Search

This paper depicts an accident that happened in 2010 in a Brazilian chemical plant. A combination of different events, installations, and commissioning errors coupled with equipment failures involving the primary substation resulted in catastrophic failure. A single-phase failure of a 138-kV disconnect switch, during closing, initiated events and phenomena that resulted in a complete plant shutdown. This paper will walk the reader through the events, forensics analysis, and power system analysis that allowed the authors to identify what happened, how it happened, and what to do to prevent it from happening again. This paper will show how the anatomy of the problem, involving equipment failure, single-phase arcing, switching transients, overvoltage, capacitive coupling, transferred surge voltages, ungrounded system, transient overvoltage due to an arcing ground fault on an ungrounded system, insulation coordination, flashover, and lack of adequate surge protection, all of which resulted in a catastrophic failure of an arc resistant switchgear and a potentially serious arc flash incident. The research followed some steps that will be commented on here as well as the lessons learned. [ABSTRACT FROM AUTHOR]

This paper presents a fuzzy control system to automate the operation of capacitor banks installed in a transmission substation. This automation intends to standardize operation and control voltage at the substation output bus. The system was implemented and tested with real data from a 345/138 kV transmission substation. The results obtained through the simulations are compared with the manual commands executed by the technicians from an operation center in Brazil. The outcomes showed the effectiveness of the proposed system to maintain the bar voltage considering the current load regime. In addition, the capacitor banks' operations numbers were reduced and standardized. [ABSTRACT FROM AUTHOR]

The main objective of this research is to propose an active and reactive power injection control in order to mitigate voltage sags. The proposed control strategy works in conjunction with a modified version of an automatic voltage regulator (AVR), where it will act on the active and reactive powers injected by the inverter to reduce the effects of voltage sags. In this way, the control will avoid possible shutdowns and damage to the equipment connected to the grid. The voltage improvement can be perceived for consumers connected to the power system. Modifications in AVR model and parameters are performed to speed up its performance, thus identifying the short-duration voltage variations (SDVV) and, consequently, the control acts to alter the powers, decreasing the active power injection and increasing the reactive power based on inverter capacity during the momentary voltage dip (MVD). Finally, when the fault is cleared, all values return to the pre-fault condition, so that the inverter only operates with active power. A 75 kW three-phase grid-connected photovoltaic system (GCPVS) equipped with the proposed control was inserted in a distribution grid of the city of Palmas, state of Tocantins, Brazil, and all of the computer simulations were performed on the Matlab/Simulink®. [ABSTRACT FROM AUTHOR]