Search

The dynamic stability of long combination vehicles (LCVs) is an important part of vehicle safety. An LCV, its driver and the road constitute a unique closed-loop dynamic system. Assessing the dynamic stability is difficult due to the complex interactions of driver-tractor-trailers-road. Rearward amplification (RA) is an effective performance measure of the dynamic stability; various methods are applied for evaluating the RA. However, the measures from different methods may differ significantly. What are the root causes for the disparity of evaluation results? This paper tackles the problem by investigating the typical methods for evaluating the measure of two LCVs, i.e. an A-train double and a B-train double. To this end, simulations of the LCVs are conducted using TruckSim software. The study discloses the main causes for the disparity of the measures from different methods, and recommends the effective approaches to the assessment of the RA. [ABSTRACT FROM AUTHOR]

Multi-trailer articulated heavy vehicles (MTAHVs) are increasingly used around the world due to their economic and environmental benefits. However, MTAHVs exhibit poor maneuverability and low lateral stability, which may lead to fatal traffic accidents. Given the safety risks, it is necessary to solve the steering and stability problems of MTAHVs before they are safely mass deployed on our roads. To this end, active trailer steering (ATS) based on the linear quadratic regulator (LQR) technique has been explored. The LQR-based ATS demonstrates improved maneuverability and enhanced lateral stability. In the ATS design, the vehicle and operating parameters are assumed constant. Thus, it is natural to question the robustness of the ATS in presence of vehicle and operating parameter uncertainties. To address the problem, this paper proposes a robust ATS system. The robust ATS controller is designed using a linear matrix inequality (LMI) based LQR method. In the design, both vehicle and steering actuator parameter uncertainties are considered; to enhance the robustness of the ATS, the weighting matrices of the proposed controller are optimized. The robust controller is applied to an A-Train Double, one type of MTAHV. The effectiveness of the robust ATS is demonstrated using numerical and hardware-in-the-loop real-time simulations. [ABSTRACT FROM AUTHOR]

The Society of Automotive Engineers issued a test procedure, SAE-J2179, to determine the rearward amplification (RA) of multi-trailer articulated heavy vehicles (MTAHVs). Built upon the procedure, the International Organization for Standardization released the test manoeuvres, ISO-14791, for evaluating directional performance of MTAHVs. For the RA measures, ISO-14791 recommends two single lane-change manoeuvres: (1) an open-loop procedure with a single sine-wave steering input; and (2) a closed-loop manoeuvre with a single sine-wave lateral acceleration input. For an articulated vehicle with active trailer steering (ATS), the RA measure in lateral acceleration under the open-loop manoeuvre was not in good agreement with that under the closed-loop manoeuvre. This observation motivates the research on the applicability of the two manoeuvres for the RA measures of MTAHVs with ATS. It is reported that transient response under the open-loop manoeuvre often leads to asymmetric curve of tractor lateral acceleration [Winkler CB, Fancher PS, Bareket Z, Bogard S, Johnson G, Karamihas S, Mink C. Heavy vehicle size and weight – test procedures for minimum safety performance standards. Final technical report, NHTSA, US DOT, contract DTNH22-87-D-17174, University of Michigan Transportation Research Institute, Report No. UMTRI-92-13; 1992]. To explore the effect of the transient response, a multiple cycle sine-wave steering input (MCSSI) manoeuvre is proposed. Simulation demonstrates that the steady-state RA measures of an MTAHV with and without ATS under the MCSSI manoeuvre are in excellent agreement with those under the closed-loop manoeuvre. It is indicated that between the two manoeuvres by ISO-14791, the closed-loop manoeuvre is more applicable for determining the RA measures of MTAHVs with ATS. [ABSTRACT FROM PUBLISHER]