Search

In this paper, we present D flip-flop, Quatro, and stacked Quarto flip-flop designs fabricated in a commercial 28-nm CMOS FDSOI technology. Stacked-transistor structures are introduced in the stacked Quatro design to protect the sensitive devices of the original structure. Striking either of the stacked devices will not upset the latch because the conduction path to the supply rail is still cut off by the other off-state device. The irradiation experimental results substantiate that the stacked Quatro design has significantly better SEU tolerance (e.g., higher heavy ion upset Linear Energy Transfer threshold and smaller cross-section data) than the reference designs. It introduces power and area penalties because the proposed design duplicates and stacks two sensitive PMOS devices. Additionally, the impact of technology scaling on Quatro in various technology nodes (130-nm, 65-nm, and 40-nm) has been studied suggesting decreasing upset threshold and decreasing cross-section data. [ABSTRACT FROM AUTHOR]

A guard-gate based flip-flop circuit temporally hardened against single-event effects is presented in this paper. Compared to several existed techniques, the organization of components inside the proposed design allows the improved performance– only one $\tau $ (the maximum width of a single-event transient (SET) to tolerate) is added into the setup time. A previously reported low-power delay element is applied, which helps make the proposed design power-efficient. The proposed design was implemented in a 65 nm CMOS bulk technology. Alpha and heavy-ions radiation experiments were performed to characterize its soft-error rates. Experimental results show that the proposed design presents no error with LETs up to 37.3 MeV-cm2/mg. Simulation results from the TFIT further validate the experimental results. [ABSTRACT FROM AUTHOR]

This paper presents an SEU-tolerant Dual Interlocked Storage Cell (DICE) latch design with both PMOS and NMOS transistors in the feedback paths. The feedback transistors improve the SEU tolerance by increasing the feedback loop delay during the hold mode. The latch design was implemented in a shift register fashion at a 130-nm bulk CMOS process node. Exposures to heavy-ions exhibited a significantly higher upset LET threshold and lower cross-section compared with the traditional DICE latch design. Performance penalties in terms of write delay, power, and area are non-significant compared to traditional DICE design. [ABSTRACT FROM PUBLISHER]

This paper presents a new SEU-tolerant latch design based on Quatro and NMOS feedback transistors. By using these feedback transistors, the SEU susceptibility is decreased because of the cutoff feedback loop. Simulation results demonstrate that the proposed design is immune to static single node upsets. The proposed latch and the reference Quatro were designed and fabricated on a 130 nm process. The test chip was exposed to heavy ions at the TAMU Cyclotron facility. The testing results show that the proposed design has a higher upset LET threshold and lower cross-section when compared to the reference latch. Its lower SEU vulnerability comes with small area penalty. [ABSTRACT FROM PUBLISHER]