies the glass to supercooled liquid transition.

We have investigated the nucleation and growth of crystalline ice in 0.24 μm thick, supercooled water films adsorbed on Pt(111). The films were transiently heated with ∼10 ns infrared laser pulses, which produced typical heating and cooling rates of ∼109–1010 K/s. The crystallization of these water films was monitored with infrared spectroscopy. The experimental conditions were chosen to suppress ice nucleation at both the water/metal and water/vacuum interfaces. Furthermore, internal pressure increases due to curvature effects are precluded in these flat films. Therefore, the experiments were sensitive to the homogeneous ice nucleation rate from ∼210 to 225 K. The experiments show that Jmax, the maximum for the homogeneous ice nucleation rate, J(T), needs to be ≥1026 m–3 s–1 and is likely to be ∼1029±2 m–3 s–1. We argue that such large nucleation rates are consistent with experiments on hyperquenched glassy water, which typically have crystalline fractions of ∼1% or more.

Experimental measurements of the properties of supercooled liquids at temperatures near their glass transition temperatures, Tg, are requisite for understanding the behavior of glasses and amorphous solids. Unfortunately, many supercooled molecular liquids rapidly crystallize at temperatures far above their Tg, making such measurements difficult to nearly impossible. In this Perspective, we discuss some recent alternative approaches to obtain experimental data in the temperature regime near Tg. These new approaches may yield the additional experimental data necessary to test current theoretical models of the dynamical slowdown that occurs in supercooled liquids approaching the glass transition.

Do liquid mixtures, cooled to temperatures below their freezing point, behave as normal liquids? We address this question using nanoscale films of methanol and ethanol supercooled liquid solutions of varying composition (7 -93% methanol) at temperatures near their glass transition,Tg. The permeation of Kr through these films is used to determine the diffusivities of the supercooled liquid mixtures. We find that the temperature dependent diffusivities of the mixtures are well-fit by a Vogel-Fulcher-Tamman equation indicating that the mixtures exhibit fragile behavior at temperatures just above their Tg. Further, for a given temperature, the composition dependent diffusivity is well-fit by a Vignes-type equation, i.e. the diffusivity of any mixture can be predicted using an exponential weighting of the diffusion of the pure methanol and ethanol diffusivities. These results show that deeply supercooled liquid mixtures can be used to provide valuable insight into the properties of normal liquid mixtures.