Search

Plastic food contact materials (FCM)-based products were widely used in everyday life. These products were normally imposed to strict regulations in order to pass the enforcement tests of compliance as a prefix condition. However, even in these “qualified” materials, unknown chemical substances, not involving in legislation lists, could migrate from FCM. In this perspective, the present work aims to thoroughly analyze by means of Gas Chromatography-Mass Spectrometry (GC-MS) the different substances/migrants in 120 qualified FCM plastic products. Unexpectedly, among the identified compounds (nearly 100), only 13% was included in the permitted list of Commission Regulation EU No 10/2011. All the identified compounds were classified into 11 categories according to their chemical structure and the FCM type, whereas toxicology data were in addition analyzed. Each plastic type exhibited different preferences of chemical migrants. Fortunately, most of the compounds identified were of low toxicity, and only 4 chemicals were included in priority lists and previous literature reports as potential risk factors. Subsequently, the accurate amount of these 4 chemicals was determined. The amount of Bis(2-ethylhexyl) adipate (DEHA) and Bis(2-ethylhexyl) phthalate (DEHP) were lower than the SML in Commission Regulation EU No 10/2011, and that of stearamide was under the recommended use quantity. The 2,4-di-tert-butylphenol (2,4-DTBP) was widely exist in the investigated FCM products. Among them, the highest level is obtained in polypropylene/low density polyethylene (BOPP/LDPE) materials, up to 45.568±31.513 mg/kg. In summary, a panel of unlisted chemical migrants were discovered and identified by GS-MS screening. The results implied that plastic FCMs were not so “inert” as they usually considered, and further safety evaluation should be performed toward the complete identification of new substances in FCM products. [ABSTRACT FROM AUTHOR]

Reverse genetics systems have been established for all major groups of plant DNA and positive-strand RNA viruses, and our understanding of their infection cycles and pathogenesis has benefitted enormously from use of these approaches. However, technical difficulties have heretofore hampered applications of reverse genetics to plant negative-strand RNA (NSR) viruses. Here, we report recovery of infectious virus from cloned cDNAs of a model plant NSR, Sonchus yellow net rhabdovirus (SYNV). The procedure involves Agrobacterium-mediated transcription of full-length SYNV antigenomic RNA and co-expression of the nucleoprotein (N), phosphoprotein (P), large polymerase core proteins and viral suppressors of RNA silencing in Nicotiana benthamiana plants. Optimization of core protein expression resulted in up to 26% recombinant SYNV (rSYNV) infections of agroinfiltrated plants. A reporter virus, rSYNV-GFP, engineered by inserting a green fluorescence protein (GFP) gene between the N and P genes was able to express GFP during systemic infections and after repeated plant-to-plant mechanical passages. Deletion analyses with rSYNV-GFP demonstrated that SYNV cell-to-cell movement requires the sc4 protein and suggested that uncoiled nucleocapsids are infectious movement entities. Deletion analyses also showed that the glycoprotein is not required for systemic infection, although the glycoprotein mutant was defective in virion morphogenesis. Taken together, we have developed a robust reverse genetics system for SYNV that provides key insights into morphogenesis and movement of an enveloped plant virus. Our study also provides a template for developing analogous systems for reverse genetic analysis of other plant NSR viruses. [ABSTRACT FROM AUTHOR]