Search

A new multicarrier system, termed multisymbol encapsulated orthogonal frequency division multiplexing (MSE-OFDM), is proposed, in which one cyclic prefix (CP) is used for multiple OFDM symbols. The original motivation for the MSE-OFDM proposal is to reduce the redundancy due to the CP in static-channel environments. The authors then found that an alternative implementation of the system can be used to improve the robustness to frequency offset and reduce the peak-to-average power ratio (PAPR). Equalization and demodulation algorithms for the MSE-OFDM system are proposed. A new preamble and the corresponding frequency-offset and channel estimation techniques are studied for the MSE-OFDM system. Using the proposed MSE-OFDM preamble, the joint maximum likelihood (ML) estimation of the frequency offset and the channel impulse response (CIR) is investigated in this paper. Possible ways to reduce the joint estimation complexity, including exploitation of the preamble structure, approximation of the joint ML estimator, and fast Fourier transform (FFT) pruning, are discussed. The performance of the proposed MSE-OFDM systems and channel estimators are analyzed and verified through numerical simulations. An analysis on the bandwidth efficiency, the performance with frequency offset, and the PAPR of the MSE-OFDM system are also presented. [ABSTRACT FROM AUTHOR]

Referring received signal strength (RSS) to a signal propagation model to find user location is one of the most promising strategies in wireless communications. This paper develops a simple method based on relative signal-strength measurements, that is, the differences in stationary signal strength measured at the user location from multiple base transceiver stations (BTSs). The stationary signal strength is the averaged RSS and also is a stationary Gaussian process. In using this method, it is vitally important to confirm that some uncertain propagation parameters can be canceled out while a signal propagation model is merged into our method for locating users. In this way, the differences in stationary signal strength lead to two solutions: One is the distance difference between pairs of BTSs, and the other is the distances from the user location to the multiple BTSs. Consequently, the hyperbolic positioning algorithm due to the distance-difference solution and the circular positioning algorithm due to the distances solution can be presented, respectively. Afterward, some experimental results were drawn from a field trial in a real propagation environment. Results show that the hyperbolic and circular positioning algorithms can locate the user to within about 350 and 300 m in 67 percentile, respectively. Compared with the numerical result reported in the literature on existing methods based on RSS only, our method is superior. Despite the result not meeting Federal Communications Commission (FCC) requirements, this method proved to be sufficiently simple and efficient in terms of the computation at burden and network signaling load. [ABSTRACT FROM AUTHOR]

Impulse radio (IR) and especially time-hopping IR (TH-IR) systems have attracted considerable attention since their introduction in the context of ultra wideband (UWB) systems in the early 1990s. Recently, with the U.S. Federal Communications Commission actions allowing for the wide-spread use of UWB radio systems, the interest in these systems has grown further. These systems promise to deliver high data rates in multiple access communication channels with very simple transmitter and receiver designs. The importance of multiuser detection for achieving high data rates with these systems has already been established in several studies. This paper studies several low-complexity multiuser detectors specifically designed for TH-IR radio systems. It is demonstrated that many multiuser detectors developed primarily for direct-sequence code division multiple access (DSCDMA) systems can be used essentially without any change in TH-IR receivers. Further, several novel, low-complexity multiuser detectors that exploit the special signal structure used for transmission by TH-LR systems are developed. These novel detectors are analyzed both theoretically and via simulations. It is shown that a very simple iterative multiuser detector yields performance that is similar to that of a single-user system. [ABSTRACT FROM AUTHOR]