Search

Building energy models (BEMs) are typically used for design and code compliance for new buildings and in the renovation of existing buildings to predict energy use. The increasing adoption of BEM as standard practice in the building industry presents an opportunity to extend the use of BEMs into construction, commissioning and operation. In 2009, the authors developed a real-time simulation framework to execute an EnergyPlus model in real time to improve building operation. This paper reports an enhancement of that real-time energy simulation framework. The previous version only works with software tools that implement the custom co-simulation interface of the Building Controls Virtual Test Bed (BCVTB), such as EnergyPlus, Dymola and TRNSYS. The new version uses an open standard interface, the Functional Mockup Interface (FMI), to provide a generic interface to any application that supports the FMI protocol. In addition, the new version utilizes the Simple Measurement and Actuation Profile (sMAP) tool as the data acquisition system to acquire, store and present data. This paper introduces the updated architecture of the real-time simulation framework using FMI and presents proof-of-concept demonstration results which validate the new framework. [ABSTRACT FROM AUTHOR]

• A model to simulate interactions between a building and its outdoor conditions. • The model co-simulates EnergyPlus, OpenFOAM, and lumped thermal models. • The model provides proper estimates of outdoor conditions at the urban microscale. • Waste heat releases from the HVAC system can be simulated from the model. • Indirect and direct effects of green roofs can be considered by the model. This paper introduces a physically-based model to simulate interactions between a building and its outdoor conditions at the urban microscale. In the model, the building is simulated with EnergyPlus while its outdoor conditions are assessed from OpenFOAM. Furthermore, the model simulates the street pavement and surrounding buildings based on the lumped thermal theory. All components of the model are quasi-dynamically co-simulated. Through simulations of the model, waste heat releases from a cooling system can be observed with a higher resolution than this achieved by most urban microclimate models in the literature. Unlike several methods in the literature, the model evaluates a countermeasure to urban heat islands by considering direct and indirect effects simultaneously. To validate the model, measurements were collected during a field experiment in an university campus. Comparing measurements to estimates, the model seems to properly approximate the outdoor temperature and the air motion. However, a discrepancy is observed between estimates and measurements of the surface temperature. The discrepancy could be minimised if a better consideration of the net-longwave radiation was possible when co-simulating EnergyPlus. After some improvements, the model could become a support tool to mitigate urban heat islands and climate change in different regions of the world. [ABSTRACT FROM AUTHOR]