Search

The trend in energy consumption, with a particular focus on heating and cooling demand, is an issue that is relevant to the promotion of new energy policies and more efficient energy systems. Moreover, heating and cooling energy demand is expected to rise in the next several decades, mainly due to climate change as well as increasing incomes in developing countries. In this context, the building sector is currently a relevant energy-intensive economic sector in Morocco; it accounts for 33% of the country's total energy demand (as the sector with the second highest energy demand, after the transport sector), with the residential sector accounting for 25% and the tertiary sector accounting for 8%. Aiming to reduce energy dependence and promote sustainable development, the Moroccan government recently issued a comprehensive plan to increase the share of renewables and improve energy efficiency. This strategy includes novel thermal building regulations promoted by the Moroccan Agency for Energy Efficiency. This paper analyzes the thermal behavior and heating-cooling energy demand of a residential building located in Tangier (Morocco) as a case example, based on the country's new thermal regulations and considering specific climatological conditions. A comparison with common Moroccan residential buildings as well as with those in nearby countries with similar meteorological conditions but significant differences in terms of energy demand regulation and requirements, such as Spain, is also included. Simulations were carried out using the DesingBuilder and EnergyPlus Software packages. According to the results, the last building thermal regulation requirements in Morocco need to be revised and extended in order to achieve the energy efficiency objectives established by the Moroccan government for 2030. [ABSTRACT FROM AUTHOR]

One of the main challenges for a further integration of renewable energy sources in the electricity grid is the development of large-scale energy storage systems to overcome their intermittency. This paper presents the concept named CHEST (Compressed Heat Energy STorage), in which the excess electricity is employed to increase the temperature of a heat source by means of a high-temperature heat pump. This heat is stored in a combination of latent and sensible heat storage systems. Later, the stored heat is used to drive an organic Rankine cycle, and hereby to produce electricity when needed. A novel application of this storage system is presented by exploring its potential integration in the Spanish technical constraints electricity market. A detailed dynamic model of the proposed CHEST system was developed and applied to a case study of a 26-MW wind power plant in Spain. Different capacities of the storage system were assessed for the case under study. The results show that roundtrip efficiencies above 90% can be achieved in all the simulated scenarios and that the CHEST system can provide from 1% to 20% of the total energy contribution of the power plant, depending on its size. The CHEST concept could be economically feasible if its capital expenditure (CAPEX) ranges between 200 and 650 k€/MW. [ABSTRACT FROM AUTHOR]

The use of lightweight concrete for the construction of single-family houses has become increasingly popular in Spain. In this paper, single-family houses with different shape factors and window-to-wall ratios are analysed from both a thermal and environmental perspective using Passive House Planning Package (PHPP) software to calculate the energy demand. The study has been carried out for different Atlantic microclimates (coastal, inland, and mountain) in northern Spain. What most affects the thermal energy used for air conditioning is the variation of the microclimates, so the study focuses mainly on this aspect. Operational energy for heating has decreased greatly via the use of high degree of insulation and hence the next task is to decrease the total energy consumed taking into account the embodied energy. Impacts on Primary Energy and Global Warming Potential are calculated using a cradle-to-grave approach. The energy use for heating and domestic hot water is analysed for different thicknesses of insulation under three energy supply scenarios: electricity only (for 2018 and with the Spanish decarbonisation plan for 2030); heat pump plus electricity; and natural gas boiler. Even for houses with a good level of insulation, the ratio of operational-to-total impacts varies significantly: from 46% to 87% for primary energy and from 31% to 75% for global warming potential, depending on the shape factor of the house, the microclimate and the heat supply scenario. By applying future environmental policies, electricity can become a more environmentally friendly option than natural gas. [ABSTRACT FROM AUTHOR]

