Search

Lidar observations of metal layers play a significant role in research on the chemistry and dynamics of the mesosphere and lower thermosphere. This work reports on Fe lidar observations conducted in Beijing and Mohe. Utilizing the same laser emission system, a 1064 nm seed laser was injected into an Nd: YAG laser to generate a single longitudinal-mode pulse 532 nm laser, which pumped a dye laser to produce a 572 nm laser. The 572 nm laser and the remaining 1064 nm fundamental frequency laser passed through a sum–frequency module to generate a 372 nm laser to detect the Fe layer. According to a total of 52.6 h of observations for 10 nights in Beijing, the Fe layer has an average column density of 1.24 × 1010 cm−2, an RMS width of 4.4 km and a centroid altitude of 89.4 km. In Mohe, observed for 16 nights and a total of 91.5 h, the Fe layer has an average column density of 1.08 × 1010 cm−2, an RMS width of 4.6 km and a centroid altitude of 89.5 km. The probability of the occurrence of sporadic Fe layers was 42.4% in Beijing and 29.4% in Mohe. Compared to simultaneously observed Na layers, the occurrence probabilities of sporadic Fe layers were higher than those of sporadic Na layers in both stations. Based on the two cases observed in Beijing, it is conjectured that the formation mechanism of sporadic metal layers above approximately 100 km has a more significant influence on sporadic Fe layers than on sporadic Na layers. The lower thermospheric Fe layers with densities significantly larger than those of the main layer were observed during two nights in Mohe. This work contributes to the refinement of the global distribution of Fe layers and provides abundant observational data for the modeling and study of the metal layers. [ABSTRACT FROM AUTHOR]

Based on the resonance fluorescence scattering mechanism, a narrowband sodium (Na) lidar can measure temperature and wind in the mesosphere and lower thermosphere (MLT) region. By using a narrowband spectral filter, background light noise during the day can be suppressed, allowing for continuous observations. To obtain full-diurnal-cycle temperature and wind measurement results, a complex and precise retrieval process is required, along with necessary corrections to minimize measurement errors. This paper introduces the design of a data acquisition unit for three frequencies in three directions of the Na lidar system in the Chinese Meridian Project (Phase II) and investigates the calibration and retrieval methods for obtaining diurnal temperature and horizontal wind in the MLT region, using a Na Doppler lidar with Faraday anomalous dispersion optical filter (FADOF). Furthermore, these methods are applied to observations conducted by a Na lidar in Beijing, China. The wind and temperature results over full diurnal cycles obtained from the all-solid-state Na Doppler lidar are reported for the first time and compared with temperature measurements from satellite, as well as wind observations from a meteor radar. The comparison demonstrates a reasonable agreement between the results, indicating the rationality of the lidar-retrieved results and the feasibility and effectiveness of the data correction and retrieval method. [ABSTRACT FROM AUTHOR]