Search

This article presents a novel approach to the analysis of heat release in a hydrogen-fueled internal combustion spark-ignition engine with exhaust gas recirculation (EGR). It also discusses aspects of thermodynamic analysis common to modeling and empirical analysis. This new approach concerns a novel method of calculating the specific heat ratio (cp/cv) and takes into account the reduction in the number of moles during combustion, which is characteristic of hydrogen combustion. This reduction in the number of moles was designated as a molar contraction. This is particularly crucial when calculating the average temperature during combustion. Subsequently, the outcomes of experimental tests, including the heat-release rate, the initial combustion phase (denoted CA0-10) and the main combustion phase (CA10-90), are presented. Furthermore, the impact of exhaust gas recirculation on the combustion process in the engine is also discussed. The efficacy of the proposed measures was validated by analyzing the heat-release rate and calculating the mean combustion temperature in the engine. The application of EGR in the range 0-40% resulted in a notable prolongation of both the initial and main combustion phases, which consequently influenced the mean combustion temperature. [ABSTRACT FROM AUTHOR]

Hydrogen as potential engine fuel can appear either as a single gas or as a component in processing gases e.g. syngas, hythane and coke gas. The research in this paper investigates impact of combustible mixture dilution on abnormal combustion called knock in the reciprocating internal combustion engine. Dilution can be realized by either exhaust gas recirculation (EGR) or making the combustible mixture lean. Novelty of this work is a new metrics defined as dilution ratio, which makes it possible to compare knock reduction caused by either EGR or leaning the air-gas mixture to the engine. Two gaseous fuels were investigated: hydrogen and coke gas with 65% hydrogen. Conclusion based on the proposed dilution ratio states that, for hydrogen as the fuel, applying EGR is more effective in knock reduction than making the mixture lean. It was found that EGR strategy in the hydrogen fueled engine can reduce knock intensity from initial 40 kPa–20 kPa, whereas by leaning the mixture to the same dilution ratio, the knock is reduced to approximately 28 kPa. With respect to coke gas, it is proved that both EGR and lean mixtures influence on knock reduction at the same strength. • Combustible mixture dilution impact on combustion knock intensity. • Dilution ratio as a metrics for both exhaust gas recirculation and lambda. • Engine knock reduced more effectively by applying exhaust gases recirculation. • The correlation between dilution ratio and knock intensity is almost linear. [ABSTRACT FROM AUTHOR]

The paper presents results from an investigation focused on toxicity content in the exhaust gases emitted by an internal combustion compression ignition engine fueled with glycerol-ethanol blends at ratio of 50/50% by volume. The innovative issue of this engine is the application of two high pressure injectors for injecting both glycerol-ethanol blend and diesel pilot fuel at high pressure (over 200 MPa). As known, glycerol is considered a byproduct from biodiesel production technologies, hence its cost is relatively low compared to other renewable alternative fuels which can be applied as fuels to the reciprocating piston engines. It was found that the toxic components UHC, NOx and CO were below the maximum allowed limits. Both NOx and smoke emissions were strongly reduced with increasing glycerol-ethanol fraction in the fuel. Summarizing, a fueling strategy such as that proposed in this paper makes it possible to effectively and environmentally friendly combust crude glycerol in compression ignition engines working in a heat and power cogeneration unit. Exhaust gas emission tests conducted in this case confirmed the usability of this technology to be implemented into practice. [ABSTRACT FROM AUTHOR]