Search

Calcium sulfoaluminate (CSA) cement is a sulfate-based binder whose high-performance hydraulic behavior depends on the rapid formation of ettringite, when grinded clinker is hydrated in presence of gypsum. Ettringite is a calcium aluminum sulfate mineral characterized by high water content, estimated as 32 water molecules per formula unit. Three examples of utilization of near-infrared (NIR) spectroscopy are here shown. First of all, information on water distribution in pure ettringite was deduced and compared with infrared analyses. Then its thermal behavior has been followed up to 400 °C, allowing to improve the knowledge about water loss and thermal decomposition of this hydrated phase. Finally, the obtained results have been employed in order to follow hydration of CSA cement sample, demonstrating thus that NIR spectroscopy, being highly sensitive to water amount and distribution, can be an extremely useful tool for hydration studies. [ABSTRACT FROM AUTHOR]

Calcium sulphoaluminate (CSA) cement is considered the third series cement besides ordinary Portland cement (OPC) and calcium aluminate (CA) cement. It is produced from gypsum, bauxite and limestone at 1,300 °C and consists of yeelimite, belite and anhydrite as main mineral phases. In the last years, many attempts have been made in applying Raman spectroscopy for the characterization of cement, clinker minerals and supplementary cementing materials (SCMs), revealing that this technique is a valuable tool for the identification of different phases in cements. In this work micro-Raman spectroscopy has been used, together with X-ray diffraction, for the characterization of CSA cement and its main minerals. In order to identify which mineral phase is responsible for the different bands, Raman spectra have been acquired from synthesized yeelimite and belite phases (whose purity degree was checked by X-ray diffraction) and from calcium sulphate di-hydrate and anhydrous (gypsum and anhydrite, respectively). On these bases, Raman spectra collected on CSA clinker and cement have been successfully assigned. Moreover, Raman spectroscopy, together with X-ray diffraction, proved useful to follow the hydration process of CSA cement up to 28 days. [ABSTRACT FROM AUTHOR]

The acceleration of very early age cement hydration by C-S-H seeding is getting attention from scholars and field applications because the enhanced early age features do not compromise later age performances. This acceleration could be beneficial for several low-CO2 cements as a general drawback is usually the low very early age mechanical strengths. However, the mechanistic understanding of this acceleration in commercial cements is not complete. Reported here is a contribution to this understanding from the study of the effects of C-S-H gel seeding in one Portland cement and two belite cements at two widely studied water–cement ratios, 0.50 and 0.40. Two commercially available C-S-H nano-seed-based admixtures, i.e., Master X-Seed 130 and Master X-Seed STE-53, were investigated. A multi-technique approach was adopted by employing calorimetry, thermal analysis, powder diffraction (data analysed by the Rietveld method), mercury intrusion porosimetry, and mechanical strength determination. For instance, the compressive strength at 1 day for the PC (w/c = 0.50) sample increased from 15 MPa for the unseeded mortar to 24 and 22 MPs for the mortars seeded with the XS130 and STE53, respectively. The evolution of the amorphous contents was determined by adding an internal standard before recording the powder patterns. In summary, alite and belite phase hydrations, from the crystalline phase content evolutions, are not significantly accelerated by C-S-H seedings at the studied ages of 1 and 28 d for these cements. Conversely, the hydration rates of tetracalcium alumino-ferrate and tricalcium aluminate were significantly enhanced. It is noted that the degrees of reaction of C4AF for the PC paste (w/c = 0.40) were 10, 30, and 40% at 1, 7, and 28 days. After C-S-H seeding, the values increased to 20, 45, and 60%, respectively. This resulted in larger ettringite contents at very early ages but not at 28 days. At 28 days of hydration, larger amounts of carbonate-containing AFm-type phases were determined. Finally, and importantly, the admixtures yielded larger amounts of amorphous components in the pastes at later hydration ages. This is justified, in part, by the higher content of amorphous iron siliceous hydrogarnet from the enhanced C4AF reactivity. [ABSTRACT FROM AUTHOR]

The study presents an investigation on the durability performance of concretes produced with an industrial scale high belite cement. This binder, thanks to the high amount of C-S-H gel and the lower C3S/C2S ratio, is characterized by high durability properties. Good resistance to freeze/thaw cycles, very low chloride migration and excellent resistance to sulfate attack were demonstrated. The accelerated carbonation test revealed that the belite cement, due to the high C2S phase amount, is able to increase its strength over time when exposed to high CO2 concentration. Durability and strength results were compared with those of CEM I, CEM II, and CEM III. In addition, a comparison of the performance of a self-compacting concrete produced with high belite cement and CEM I (as reference) is also presented. The results show that the self-compacting concrete with the high belite cement is able to reach sufficient strengths already after 1 day of hydration, with a low heat development and improved durability properties, compared to CEM I. [ABSTRACT FROM AUTHOR]

Abstract: The feasibility of electrokinetic remediation of copper-contaminated soil was evaluated following eight days of electroreclamation. The results indicate that electrokinetic reclamation of Cu is totally ineffective in soil composed primarily of clay minerals and organic matter. The strong absorption of copper by this kind of soil, in our view mainly a result of retention by the clay component, makes it resistant to mobilization by the electrogenerated acidic front as well as by citrates (the competitors of natural chelating agents, i.e., humates). Such conditions, while adverse for the electroremediation process, may cause this kind of soil to act as a natural barrier to the leaching of copper ions. [Copyright &y& Elsevier]

