Search

In this work, the influence of the Fe and Fe/C co-doped buffer on the AlGaN/GaN HEMTs is systematically investigated and compared. Due to the pronounced Fe tail in the unintentionally doped layer of the Fe-doped buffer compared to the Fe/C co-doped buffer, and the utilization of a two-step C doping process in the Fe/C co-doped buffer, it results in effectively reducing leakage current and increasing breakdown voltage without sacrificing saturation current and peak transconductance. Meanwhile, the RF characteristics of the Fe/C co-doped buffer are also superior to the Fe-doped buffer. More importantly, Drain Transient Current measurements indicate that the current collapse in the Fe/C co-doped buffer is smaller than that in the Fe-doped buffer. Through simulation analysis, the reason was identified: In the near-channel region, the weaker Fe tail effect in Fe/C co-doped buffer leads to a lower acceptor trap ionization. When the concentration of C exceeds 1 × 1016 cm−3, the ionization of traps introduced by Fe is suppressed. Additionally, the two-step C impurity distribution in the Fe/C co-doped buffer design modulates the electric field and potential, reducing the effective range of the electric field and potential, thereby effectively reducing the trap effects. These results are highly meaningful for the design of high-power amplifier epitaxial structures. [ABSTRACT FROM AUTHOR]

In this paper, the ohmic contact mechanism and gate electrostatic control of a deep-recessed ohmic contact structure for multi-channel Al0.3Ga0.7N/GaN high electron mobility transistors (HEMTs) is investigated. A transmission electron microscope and an energy dispersive spectrum are utilized to investigate the ohmic contact interface mechanism. Due to a reduction of source/drain parasitic resistances and simultaneous connection of five channels by using deep-recessed ohmic contact, a large maximum drain current density and a distinct five hump feature of ultra-wider trans-conductance are achieved. More importantly, it is revealed that the downward expansion of the gate potential for the deep-recessed ohmic contact structure is much deeper than that for conventional devices. This characteristic leads to a remarkable reduction in subthreshold swing (SS) and off-state leakage, indicating an ultra-wide and high trans-conductance profile. The fabricated devices show a lower off-state drain leakage, a lower SS, and a wider gate voltage swing (40 V). Due to an enhancement of gate electrostatic control, the current collapse and electrical reliability characteristics of multi-channel Al0.3Ga0.7N/GaN HEMTs with deep-recessed ohmic contact also improve. The results presented here indicate that the multi-channel device has great potential for high current and wide bandwidth applications. [ABSTRACT FROM AUTHOR]

This work reports an AlN/GaN/InGaN high electron mobility transistor (HEMT) with a steep subthreshold swing (SS) of sub-60 mV/dec utilizing a coupling-channel architecture. The fabricated transistors show a negligible hysteresis, a SS of 39 mV/dec, a large gate voltage swing of >4.2 V, and achieving an excellent quality factor Q = gm/SS of 6.3 μS-dec/μm-mV. The negative differential resistance effect was found in the subthreshold region in the gate current–voltage (Ig–VGS) curve. The hot carrier transfer mechanism that occurred in the turn-on/pinch-off progress of the CC-HEMT under the dual-directional sweep, proved by the VDS- and Lg-dependent bi-directional transfer I–V characteristics, can be responsible for these excellent device performances. This work is believed to encourage further study of the AlN/GaN platform to power the future group III-nitrides CMOS technology. [ABSTRACT FROM AUTHOR]

In this work, ultrathin barrier (∼6 nm) AlGaN/GaN high-electron-mobility transistors (HEMTs) with in situ SiN gate dielectric and slant-field plate (SFP) T-gates were fabricated and analyzed. Since the proposed scheme of gate dielectric and SFP effectively suppresses the gate leakage and alleviates the peak electric field (E-field) around gate region, the maximum breakdown voltage (VBK) was improved to 92 V, which is 54 V higher than that of the conventional device. The fabricated ultrathin AlGaN/GaN HEMT with 60-nm SFP-T-gate exhibited the peak fT of 177 GHz and peak fmax of 393 GHz, yielding high figure-of-merits of fT · VBK = 16 THz V and fmax·VBK = 36 THz V. Moreover, load-pull measurements at 30 GHz reveal that these devices deliver output power density (Pout) of 4.6 W/mm at Vds = 20 V and high power-added efficiency up to 52.5% at Vds = 10 V. Essentially, the experimental results indicate that the employment of SFP and in situ SiN gate dielectric is an attractive approach to balance the breakdown and speed for millimeter wave devices. [ABSTRACT FROM AUTHOR]

In this work, high-performance millimeter-wave AlGaN/GaN structures for high-electron-mobility transistors (HEMTs) are presented using a Si-rich SiN passivation layer. The analysis of transient and x-ray photoelectron spectroscopy measurements revealed that the presence of the Si-rich SiN layer leads to a decrease in the deep-level surface traps by mitigating the formation of Ga–O bonds. This results in a suppressed current collapse from 11% to 5% as well as a decreased knee voltage (Vknee). The current gain cutoff frequency and the maximum oscillation frequency of the devices with the Si-rich SiN layer exhibit the values of 74 and 140 GHz, respectively. Moreover, load-pull measurements at 30 GHz show that the devices containing the Si-rich SiN deliver excellent output power density of 8.7 W/mm at Vds = 28 V and high power-added efficiency up to 48% at Vds = 10 V. The enhanced power performance of HEMTs using Si-rich SiN interlayer passivation is attributed to the reduced Vknee, the suppressed current collapse, and the improved drain current. [ABSTRACT FROM AUTHOR]