Search

The deflection from classical Chemical Warfare Agents in military use has been currently noticed. That is why questions' solution concerning contamination after their use importantly decreases. On the other hand, a possibility of contamination development after both military and terroristic Toxic Industrial Chemicals usage is very high. Despite these very important facts, necessity of solutions of questions concerning study of suits' protective properties used for specialists' isolative protection increases. In this way, the gained results principally affect the evaluation of effectivity of accepted protective measurements in all kinds of military operations conducted by both Czech Armed Forces Chemical Corps specialists and specialists from Fire Rescue Brigades. The main aim of the article is to point to some properties of butyl-rubber polymer mixture coated on polyamide fabric considering selected liquid aliphatic saturated hydrocarbons in a homological line with the use of the PIEZOTEST method which uses a QCM detector. [ABSTRACT FROM AUTHOR]

The worldwide transmission of acute respiratory syndrome coronavirus 2 (SARS-CoV-2) as a deadly or devastating disease is known to affect thousands of people every day, many of them dying all over the planet. The main reason for the massive effect of COVID-19 on society is its unpredictable spread, which does not allow for proper planning or management of this disease. Antibiotics, antivirals, and other prescription drugs, necessary and used in therapy, obviously have side effects (minor or significant) on the affected person, there are still not clear enough studies to elucidate their combined effect in this specific treatment, and existing protocols are sometimes unclear and uncertain. In contrast, it has been found that nutraceuticals, supplements, and various herbs can be effective in reducing the chances of SARS-CoV-2 infection, but also in alleviating COVID-19 symptoms. However, not enough specific details are yet available, and precise scientific studies to validate the approved benefits of natural food additives, probiotics, herbs, and nutraceuticals will need to be standardized according to current regulations. These alternative treatments may not have a direct effect on the virus or reduce the risk of infection with it, but these products certainly stimulate the human immune system so that the body is better prepared to fight the disease. This paper aims at a specialized literary foray precisely in the field of these "cures" that can provide real revelations in the therapy of coronavirus infection.

The problems of determining the protective properties of barrier materials used for the production of body surface protection products of an isolative type are very actual. These garments are expected to have long-term resistance against permeation of toxic substances. The paper deals with the study of the effect of organic solvent vapours on the changes in protective properties of selected anti-gas protective garments commonly used by the North Atlantic Treaty Organization armed forces. Permeation measurements of selected gases with integral permeameter were performed to verify their barrier properties, surface changes after exposure to selected solvents by using a 3D optical profilometer, permeation measurements for vapours of these solvents with differential permeameter, and experimental simulating the possible influence of barrier properties of garments within permeation of air. It has been shown that in the case of gases, the permeability of the studied materials increases with decreasing kinetic diameter of the penetrant molecule used. In the case of acetonitrile and isooctane vapours, permeability increased with increasing vapour concentration due to interactions between polymeric materials and molecules of organic compounds. The permeation measurements of pure vapours and air/vapour mixtures indicate that the level of interactions between the molecules of the penetrant and the material of the protective garment is not strong enough to degrade the material of the garment in such a way as to allow a greater penetration of the pollutants through it. The results of permeation experiments for gases and organic vapours showed very good barrier properties of studied chemical isolated garments., Competing Interests: Declaration of competing interest The authors declare no conflict of interest., (Copyright © 2020 Elsevier B.V. All rights reserved.)

