Search

This study systematically assesses the efficacy of the vehicle scanning methods (VSM) in accurately estimating the mode shapes of bridges seated on elastic supports. Three state-of-the-art VSM methods are employed to obtain the mode shapes of bridges using the vehicle data during its travel. Two of the evaluated methods use a signal decomposition technique to extract the modal components of the bridge from the contact point of the response while the third one relies on the segmentation of the measured signals along the bridge deck and applying an operational modal analysis tool to each segmented signal to estimate the mode shapes. Numerical analyses are conducted on one single- and one two-span bridge, considering smooth and rough road profiles, different vehicle speeds, and presence of lead vehicle. The accuracy of the numerical models used in developing and assessing vehicle scanning models is tested, and the results of the study demonstrate the method using a half-car vehicle model and signal decomposition technique shows robustness against increasing vehicle speeds and road roughness while the method applying the segmentation of the measured signals provides relatively accurate mode shape estimates at the bridge edges at low speed, although the three methods have their limitations. It is also observed that simplified bridge and vehicle models can hide potential challenges that arise from the complexity of actual vehicle and bridge systems. Considering that a significant number of bridges worldwide are built on elastic supports, the practical success of vehicle scanning methods depends on their ability to handle elastic boundary conditions with reliability. Therefore, the article provides valuable insights into the capabilities and limitations of the current vehicle scanning methods, paving the way for further advancements and refinements in these techniques. [ABSTRACT FROM AUTHOR]

Damage detection algorithms employing the conventional acceleration measurements and the associated modal features may underperform due to the limited number of sensors used in the monitoring and the smoothing effect of spline functions used to increase the spatial resolution. The effectiveness of such algorithms could be increased if a more accurate estimate of mode shapes were provided. This study presents a hybrid structural health monitoring method for vibration-based damage detection of bridge-type structures. The proposed method is based on the fusion of data from conventional accelerometers and computer vision-based measurements. The most commonly used mode shape-based damage measures, namely, the mode shape curvature method, the modal strain energy method, and the modal flexibility method, are used for damage detection. The accuracy of these parameters used together with the conventional sparse sensor setups and the proposed hybrid approach is investigated in numerical case studies, with damage scenarios simulated on a simply-supported bridge. The simulations involve measuring the acceleration response of the bridge to ambient vibrations and train crossings and then processing the data to determine the modal frequencies and mode shapes. The efficiency and accuracy of the proposed hybrid health monitoring methodology are demonstrated in case studies involving scenarios in which conventional acceleration measurements fail to detect and locate damage. The robustness of the proposed method against various levels of noise is shown as well. In the studies considered, damage as small as 10% decrease in flexural stiffness of the bridge and localized in less than 1% of the span-length of the bridge is reliably detected even with very high levels of measurement noise. Finally, a modified modal flexibility damage parameter is derived and used to alleviate the shortcomings of the modal flexibility damage parameter. [ABSTRACT FROM AUTHOR]