Search

Results of experimental research and two-dimensional hydrodynamical simulations of close to critically damped microsecond timescale underwater electrical explosions of butterfly-shaped foils for six different materials are presented. Using current and voltage waveforms along with multi-frame shadow images of the shocks generated in water, the values of the specific action integral, h, were determined. It is shown that values of h can be calculated based on the average current density and that its value (within error bars) does not change in the range of current densities (0.5–1) × 108 A/cm2. The values of h were found to be consistent with those obtained for sub-microsecond underwater electrical explosions of wires made of the same material but differ from those obtained in earlier research with explosion of wires in vacuum. [ABSTRACT FROM AUTHOR]

We present results on underwater electrical explosions of thin aluminum and copper foils using a generator delivering ∼200 kA current amplitude, ∼0.9 μs rise time pulses. Time-resolved shadow imaging displays the generation of a strong planar shock wave in water in the vicinity of the exploding foil. Using time-resolved spectroscopy, aluminum oxide (AlO) absorption bands were observed in a Planckian-like spectrum, indicating that aluminum combustion starts when aluminum vaporizes. It is also shown that the strongest shock wave is obtained for the largest linear energy deposition rate to the foil. [ABSTRACT FROM AUTHOR]

Results of an experimental research and one-dimensional hydrodynamical simulations of critically damped sub-microsecond timescale underwater electrical explosions of wires made of 12 different materials are presented. Using current and voltage waveforms, streak shadow images of the shocks generated in water and wire expansion obtained by one-dimensional hydrodynamic simulations, the maximal values of the energy density, energy density deposition rates, and specific action integrals were determined. It is shown that for all study materials, the deposited energy density significantly exceeds the energy density required for the solid–liquid phase transition but is substantially smaller to induce a full liquid–vapor phase transition of the wire. At the time when the maximal value of the deposited power is realized, the deposited energy densities were found to be larger than the atomization energy for all materials. Estimates of the plasma parameters show that the explosion of the wires can be characterized by a high resistance and lowly ionized weakly coupled plasma. Three groups of materials were distinguished by either decrease, plateau, or increase in the resistance after the maximum of the deposited power. It was confirmed that the observed maximum Planckian temperature for all wire material does not exceed 6000 K due to the "bath" effect and that there is a correlation between the wire radial expansion and the strong shock wave velocities. [ABSTRACT FROM AUTHOR]

Two interacting supersonic water jets and collisions of a water jet with an aluminum target are studied experimentally and by hydrodynamic simulations. Supersonic water jets form, when shocks generated by underwater electrical explosions of conical wire arrays converge. The arrays are supplied by a ∼250 kA, ∼1 μs rise time current pulse. Underwater explosion of two conical arrays placed face to face produces jets propagating in air with velocities of ∼ 2.5 × 10 3 m/s leading to hot plasma formation at a temperature of ∼2200–3000 K, pressure ∼ 1.7 × 10 10 Pa, and density > 10 29 m−3. When a single array explodes underwater in front of an aluminum target, the collision of the jet with the target produces a local pressure of ∼ 3 × 10 10 Pa on the surface of the target. [ABSTRACT FROM AUTHOR]