Research Highlights: This paper compares the thermal requirements in three different olive-growing areas in the Mediterranean region (Toledo, central Spain; Lecce, southeastern Italy; Chaal, central Tunisia). A statistical method using a partial least square regression for daily temperatures has been applied to study the chilling and heat requirements over a continuous period. Background and Objectives: The olive is one of the main causes of pollen allergy for the population of Mediterranean cities. The physiological processes of the reproductive cycle that governs pollen emission are associated with temperature, and thermal requirements strongly regulate the different phases of the plant's life cycle. However, the point when several specific processes occur—Such as the phases within the dormancy period—Is unclear, and the transition between endodormancy and ecodormancy is not easily distinguishable from an empirical point of view. This work focuses on defining the thermal accumulation periods related to the temperature balance needed to meet the chilling and heat requirements for the metabolic activation and budbreak in olive trees. Results and Conclusions: Thermal accumulation patterns in olive trees are strongly associated with the bioclimatic conditions of olive-growing areas, and the olive flowering start dates showed significant differences between the three studied stations. Our results show that the chilling requirements were fulfilled between late autumn and early winter, although the chilling accumulation period was more evident in the coldest and most continental bioclimatic areas (central Spain). The heat accumulation period (forcing period) was clearly defined and showed a close relationship with the timing of olive flowering. Heat requirements were therefore used to generate accurate forecasting models to predict the beginning of the olive bloom and subsequent olive pollen emission. A forecasting model considering both the chilling and heat requirements was generated in Toledo, where the estimated days displayed an error of 2.0 ± 1.8 days from the observed dates. For Lecce, the error was 2.7 ± 2.5 days and for Chaal, 4.2 ± 2.4 days. [ABSTRACT FROM AUTHOR]

Energy poverty can be defined as the inability to pay the bills that are required for maintaining the comfort conditions (usually in winter) in dwellings. The use of energy efficient systems is one way forward to mitigate this problem, with one option being the electrically driven air source heat pump water heater. This paper assesses the performance of a centralised heat pump (200 kW of heating capacity) to meet the space heating demand of block dwellings in Madrid (tier four out of five in winter severity in Spain). Two models have been developed to obtain the following variables: the hourly thermal energy demand and the off-design heat pump performance. The proposed heat pump is driven by a motor with variable rotational speed to modulate the heating capacity in an efficient way. A back-up system is also considered to meet the peak demand. A levelised cost of heating of 92.22 €/MWh is obtained for a middle-level energy efficiency in housing (class E, close to D). Moreover, the following energy-environmental parameters have been achieved: more than 74% share of renewable energy in primary energy and 131.7 g CO2 avoided per kWh met. A reduction of 60% in the heating cost per dwelling is obtained if an energy retrofit is carried out, improving the energy performance class from E to C. These results prove that the proposed technology is among the most promising measures for addressing energy poverty in vulnerable households. [ABSTRACT FROM AUTHOR]

Rooftop gardens ona building have proved to be a good way to improve its storm water management, but many other benefits can be obtained from the installation of these systems, such as reduction of energy consumption, decrease of the heat stress, abatement on CO2 emissions, etc. In this paper, the effect from the presence of these rooftop gardens on abuilding's energy consumption has been investigated by experimental campaigns using a green roof ona public building in a Mediterranean location in Spain. The obtained results demonstrate a substantial improvement by the installation of the green roof onthe building's cooling energy demand for a standard summer day, in the order of 30%, and a reduction, about 15%, in the heating energy demand for a winter day. Thus, given the longer duration of the summer conditions along the year, a noticeable reduction on energy demand could be obtained. Simulation analysis, using commercial software TRNSYS code, previously calibrated using experimental data for typical summer and winter days, allows for the extrapolation to the entire year of these results deducing noticeable improvement in energy efficiency, in the order of 19%, but with an increase of 6% in the peak power during the winter period. [ABSTRACT FROM AUTHOR]

