Search

Time-resolved scanning Kerr microscopy has been used to perform optically detected, phase-resolved spin–orbit torque ferromagnetic resonance (SOT-FMR) measurements on a microscale CoFeB ellipse at the center of a Pt Hall cross subject to RF and DC current. Time-resolved polar Kerr images revealed localized dynamics with large amplitude at the center and weaker amplitude at the edges. Therefore, field swept SOT-FMR spectra were acquired from the so-called center mode to probe the SOTs active at the center of the ellipse, thus minimizing non-uniform edge contributions. When the magnetic field was applied at 30° from the hard axis of the ellipse and a DC current was applied, a marked asymmetry was observed in the amplitude and linewidth of the FMR peaks as the applied field was reversed. Both absorptive and dispersive parts of the spectra were in good agreement with a macrospin calculation. The damping parameter (α) and the Slonczewski torque parameter were determined to be 0.025 and (6.75 ± 0.75) × 10−7 Oe A−1 cm2, respectively. The hard axis SOT-FMR linewidth was found to be almost independent of the DC current value, suggesting that the SOT has a minimal influence in the hard axis configuration and that thermal effects were insignificant. This study paves the way for spatially resolved measurements of SOT probed using localized modes of microscale devices that go beyond the spatially averaged capability of electrical measurement techniques. [ABSTRACT FROM AUTHOR]

Time-resolved scanning Kerr microscopy (TRSKM) has been used to image precessional magnetization dynamics excited by a DC current within a nano-contact (NC) spin Hall nano-oscillator (SHNO). Injection of a radio frequency (RF) current was used to phase lock the SHNO to TRSKM. The out of plane magnetization was detected by means of the polar magneto optical Kerr effect (MOKE). However, longitudinal MOKE images were dominated by an artifact arising from the edges of the Au NCs. Time resolved imaging revealed the simultaneous excitation of a non-linear "bullet" mode at the centre of the device, once the DC current exceeded a threshold value, and ferromagnetic resonance (FMR) induced by the RF current. However, the FMR response observed for sub-critical DC current values exhibits an amplitude minimum at the centre, which is attributed to spreading of the RF spin current due to the reactance of the device structure. This FMR response can be subtracted to yield images of the bullet mode. As the DC current is increased above threshold, the bullet mode appears to increase in size, suggesting increased translational motion. The reduced spatial overlap of the bullet and FMR modes, and this putative translational motion, may impede the injection locking and contribute to the reduced locking range observed within NC-SHNO devices. This illustrates a more general need to control the geometry of an injection-locked oscillator so that the autonomous dynamics of the oscillator exhibit strong spatial overlap with those resulting from the injected signal. [ABSTRACT FROM AUTHOR]

The design and fabrication of a novel plasmonic cavity, intended to allow far-field recovery of signals arising from near field magneto-optical interactions, is presented. Finite element modeling is used to describe the interaction between a gold film, containing cross-shaped cavities, with a nearby magnetic under-layer. The modeling revealed strong electric field confinement near the center of the cross structure for certain optical wavelengths, which may be tuned by varying the length of the cross through a range that is compatible with available fabrication techniques. Furthermore, the magneto optical Kerr effect (MOKE) response of the composite structure can be enhanced with respect to that of the bare magnetic film. To confirm these findings, cavities were milled within gold films deposited upon a soluble film, allowing relocation to a ferromagnetic film using a float transfer technique. Cross cavity arrays were fabricated and characterized by optical transmission spectroscopy prior to floating, revealing resonances at optical wavelengths in good agreement with the finite element modeling. Following transfer to the magnetic film, circular test apertures within the gold film yielded clear magneto-optical signals even for diameters within the sub-wavelength regime. However, no magneto-optical signal was observed for the cross cavity arrays, since the FIB milling process was found to produce nanotube structures within the soluble under-layer that adhered to the gold. Further optimization of the fabrication process should allow recovery of magneto-optical signal from cross cavity structures. [ABSTRACT FROM AUTHOR]

