Search

• The usage of correlation between maximum temperature and peak load. • The reconstruction of CT images identifies the debonding distribution and degree. • A novel inspection way of combing infrared imaging and micro CT reconstruction methods. • The role of axial yarns in axial crushing. In this work, the effect of axial yarns on damage behavior of two-dimensional triaxially braided composite(2DTBC) tubes subjected to axial compression was investigated. A novel damage detection method combining infrared thermography and CT scanning was presented. In the area without axial yarns, yarn crossovers were separated from each other due to interlacing patterns. Axial compression caused the braiding yarns to shear deformation like scissors. Inter-yarn de-bonding appeared in crossovers and could not connect. Consequently, it caused a progressively folding failure mode. In contrast, local buckling occurred on axial yarns because of their primary loading behavior. Cracks along the axial yarns formed, which would combine with debonding crossovers caused by the sheared braiding yarn. It resulted in significant inter-layer delamination and consequently splaying failure mode. The energy absorption of composites tube with 18 axial yarns increased by 79.9% at the cost of 27.8% fiber usage more than 3 axial yarns. [ABSTRACT FROM AUTHOR]

Localized deformation and damage mechanism of triaxial braided composite tubes, with different quantities and positions of axial yarns, were experimentally studied under transverse low-velocity impact. A high-speed infrared thermography was applied to analyze the transient thermo-mechanical failure process and afterwards verified by the external and internal damage characterization. It is found that the distribution of axial yarns has a significant effect on the mechanical behavior of braided composite tubes. The bending stiffness and peak force of the tubes were enhanced with the increased quantity of axial yarns, while the impact lasting time and displacement presented an opposite trend. And the more axial yarns assembled at the impact side, the greater force oscillatory of the tubes under low-velocity impact, accompanied by the decreased heat generation in small-angle braided tubes and the alleviated fiber tows fracture, delamination and in-plane shear cracks inside the wall of large-angle braided tubes. On the premise of the same quantity of axial yarns, the position effect plays a key role. Axial yarns concentrated at the impact side could restrain the damages spreading to the non-impact side by changing the damage mode of large-angle braided tubes. If a larger force is needed at the early stage, axial yarns could be inserted at the local position most probably to be impacted; Otherwise, it is highly suggested to braid at least one axial yarn in each layer at the impact side and non-impact side respectively to reinforce localized strength and prevent the impact-side indentation and non-impact-side delamination. • High-speed IR thermography verified by the external and internal damage characterization. • Effect of axial yarn quantity and location on mechanical behavior and damage mechanism. • Force oscillation response caused by dense distribution of axial yarns at the impact side. • Necessity of axial yarns in alleviating the severity of localized damages at the impact side. • Importance to install at least one axial yarn at the non-impact side of large-angle braided tube. [ABSTRACT FROM AUTHOR]