The aim was to determine the absence of gluten in pet food samples marked as 'grain-free' and 'gluten-free' diets, to assess the reliability of manufacturer labelling of such products. A total of 15 diets labelled as grain- or gluten-free and 2 commercial diets containing wheat were sampled. An analytical procedure using high-pressure liquid chromatography coupled with mass spectrometry with high power of resolution was developed and applied to determine specific markers of wheat gluten. The results are expressed as mg of wheat flour type '00' present in 1 g of feed. The quantification limit (LOQ) obtained in the flour for ion m/z 894.5043, z = 2, is 4 mg of flour per gram. In 14 out of the 15 samples from a grain- or gluten-free diet the quantifier ion signal was < LOQ, while in 1 out of the 15 samples 10 mg of flour/g feed were measured. Adverse reaction to gluten in dogs have been documented in certain breeds Gluten is tricky to detect and measure in pet food Contamination of gluten in pet food samples marked as 'grain-free' and 'gluten-free' diets An analytical procedure was developed using HPLC coupled with HRMS [ABSTRACT FROM AUTHOR]

The purpose of this study was the development of various analytical mass spectrometry (MS) methods to investigate the chemical composition of e-liquids used in electronic cigarettes and characterize their quality. Low-quality nicotine (the main active compound), glycerol, propylene glycol (solvents), or flavors could greatly increase the toxicity. The search of alkaloid contaminants of nicotine was performed by liquid chromatography-tandem mass spectrometry (LCMS- MS) after a study of fragmentation pathways by high-resolution electrospray ionization (ESI)-MS. A fully validated method for quantitation of organic polar impurities such as cotinine, anabasine, myosmine, nornicotine, and N-nitroso-nornicotine and nicotine itself was developed using MS coupled to ultrahigh-pressure liquid chromatography (UHPLC). To evaluate organic volatile toxicants, the headspace from e-cigarette refill liquids was sampled by the purge-andtrap method to perform gas chromatography (GC)-MS analysis. Finally, heavy metal residues as inorganic toxicants were determined by inductively coupled plasma (ICP)-MS after simple dilution. A number of cases of contamination by metals (mainly arsenic) were detected. [ABSTRACT FROM AUTHOR]

Abstract: Objective: In order to reduce remote cardiac events associated with graft occlusions, arterial conduits are being increasingly utilized in coronary artery bypass grafting (CABG). While the internal thoracic artery (ITA) is the graft of choice for CABG, it is sometimes difficult or impossible to obtain a complete arterial revascularization only with ITAs in three-vessel diseases. We present our experience with total arterial myocardial revascularization with bilateral internal thoracic artery (BITA) and right gastroepiploic artery (rGEA). Methods: From April 1994 to January 2004, 174 patients (165 male, mean age 55.9±7.4) underwent coronary artery bypass procedure with exclusive use of BITA and rGEA. Left ventricular ejection fraction ranged from 20 to 68% (mean 55.9±6.8%). Seven patients (4%) had poor ejection fraction (<0.30), 23 (13, 2%) had acute myocardial infarction, 14 (8%) had left main disease. The mean CPB time was 96.9±15.7min and the mean cross clamping time was 70±14.2min. The mean number of distal anastomoses was 3.3±0.5 per patient. Results: Early mortality was 1.7%. The patients were followed for up to 9 years (mean follow-up time 6.3±2.6 years). Actuarial freedom from cardiac death (including hospital death) was 97.6%, at 9 years after the operation. Actuarial freedom from angina and cardiac events at 9 years was 79, 5% and 77, 6%, respectively. No perioperative myocardial infarction occurred. None of the patients needed a redo-CABG after leaving the hospital. Conclusions: This study indicates that the myocardial revascularization in young patients with three-vessel disease using exclusively pedicle BITA and rGEA provides excellent 9-year patient survival and improvement in terms of freedom from return of angina pectoris and freedom from any cardiac-related event. These results encourage the more extensive use of BITA and rGEA in selected patients with three-vessel coronary disease. [Copyright &y& Elsevier]

There is a growing body of evidence to suggest that cannabinoids are beneficial for a range of clinical conditions, including pain, inflammation, epilepsy, sleep disorders, the symptoms of multiple sclerosis, anorexia, schizophrenia and other conditions. The transformation of cannabinoids from herbal preparations into highly regulated prescription drugs is therefore progressing rapidly. The development of such drugs requires well-controlled clinical trials to be carried out in order to objectively establish therapeutic efficacy, dose ranges and safety. The low oral bioavailability of cannabinoids has led to feasible methods of administration, such as the transdermal route, intranasal administration and transmucosal adsorption, being proposed. The highly lipophilic nature of cannabinoids means that they are seen as suitable candidates for advanced nanosized drug delivery systems, which can be applied via a range of routes. Nanotechnology-based drug delivery strategies have flourished in several therapeutic fields in recent years and numerous drugs have reached the market. This review explores the most recent developments, from preclinical to advanced clinical trials, in the cannabinoid delivery field, and focuses particularly on pain and inflammation treatment. Likely future directions are also considered and reported. [ABSTRACT FROM AUTHOR]