Search

A radiation-tolerant digital multiphase current-mode hysteretic point-of-load regulator fabricated on a commercial 180-nm CMOS process is presented. Experiments and simulations are used to demonstrate its single-event immunity and its total-dose tolerance over 100 krad(Si). Key electrical performance parameters are: 5-V input, 0.8–3.3 V output, 10-A load current, 93% peak efficiency, four-phase hysteretic quasi-current-mode buck converter with ±1.5% frequency synchronization, ±3.6% current sharing error, and 1% ripple. [ABSTRACT FROM AUTHOR]

A fully integrated digital low-dropout regulator (DLDO) with a fast transient response, providing a regulated supply for system-on-chip (SoC) power management applications is proposed. Wideband operation and fast transient response are achieved through a transient enhanced proportional-integral controller, without compromising the stability of the DLDO at steady-state operation. The transient enhancement stage boosts loop-gain dynamically during load transients. In the gain boosting mode, the DLDO closed-loop bandwidth is increased, resulting in reduced undershoot/overshoot and fast settling. When the output voltage recovers to the desired level, the boost mode operation is disabled. For a load change with a 4-mA/ns slew rate between 10 and 50 mA, utilizing transient enhancement mode reduced the measured undershoot and overshoot by 35% and 17%, respectively. The characterization results show that the transient enhancement mode can reduce the settling time from 500 to 250 ns for a 10–50-mA load current change. The proposed DLDO operates with an input voltage ranging from 0.84 to 1.24 V, and output voltage ranging from 0.6 to 1 V. The maximum output current of the DLDO is 50 mA and the DLDO achieves a peak current efficiency of 99.2%, with DLDO figure of merit (FOM2) of 63.25 ps. The DLDO prototype chip is fabricated on a 0.13- \mu \textm CMOS technology and occupies a 0.0631-mm2 die area. [ABSTRACT FROM PUBLISHER]

An all-digital sliding-mode (ADSM) controlled dc-dc converter, utilizing single-bit oversampled frequency domain digitizers in its feedback path is proposed. Sliding-mode control provides several benefits over the traditional PID control in terms of fast transient response, robustness to parameter and component variations, and low sensitivity to loop disturbances. However, analog implementations of sliding-mode control require several amplifiers in the controller and suffer from process, voltage, and temperature variations. In the proposed approach, the sliding-mode controller (SMC) is implemented digitally; utilizing a first order single-bit ΣΔ frequency to digital converter (ΣΔFDC)-based feedback and reference digitizing ADCs, running at 32-MHz sampling rate. The ADSM regulator achieves 1% settling time in less than 5 μs for a load variation of 600 mA. The SMC uses a high-bandwidth hysteretic differentiator and an integrator to perform the sliding control law in digital domain. The proposed approach overcomes the steady-state error (or dc offset), and band limits the switching frequency, which are the two common problems associated with SMCs. The IC is designed and fabricated on a 0.35-μm CMOS process occupying an active area of 2.72 mm2. [ABSTRACT FROM AUTHOR]

This paper presents a digitally controlled programmable point-of-load regulator for next-generation power systems. A novel digital control scheme was designed to minimize single-event effect (SEE)-induced transient effects. By effectively programming the loop transmission, the POL can trade off transient response time with SET robustness. The IC works with 1 to 5.5 V input voltage, 1–4.5V regulated output voltage, high efficiency (peak efficiency at 94%) and power of up to 5 W. The design was fabricated in the AMI i2t100 0.7 \mum complimentary, metal-oxide semiconductor (CMOS) process and characterized with the Jet Propulsion Laboratory (JPL) pulsed laser system. [ABSTRACT FROM PUBLISHER]