Search

Abstract: Phase cancellation in ultrasound due to large receiver size has been proposed as a contributing factor to the inaccuracy of estimating broadband ultrasound attenuation (BUA), which is used to characterize bone quality. Transducers with aperture size ranging from 2 to 5 mm have been used in previous attempts to study the effect of phase cancellation. However, these receivers themselves are susceptible to phase cancellation because aperture size is close to one center wavelength (about 3 mm at 500 KHz in water). This study uses an ultra small receiver (aperture size: 0.2 mm) in conjunction with a newly developed two-dimensional (2-D) synthetic array system to investigate the effects of phase cancellation and receiver aperture size on BUA estimations of bone tissue. In vitro ultrasound measurements were conducted on 54 trabecular bone samples (harvested from sheep femurs) in a confocal configuration with a focused transmitter and synthesized focused receivers of different aperture sizes. Phase sensitive (PS) and phase insensitive (PI) detections were performed. The results show that phase cancellation does have a significant effect on BUA. The normalized BUA (nBUA) with PS is 8.1% higher than PI nBUA while PI BUA is well correlated with PS BUA. Receiver aperture size also influences the BUA reading for both PI and PS detection and smaller receiver aperture tends to result in higher BUA readings. The results also indicate that the receiver aperture size used in the confocal configuration with PI detection should at least equal the aperture of the transmitter to capture most of the energy redistributed by the interference and diffraction from the trabecular bone. [Copyright &y& Elsevier]

Ultrasound has been widely used to nondestructively evaluate various materials, including biological tissues. Quantitative ultrasound has been used to assess bone quality and fracture risk. A pulsed phase-locked loop (PPLL) method has been proven for very sensitive tracking of ultrasound time-of-flight (TOF) changes. The objective of this work was to determine if the PPLL TOF tracking is sensitive to bone deformation changes during loading. The ability to noninvasively detect bone deformations has many implications, including assessment of bone strength and more accurate osteoporosis diagnostics and fracture risk prediction using a measure of bone mechanical quality. Fresh sheep femur cortical bone shell samples were instrumented with three 3-element rosette strain gauges and then tested under mechanical compression with eight loading levels using an MTS machine. Samples were divided into two groups based on internal marrow cavity content: with original marrow, or replaced with water. During compressive loading ultrasound waves were measured through acoustic transmission across the mid-diaphysis of bone. Finite element analysis (FEA) was used to describe ultrasound propagation path length changes under loading based on µCT-determined bone geometry. The results indicated that PPLL output correlates well to measured axial strain, with R(2) values of 0.70 ± 0.27 and 0.62 ± 0.29 for the marrow and water groups, respectively. The PPLL output correlates better with the ultrasound path length changes extracted from FEA. For the two validated FEA tests, correlation was improved to R(2) = 0.993 and R(2) = 0.879 through cortical path, from 0.815 and 0.794 via marrow path, respectively. This study shows that PPLL readings are sensitive to displacement changes during external bone loading, which may have potential to noninvasively assess bone strain and tissue mechanical properties.

The increasing popularity of rock climbing and its associated injury of closed traumatic pulley A2 rupture has sparked investigator interest in pulley biomechanics. Biomechanically, the A2 and A4 pulleys are important for preventing bowstringing of the flexor tendon upon digital flexion. The literature is replete with reparative techniques for A2 pulley rupture. These techniques include direct fibrous tissue repair, as well as the use of palmaris longus autograft for single- and double-loop reconstruction. Through a previously undescribed minimally invasive double-anchor technique, we used palmaris longus tendon and 2-mm bioabsorbable suture anchors to reconstruct the A2 pulley at its anatomical location in a cadaver model. Then the ultimate load to failure of this reconstruction was tested against 2 known reconstructive techniques, namely, single-loop and double-loop palmaris repair. There was no significant difference between the strength of the previously described single-loop technique and our novel double-anchor technique. Furthermore, our minimally invasive repair obviated the need for the circumferential dissection and soft tissue trauma associated with the single- and double-loop repairs.

We performed 100 percutaneous releases of the trigger digits in a cadaveric model using an 18-gauge needle. Successful percutaneous release was achieved for only 59 digits (59%). No neurovascular injury occurred. We found that a percutaneous trigger digit release resulted in high percentage of incomplete releases of A1 pulley, especially in the thumb, index, and little fingers.