Search

To increase the power density of a wireless power transfer (WPT) system, the coupling of coils can be strong. However, in a strongly coupled series–series WPT system with a diode rectifier, currents can be distorted and discontinuous, and first harmonic approximation is no longer valid. The inverter is likely to work in hard switching, leading to extra noise, decreased efficiency, and a potential hazard for a safe operation. Through time-domain analysis, this article reveals that with a dual-side 90° phase shift, the hard switching of the inverter can be avoided, the power level can be enhanced, and the discontinuous conduction mode can be avoided to eliminate noises. The factors impacting the soft switching operations of the inverter and the rectifier are analyzed. To achieve 90° dual-side phase shift, the conventional approach of using the receiver voltage/current, which can be distorted and discontinuous in strongly coupled WPT systems, for phase synchronization is no longer suitable. A new set of coils, namely driving coils, is used for phase synchronization so that dual-side phase shift can be implemented independent from power transfer. Experimental results have validated the effectiveness of the analysis. [ABSTRACT FROM AUTHOR]

The pulse-density-modulation (PDM) zero-voltage-switching (ZVS) full-bridge converter is a promising power converter for wireless power transfer (WPT) systems. The converter has the advantages of both direct conversion ratio control and load-independent soft switching. These advantages reduce the overall system complexity and power loss. However, the converter suffers from the limitations of large low-frequency subharmonics, a narrowed modulation range, and a large modulation delay. These limitations are caused by the existing PDM strategy, which was designed to generate a symmetric ZVS current to ensure the ideal ZVS for minimizing the switching loss. This paper finds that even with an asymmetric ZVS current, the ideal ZVS can still be ensured by the negative feedback effect of the dead-time voltage. Based on this finding, a PDM strategy that allows asymmetric ZVS currents is proposed to overcome the aforementioned limitations. In experiments, a ZVS full-bridge converter was modulated by the existing and the proposed PDM strategies, respectively. The converter performances and responses were compared and the results showed that the proposed PDM strategy can overcome the limitations while achieving ZVS. The proposed PDM strategy was also tested in a WPT system for verification. [ABSTRACT FROM AUTHOR]