Search

Plastic food contact materials (FCM)-based products were widely used in everyday life. These products were normally imposed to strict regulations in order to pass the enforcement tests of compliance as a prefix condition. However, even in these “qualified” materials, unknown chemical substances, not involving in legislation lists, could migrate from FCM. In this perspective, the present work aims to thoroughly analyze by means of Gas Chromatography-Mass Spectrometry (GC-MS) the different substances/migrants in 120 qualified FCM plastic products. Unexpectedly, among the identified compounds (nearly 100), only 13% was included in the permitted list of Commission Regulation EU No 10/2011. All the identified compounds were classified into 11 categories according to their chemical structure and the FCM type, whereas toxicology data were in addition analyzed. Each plastic type exhibited different preferences of chemical migrants. Fortunately, most of the compounds identified were of low toxicity, and only 4 chemicals were included in priority lists and previous literature reports as potential risk factors. Subsequently, the accurate amount of these 4 chemicals was determined. The amount of Bis(2-ethylhexyl) adipate (DEHA) and Bis(2-ethylhexyl) phthalate (DEHP) were lower than the SML in Commission Regulation EU No 10/2011, and that of stearamide was under the recommended use quantity. The 2,4-di-tert-butylphenol (2,4-DTBP) was widely exist in the investigated FCM products. Among them, the highest level is obtained in polypropylene/low density polyethylene (BOPP/LDPE) materials, up to 45.568±31.513 mg/kg. In summary, a panel of unlisted chemical migrants were discovered and identified by GS-MS screening. The results implied that plastic FCMs were not so “inert” as they usually considered, and further safety evaluation should be performed toward the complete identification of new substances in FCM products. [ABSTRACT FROM AUTHOR]

In China, incidences involving pupils suffering health problems caused by synthetic running tracks have attracted the public's attention. However, the existence of known and unknown harmful chemicals in the tracks have not yet been explored. Here, the levels of 16 known harmful ingredients were firstly analyzed in 167 school running tracks. In all samples, the recognized toxic solvents and additives, such as the benzene series, soluble mercury, 3,3′-dichloro-4,4′-diaminodiphenylmethane (MOCA) and toluene diisocyanate monomer (TDI) were under the limits of detection. In contrast, polycyclic aromatic hydrocarbons (PAHs), phthalates, Short chain chlorinated paraffins (SCCPs) soluble lead, cadmium and chromium were found in 86%, 88%, 46%, 81%, 43% and 83% of the specimens, respectively. The levels, toxicology and distribution of these known chemicals were evaluated. Then, a static-headspace gas chromatography-mass spectrometer (GC-MS) method in full scan mode was employed to screen for unknown volatile chemicals. Three groups of chemicals reflecting different kinds of pollution sources were discovered: new solvents, such as N, N-Dimethylformamide, new additives, such as 2-ethylhexanoic acid, and by-products, such as carbon disulfide. In summary, the existence of potential risk factors in school plastic tracks was revealed through exhaustive testing. Moreover, most of the hazardous components detected have been recently included in a new national standard to improve the safety performance of synthetic running tracks. [ABSTRACT FROM AUTHOR]