Search

The disposal of peat soil poses an increasingly difficult problem for actual engineering projects of Dianchi Lake area. This study obtains peat soil from seven areas around Dianchi Lake, and the content of humic acid (HA) in peat soil is between 2.36% and 28.13%. Then, this study simulates the peat soil by adding HA into the cohesive soil and uses cement to solidify it. The effect of cement and HA on the strength development of samples is examined by the unconfined compressive strength (UCS) test. Additionally, the microstructures of typical mixes are analyzed by scanning electron microscopy (SEM), X-ray diffraction (XRD), and mercury intrusion porosimetry (MIP). The results showed that HA will significantly reduce the UCS of cement soil. The SEM, XRD, and MIP confirmed that cement hydration reaction increases with cement ratio. In addition to the cementitious soil particles, hydration products gradually fill the pores of the soil and effectively reduce the number of large-size (6000∼40,000 nm) pores in cement soil, which makes the soil particle framework stronger. When the cement ratio increases from 15% to 25%, the diffraction peak of CAH and CSH increases faster. Combined with the results of the UCS test, it could be proved that cement ratio greater than 20% weakens the influence of HA on the strength development of cement soil sample. [ABSTRACT FROM AUTHOR]

To study the corrosion behavior of cement soil in peat soil, the experiment involves the preparation of peat soil by incorporating humic acid into cohesive soil with a lower organic matter content. Cement soil samples are then prepared by adding cement to the mixture. These samples are subjected to immersion in fulvic acid solution and deionized water to simulate different working environments of cement soil. The experiment considers immersion time as the variable factor. It conducts observations of apparent phenomena, ion leaching tests, and unconfined compression strength tests on the cement soil. The experiment results are as follows: (1) With increasing immersion time, the surface of the cement soil in the peat soil environment experiences the disappearance of Ca(OH)2 and calcium aluminate hydrate. Additionally, large amounts of bird dropping crystals precipitate on the surface and within the specimen. The cement soil undergoes localized disintegration due to extensive erosion caused by swelling forces. (2) In the peat soil environment, fulvic acid reacts with the hydration products of cement, resulting in partial leaching of ions such as Ca2+, Mg2+, Al3+, and Fe3+ into the immersion solution. The lower the pH of the fulvic acid immersion (indicating higher concentration), the more significant the ion leaching. Increasing the ratio of humic acid to cement can slow down the leaching of ions. The cement soil undergoes dissolutive erosion in the peat soil environment. (3) The peat soil environment exerts both strengthening and corrosive effects on the cement soil. Cement soil without humic acid exhibits noticeable corrosion in the peat soil environment, gradually decreasing strength as immersion time increases. The strength decreases by 83% from 28 to 365 days. In contrast, cement soil with humic acid experiences an initial period of strengthening, leading to a significant increase in strength in the short term (34% increase from 28 to 90 days). However, the corrosive effects gradually dominate, resulting in a decrease in strength over time. The strength decreases by 80% from 90 to 365 days. This study also explores the strengthening effects of peat soil on cement soil. It identifies phenomena such as extensive erosion and new substance precipitation in cement soil. [ABSTRACT FROM AUTHOR]

Many peat soils are distributed around plateau lakes, and the reinforcement of peat soils with high organic matter content by ordinary cement cannot meet the actual engineering requirements. In order to obtain better mechanical properties and durability of the reinforcement, this experiment prepared peat soil by mixing humic acid reagent into the alluvial clay soil with low organic matter content. The cement soil samples were prepared by adding cement and ultrafine cement (UFC) by stirring method; the samples were then soaked in fulvic acid solution to simulate the cement soil in the peat soil environment. Using the unconfined compressive strength (UCS) test, scanning electron microscope (SEM) test, and pores and cracks analysis system (PCAS) test, the effect of UFC content change on cement soil's humic acid erosion resistance was explored, and the optimal UFC content range was sought. The results of the UCS test show that with an increase in immersion time, the strength curves of cement soil samples gradually increase to the peak strength and then decrease. Significant differences in the time correspond to the peak strength, and the overall presentation is two processes: the strength enhancement stage and the corrosion stage of the sample. The incorporation of UFC makes the cement soil in the peat soil environment exhibit excellent corrosion resistance, and the optimal UFC content is 10%. The results of the SEM and PCAS tests show that the microstructure of cement soil after immersion time exceeds 90 days, increases with an increase in immersion time, and its structural connectivity gradually weakens. The excellent characteristics of UFC particles, such as small particle size, narrow particle size distribution, fast hydration reaction rate, high hydration degree, and many hydration products, weakened the adverse effects of humic acid on the cement soil structure to a certain extent. Therefore, although the number of macropores increases, they are not connected. It still presents a relatively compact honeycomb overall structure, which correlates well with the UCS results. [ABSTRACT FROM AUTHOR]