Four different designs of partially built hard disk write heads with a yoke comprising four repeats of NiFe (1 nm)/CoFe (50 nm) were studied by both x-ray photoemission electron microscopy (XPEEM) and time-resolved scanning Kerr microscopy (TRSKM). These techniques were used to investigate the static equilibrium domain configuration and the magnetodynamic response across the entire structure, respectively. Simulations and previous TRSKM studies have made proposals for the equilibrium domain configuration of similar structures, but no direct observation of the equilibrium state of the writers has yet been made. In this study, static XPEEM images of the equilibrium state of writer structures were acquired using x-ray magnetic circular dichroism as the contrast mechanism. These images suggest that the crystalline anisotropy dominates the equilibrium state domain configuration, but competition with shape anisotropy ultimately determines the stability of the equilibrium state. Dynamic TRSKM images were acquired from nominally identical devices. These images suggest that a longer confluence region may hinder flux conduction from the yoke into the pole tip: the shorter confluence region exhibits clear flux beaming along the symmetry axis, whereas the longer confluence region causes flux to conduct along one edge of the writer. The observed variations in dynamic response agree well with the differences in the equilibrium magnetization configuration visible in the XPEEM images, confirming that minor variations in the geometric design of the writer structure can have significant effects on the process of flux beaming. [ABSTRACT FROM AUTHOR]

Vortex dynamics within arrays of square ferromagnetic nanoelements have been studied by time-resolved scanning Kerr microscopy (TRSKM), while x-ray photoemission electron microscopy has been used to investigate the equilibrium magnetic state of the arrays. An alternating field demagnetization process was found to initialize a distribution of equilibrium states within the individual elements of the array, including quasiuniform states and vortex states of different chirality and core polarization. Repeated initialization revealed some evidence of stochastic behavior during the formation of the equilibrium state. TRSKM with a spatial resolution of ~300 nm was used to detect vortex gyration within arrays of square nanoelements of 250-nm lateral size. Two arrays were studied consisting of a 9 × 9 and 5 × 5 arrangement of nanoelements with 50- and 500-nm element edge-to-edge separation to encourage strong and negligible dipolar interactions, respectively. In the 5 × 5 element array, TRSKM images, acquired at a fixed phase of the driving microwave magnetic field, revealed differences in the gyrotropic phase within individual elements. While some phase variation is attributed to the dispersion in the size and shape of elements, the vortex chirality and core polarization are also shown to influence the phase. In the 9 × 9 array, strong magneto-optical response due to vortex gyration was observed across regions with length equal to either one or two elements. Micromagnetic simulations performed for 2 × 2 arrays of elements suggest that particular combinations of vortex chirality and polarization in neighboring elements are required to generate the observed magneto-optical contrast. [ABSTRACT FROM AUTHOR]

Time-resolved scanning Kerr microscopy has been used to directly image the magnetization dynamics of nanocontact (NC) spin-torque vortex oscillators (STVOs) when phase locked to an injected microwave (rf) current. The Kerr images reveal free-layer magnetization dynamics that extend outside the NC footprint, where they cannot be detected electrically, but which are crucial to phase-lock STVOs that share common magnetic layers. For a single NC, dynamics were observed not only when the STVO frequency was fully locked to that of the rf current, but also for a partially locked state characterized by periodic changes in the core trajectory at the rf frequency. For a pair of NCs, we explore the correlation between the spatial character of injection-locked dynamics and the free-running spectra. Insight gained from these images may improve understanding of the conditions required for mutual phase locking of multiple STVOs, and hence enhanced microwave power emission. [ABSTRACT FROM AUTHOR]

We employ an extended finite-element model as a design tool capable of incorporating the interaction between plasmonic antennas and magneto-optical effects, specifically the magneto-optical Kerr effect (MOKE). We first test our model in the absence of an antenna and show that for a semi-infinite thin-film, good agreement is obtained between our finite-element model and analytical calculations. The addition of a plasmonic antenna is shown to yield a wavelength dependent enhancement of the MOKE. The antenna geometry and its separation from the magnetic material are found to impact the strength of the observed MOKE signal, as well as the antenna's resonance wavelength. Through optimization of these parameters we achieved a MOKE enhancement of more than 100 when compared to a magnetic film alone. These initial results show that our modeling methodology offers a tool to guide the future fabrication of hybrid plasmonic magneto-optical devices and plasmonic antennas for magneto-optical sensing.