Barrier materials have wide applicability in both professional (military, medical, industrial) and non-professional (leisure and sports) fields. This paper focuses on the preparation of real conductive polymer (CP) sensors, for the study of the permeation of volatile toxic compounds through barrier materials. Use of such a CP sensor can help improve the quality of barrier materials used in protective clothing. Several types of platforms have been manufactured or purchased for use as comb sensors with different electrode dimensions, and a suitable method of applying the detection layer of conductive polymers (polyaniline and poly-pyrrole) has been developed. Prepared sensors were obtained using various technologies and were assessed not only for response to exposure to vapors of volatile toxic substances, but also for the possibility of their incorporation into a permeation cell, in order to expand the possibilities of using existing permeation devices. The resulting conductivity of the surface film ranges from 50 to 10,000 μS/cm. When exposed to ethanol vapors, the conductivity of the sensors dropped significantly and returned to the original value after exposure ended. The conductivity of the B12 CP sensor was in the range of 10-100 mS/cm and is considered the most valuable tested sensor. CPs deposited on this substrate have very high sensitivity in units of ppm (in special cases, even ppb) within the detection of analytes (in this case toxic vapors of ethanol, acetic acid) and the ability to return to initial (zero) conductivity., (Copyright © 2019 Elsevier B.V. All rights reserved.)

Self-medication during pregnancy continues to be an issue in developing countries due to poor medical education. The most commonly used drugs are analgesics, mainly acetaminophen (paracetamol, APAP) and, to a lesser extent, ketoprofen (KPF). The aim of the study was to establish whether there are consequences of accidental use of these two drugs during early embryogenesis. The experimental study was performed on 30 pregnant white mice, divided into three groups: a first group to which APAP was administered, a second group to which KPF was administered, and group 3 as a control group. At delivery, the baby mice were examined, and after their first parturition, they were taken into study and examined according to the established protocol. Macroscopic and microscopic examinations of the liver and kidney were performed; liver and renal changes were recorded. Regarding the fertility, the number of fetuses born to mothers that were administered APAP and KPF corresponded to the normal values recorded in this species. Microscopic changes that were found in the kidney were as follows: APAP group - necrosis of the urinary tube, vascular congestions and vascular disorders; KPF group - ectasia, especially in the medullary cavity. Microscopic hepatic changes showed in the APAP group - vascular congestions, vascular disorders and hemosiderin deposits in the Kupffer cells; in the KPF group were found - discrete vascular disorders consisting in sinusoidal capillary ectasia and vascular congestions, as well as the presence of lymphocyte conglomerates. The aforementioned lesions indicate hepatic and renal distress with variable degrees of severity, but they appear to be reversible (the longer the time from the maximum effect of the drug the lower its toxicity)., (Copyright © 2019 Elsevier B.V. All rights reserved.)

The SiO x barrier nanocoatings have been prepared on selected polymer matrices to increase their resistance against permeation of toxic substances. The aim has been to find out whether the method of vacuum plasma deposition of SiO x barrier nanocoatings on a polyethylene terephthalate (PET) foil used by Aluminium Company of Canada (ALCAN) company (ALCAN Packaging Kreuzlingen AG (SA/Ltd., Kreuzlingen, Switzerland) within the production of CERAMIS ® packaging materials with barrier properties can also be used to increase the resistance of foils from other polymers against the permeation of organic solvents and other toxic liquids. The scanning electron microscopy (SEM) microstructure of SiO x nanocoatings prepared by thermal deposition from SiO in vacuum by the Plasma Assisted Physical Vapour Deposition (PA-PVD) method or vacuum deposition of hexamethyldisiloxane (HMDSO) by the Plasma-enhanced chemical vapour deposition (PECVD) method have been studied. The microstructure and behavior of samples when exposed to a liquid test substance in relation to the barrier properties is described.

The article deals with the preparation and possibilities of using combined filtration sorption systems usable for the construction of folded filters or respirators. The studied materials are made of several structural layers-a filter membrane made of polymeric nanofibers, an adsorbent containing active carbon or porous silicon dioxide nanofibers, and a supporting or cover nonwoven bicomponent fabric. The layers are connected only by pressure at an elevated temperature without the use of binders, according to utility model PUV 31 375. The result is a compact fabric material of textile character with a high permeability, good mechanical resistance, which effectively catches the submicron particles and the gases of the organic substances. The prepared samples of the filter sorptive material have been evaluated not only from the point of view of morphology and microstructure, but also from the point of view of the capture of pollutants.