District heating (DH) is an important technology in future smart energy systems as it allows for an efficient implementation of various renewable energy sources. As DH develops towards lower temperatures and renewable electricity production increases, new types of heat sources become relevant. Thus, the aim of this article is to assess the potential for utilizing four unconventional excess heat (UEH) sources in DH systems, namely: Data centers, wastewater treatment, metros and service sector buildings. The main method used to assess the UEH potentials is an energy system analysis focusing on the availability and economic feasibility of utilizing the UEH sources in national contexts. The analysis consists of 2015 and 2050 scenarios for Germany, Spain and France. The results show a potential for utilizing the UEH potentials in all three countries, both in 2015 and 2050 systems. The potentials are highest in the 2050 scenarios, primarily due to larger DH shares. Furthermore, the potentials are limited by competition with other heat supply sources, conjunction with heat demands and feasible heat pump operation. In conclusion, the four UEH sources could impact the local DH systems, but in a national energy system context they are expected to play a minor role. [ABSTRACT FROM AUTHOR]

Off-gas is one of the by-products of the steelmaking process. Its potential energy can be transformed into heat and electricity by means of cogeneration. A case study using a coke oven and Linz–Donawitz converter gas is presented. This work addresses the gas allocation problem for a cogeneration system producing steam and electricity. In the studied facility, located in northern Spain, the annual production of the plant requires 95,000 MWh of electrical energy and 525,000 MWh of thermal energy. The installed electrical and thermal power is 20.4 MW and 81 MW, respectively. A mixed integer linear programming model is built to optimize gas allocation, thus maximizing its benefits. This model is applied to a 24-h scenario with real data from the plant, where gas allocation decision-making was performed by the plant operators. Application of the model generated profit in a scenario where there were losses, increasing benefits by 16.9%. A sensitivity analysis is also performed. The proposed model is useful not only from the perspective of daily plant operation but also as a tool to simulate different design scenarios, such as the capacity of gasholders. [ABSTRACT FROM AUTHOR]

Solar thermal plants are often considered as a convenient and environmentally friendly way to supply heat to buildings or low temperature industrial processes. Some modelling techniques are required to assess the dynamic behaviour of solar thermal plants in order to control them correctly. This aspect is reinforced while large plants are considered. Indeed, some atmospheric conditions, such as local clouds, could have significant influence on the outlet temperature of the solar field. A common modelling approach to assess the heat transport in pipes is the one-dimensional finite volume method. However, previous work shows limitations in the assessment of the temperatures and in the computational time required for simulating large pipe networks. In this contribution, a previous alternative method developed and validated in a district heating network is used and extended to a solar thermal plant considering the thermal solar gain and the inertia of the pipes. The present contribution intends to experimentally validate this model on an existing solar plant facility available at the Plataforma Solar de Almeria in Spain. [ABSTRACT FROM AUTHOR]

Heat waves pose additional risks to urban spaces because of the additional heat provided by urban heat islands (UHIs) as well as poorer air quality. Our study focuses on the analysis of UHIs, human thermal comfort, and air quality for the city of Madrid, Spain during heat waves. Heat wave periods are defined using the long-term records from the urban station Madrid-Retiro. Two types of UHI were studied: the canopy layer UHI (CLUHI) was evaluated using air temperature time-series from five meteorological stations; the surface UHI (SUHI) was derived from land surface temperature (LST) images from MODIS (Moderate Resolution Imaging Spectroradiometer) products. To assess human thermal comfort, the Physiological Equivalent Temperature (PET) index was applied. Air quality was analyzed from the records of two air quality networks. More frequent and longer heat waves have been observed since 1980; the nocturnal CLUHI and both the diurnal and nocturnal SUHI experience an intensification, which have led to an increasing number of tropical nights. Conversely, thermal stress is extreme by day in the city due to the lack of cooling by winds. Finally, air quality during heat waves deteriorates because of the higher than normal amount of particles arriving from Northern Africa. [ABSTRACT FROM AUTHOR]