Search

The present study analyzed ROH and consensus ROH regions in 102 animals of eleven diverse Indian goat (Capra hircus) breeds using whole genome sequencing. A total of 51,705 ROH and 21,271 consensus regions were identified. The mean number of ROH per animal was highest in the meat breed, Jharkhand Black (2693) and lowest in the pashmina breed, Changthangi (60). The average length of ROH (ALROH) was maximum in Kanniadu (974.11 Kb) and minimum in Tellicherry (146.98 Kb). Long ROH is typically associated with more recent inbreeding, whereas short ROH is connected to more ancient inbreeding. The overall ROH-based genomic inbreeding (FROH) was highest for Jharkhand Black (0.602) followed by Kanniadu (0.120) and Sangamneri (0.108) among all breeds. FROH of Jharkhand Black was higher than Kanniadu up to 5 Mb ROH length category. However, in > 20 Mb ROH length category, Kanniadu (0.98) exhibited significantly higher FROH than Jharkhand Black (0.46). This implies that Kanniadu had higher levels of recent inbreeding than Jharkhand Black. Despite this, due to the presence of both recent and ancient inbreeding, Jharkhand Black demonstrated higher overall FROH compared to Kanniadu. ROH patterns revealed dual purpose (meat and dairy) and pashmina breeds as less consanguineous while recent inbreeding was apparent in meat breeds. Analysis of ROH consensus regions identified selection sweeps in key genes governing intramuscular fat deposition, meat tenderisation, lean meat production and carcass weight (CDK4, ALOX15, CASP9, PRDM16, DVL1) in meat breeds; milk fat percentage and mammary gland development (POLD1, NOTCH2, ARHGAP35) in dual purpose (meat and dairy) breeds; while cold adaptation and hair follicle development (APOBEC1, DNAJC3, F2RL1, FGF9) in pashmina breed. MAPK, RAS, BMP and Wnt signaling pathways associated with hair follicle morphogenesis in Changthangi were also identified. PCA analysis based on ROH consensus regions revealed that meat breeds are more diverse than other goat breeds/populations. [ABSTRACT FROM AUTHOR]

Among many applications of DC–DC isolated converters, power supplies, renewable energy sources, and electric vehicles are prominent. These converters are the basic, easy to use, low component count and being used in industry from a few decades. In this study, a unique operation mode of DC–DC isolated converter called “green mode” is proposed to increase the efficiency of converter under light load conditions. Switching losses of the converter can be reduced by using the converter’s secondary-side control method, which enables a reduction in the primary-side switches' switching frequency and turn-off duration. The converter also uses a soft switching mechanism to further minimize the switching losses. The converter achieves the output voltage of 24 V under different load conditions. Under No load condition the efficiency of the converter has significantly improved, which is 82.3%, due to reduced power losses under light load conditions. It is demonstrated through experimental data that validates the green-mode operation. Although the efficiency under full load conditions is around 79.7%. These DC–DC converters shall enhance the range of electric vehicle (EV) and shall be a boon to EV technology. [ABSTRACT FROM AUTHOR]

The widely used vitamin-E based amphiphilic material, tocopheryl polyethylene glycol succinate (TPGS) was further improvised to redox-sensitive thiolated TPGS (TPGS-SH), which has been achieved by attaching 4-aminothiophenol. Further, TPGS and TPGS-SH-coated bimetallic gold-silver nanoparticles (TPGS-Au-Ag-NP and TPGS-SH-Au-Ag-NP) were formulated to explore their antibacterial and wound healing abilities. The prepared NP were monodisperse with a mean hydrodynamic diameter of 69.5±3.23 nm, 59.65±3.23 nm, PDI of 0.3±0.05, 0.2±0.03 and a zeta potential of +29.2±2.71 mV and +35.28±1.53 mV, respectively. The TPGS and TPGS-SH modified Au-Ag-NP were tested for their antibacterial efficacy against methicillin-resistant Staphylococcus aureus (MRSA) and E. coli; minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) results showed that TPGS Au-Ag-NP, TPGS-SH-Au-Ag-NP displayed significantly stronger antibacterial activity than their coating material alone. The anti-efflux pump activity of the most potent antibacterial agent TPGS-SH-Au-Ag-NP was evaluated against MRSA. Toxicity assessment of TPGS-SH-Au-Ag-NP in human dermal fibroblasts showed 88% viability up to 125 µg/mL. The TPGS-SH-Au-Ag-NP, after incorporation in chitosan film (TPGS-SH-Au-Ag-NP-CS), exhibited sustained release and prolonged in vivo residence characteristics, which were evaluated by IVIS. Results also revealed that treatment with TPGS-SH-Au-Ag-NP showed a significant 87% wound healing rate after 12 days of application in the rat model. Hence, we concluded that TPGS-SH-Au-Ag-NP was safe and effective against test bacteria MRSA and capable of efficient wound healing when incorporated in chitosan film. [Display omitted] • Novel redox sensitive bimetallic gold-silver NPs synthesized. • TPGS and TPGS-SH modified Au-Ag-NPs exhibited enhanced antibacterial activity. • TPGS-SH-Au-Ag-NPs demonstrated the inhibition of efflux pumps. • TPGS-SH-Au-Ag-NPs loaded chitosan film showed sustained release. • TPGS-SH-Au-Ag-NP-CS exhibited remarkable wound healing potential in rats. [ABSTRACT FROM AUTHOR]