Search

Knee function is rarely measured objectively during functional tasks following total knee arthroplasty. Inertial measurement units (IMU) can measure knee kinematics and range of motion (ROM) during dynamic activities and offer an easy-to-use system for knee function assessment post total knee arthroplasty. However, IMU must be validated against gold standard three-dimensional optical motion capture systems (OMC) across a range of tasks if they are to see widespread uptake. We computed knee rotations and ROM from commercial IMU sensor measurements during walking, squatting, sit-to-stand, stair ascent, and stair descent in 21 patients one-year post total knee arthroplasty using two methods: direct computation using segment orientations (r_IMU), and an IMU-driven iCloud-based interactive lower limb model (m_IMU). This cross-sectional study compared computed knee angles and ROM to a gold-standard OMC and inverse kinematics method using Pearson's correlation coefficient (R) and root-mean-square-differences (RMSD). The r_IMU and m_IMU methods estimated sagittal plane knee angles with excellent correlation (>0.95) compared to OMC for walking, squatting, sit-to-stand, and stair-ascent, and very good correlation (>0.90) for stair descent. For squatting, sit-to-stand, and walking, the mean RMSD for r_IMU and m_IMU compared to OMC were <4 degrees, < 5 degrees, and <6 degrees, respectively but higher for stair ascent and descent (~12 degrees). Frontal and transverse plane knee kinematics estimated using r_IMU and m_IMU showed poor to moderate correlation compared to OMC. There were no differences in ROM measurements during squatting, sit-to-stand, and walking across the two methods. Thus, IMUs can measure sagittal plane knee angles and ROM with high accuracy for a variety of tasks and may be a useful in-clinic tool for objective assessment of knee function following total knee arthroplasty. [ABSTRACT FROM AUTHOR]

Purpose: The aim of this study was to describe the native trochlear orientation of non-arthritic knees in three planes and to quantify the relationship between trochlear and distal condylar anatomy across race and sex. Methods: Computed tomography scans of 1578 femora were included in this study. The mediolateral position of the trochlear sulcus, the distal trochlear sulcus angle (DTSA) the medial sulcus angle (MSA) and the lateral sulcus angle (LSA) as well as the mechanical lateral distal femoral angle (mLDFA) were measured relative to a standard reference coordinate system. Multiple linear regression analyses were performed to account for potential confounding variables. Results: The mediolateral position of the trochlear sulcus had minimal mean deviation of the sagittal femoral plane. The mean DTSA was 86.1° (SD 2.2°). Multilinear regression analysis found mLDFA, sex, and age all influence DTSA (p < 0.05), with mLDFA having by far the greatest influence (r2 = 0.55). The medial facet of the trochlear sulcus was found to be flat proximally and more prominent distally. The lateral facet was relatively uniform throughout the arc. Conclusion: In non-arthritic knees, due to a strong positive correlation between the DTSA and the mLDFA, the trochlear sulcus is consistently orientated in the sagittal femoral plane regardless of distal condylar anatomy. Minor deviations from the sagittal plane occur in a lateral direction in the middle part and in a medial direction at the proximal and distal part of the trochlea. These findings have relevance regarding the biomimetic design of total knee implants. [ABSTRACT FROM AUTHOR]