Search

The increased attraction of biological volatile compounds has opened the route to a wide variety of sampling techniques, amongst which trap tubes packed with adsorbent materials are commonly used. Many types of adsorbent materials are available and the choice of the adsorbent can impact the obtained results in untargeted analysis. Therefore, a proper combination of the adsorbent material and the sample is necessary to increase the robustness and reproducibility of biological studies. In this study, the sampling performance of thermal desorption tubes with six common adsorbent material combinations, i.e., Tenax® TA, Tenax® TA/Carbopack™ B, Tenax® TA/Sulficarb, Tenax® TA/Carbograph™ 5TD, Tenax® TA/Carbograph™ 1TD/Carboxen® 1003, and Carboxen® 1016/Carbograph™ 5TD, was evaluated in two different setups: in vitro and in vivo sampling. The in vitro setup consisted of the headspace dynamic extraction of spiked serum, and a mixture of 19 standards was evaluated in terms of response and reproducibility. The in vivo setup consisted into two parts: the first one was based the evaluation of the standard mixture, which was flash-vaporised into Tedlar® bags containing exhaled breath; the second part was based on the longitudinal monitoring of breath metabolites originating from a beverage intake (i.e., brewed coffee), over a 90 min time period. The tubes were all desorbed and analysed in a comprehensive two-dimensional gas chromatography system coupled to a high-resolution time-of-flight mass spectrometer (GC × GC-HR ToF MS). In both sampling setups, the widest analytes coverage and the overall best extraction yield on the selected compounds were obtained using Tenax® TA, followed by Tenax® TA/Carbopack™ B. Tenax® TA provided the highest sampling reproducibility with 12 %RSD, 10 %RSD and5 %RSD of the response during the experiments using the in vitro setup, the in vivo setup, and during the longitudinal tracking, respectively.

In the present research, the potential of breath analysis by comprehensive two-dimensional gas chromatography coupled to mass spectrometry (GC×GC-MS) was investigated for the discrimination between healthy and infected mice. A pilot study employing a total of 16 animals was used to develop a method for breath analysis in a murine model for studying Mycobacterium tuberculosis complex (MTBC) using the M. bovis bacillus Calmette-Guérin. Breath was collected in Tedlar bags and concentrated onto thermal desorption tubes for subsequent analysis by GC×GC-MS. Immunological test and bacterial cell count in bronchoalveolar lavage fluid and mice lung homogenate confirmed the presence of bacteria in the infected group. From the GC×GC-MS analysis, 23 molecules were found to mainly drive the separation between control and infected mice and their tentative identification is provided.This study shows that the overall used methodology is able to differentiate breath between healthy and infected animals, and the information herein can be used to further develop the mouse breath model to study MTBC pathogenesis, evaluate pre-clinical drug regimen efficacy, and to further develop the concept of breath-based diagnostics.

Microorganisms catabolize carbon-containing compounds in their environment during growth, releasing a subset of metabolic byproducts as volatile compounds. However, the relationship between growth media and the production of volatile compounds has been largely unexplored to-date. To assess the core and media-specific components of the Klebsiella pneumoniae volatile metabolome via growth in four in vitro culture media. Headspace volatiles produced by cultures of K. pneumoniae after growth to stationary phase in four rich media (brain heart infusion broth, lysogeny broth, Mueller-Hinton broth, and tryptic soy broth) were analyzed using comprehensive two-dimensional gas chromatography time-of-flight mass spectrometry (GC×GC-TOFMS). Differences in the composition of headspace volatiles as a function of growth media were assessed using hierarchical clustering analysis (HCA) and principal component analysis (PCA). A total of 365 volatile compounds were associated with the growth of K. pneumoniae across all media, of which 36 (10%) were common to all growth media, and 148 (41%) were specific to a single medium. In addition, utilizing all K. pneumoniae-associated volatile compounds, strains clustered as a function of growth media, demonstrating the importance of media in determining the metabolic profile of this organism. K. pneumoniae produces a core suite of volatile compounds across all growth media studied, although the volatile metabolic signature of this organism is fundamentally media-dependent.

The present research is based on the development of an effective, environmentally-friendly and low-cost method for investigation of minor components in vegetable oils, exploiting the advantages of a miniaturized solid-phase extraction (SPE) and the potential of flow modulation (FM) comprehensive two-dimensional gas chromatography (GC×GC), coupled to a mass spectrometer (MS) and a flame ionization detector (FID). The initial sample preparation step was carried out using a miniaturized approach characterized by a SPE process in a Pasteur pipette. Then, the isolated fraction was injected into an FM GC×GC system. Tentative identification was carried out by means of MS spectral information, while quantification was carried out by using the FID data. Four different vegetable oil samples were analyzed using the proposed method, namely an extra virgin olive oil (EVO), a hazelnut oil (HO), a borage oil, and an EVO/HO mixture.

The first description of a comprehensive two-dimensional gas chromatography (GC×GC) elucidation of an essential oil appeared in 2000 (J. High Resol. Chromatogr. 2000;23:208-214); since then, a variety of investigations have been published also involving complex samples related to essential oils, such as perfumes. In many instances, there was no mismatch between the use of GC×GC, and the analytical scope; on the other hand, in some specific cases the use of GC×GC appeared to be less adequate. The present contribution is focused on the application of GC×GC, within the context of essential oil analysis. Perfumes are also tightly related to essential oils, and so are herein considered. Rather than to describe and critically-review all the research related to such investigations, attention has been devoted to the general analytical usefulness of GC×GC in the aforementioned application fields, over more established approaches, such as conventional GC and heart-cutting multidimensional GC.

The present contribution is focused on the evolution and current trends of comprehensive two-dimensional gas chromatography-mass spectrometry (GC × GC-MS), with respect to a review that described this specific methodology published at the beginning of 2008 (Mondello et al., 2008). In fact, since then there has been considerable evolution in the MS field, certainly exceeding that observed in GC × GC. In particular, the present paper will cover the combination of novel MS machines [single quadrupole (Q) and triple quadrupole, isotope ratio, low- and high-resolution time-of-flight (ToF), hybrid (Q-ToF)] to GC × GC systems, and will position comprehensive two-dimensional gas chromatography within the wider context of separation science. © 2014 Wiley Periodicals, Inc. Mass Spec Rev 35:524-534, 2016.

The present research is based on the development and use of a flow-modulation (FM) comprehensive two-dimensional gas chromatography-quadrupole mass spectrometry (GC×GC-qMS) method for the determination of recently-highlighted (by the Scientific Committee on Consumer Safety) fragrance allergens (54) in cosmetics. FM GC×GC-qMS conditions were finely tuned to generate flow conditions (≈7 mL min(-1)) compatible with the qMS system used. Six-point calibration curves, over the range 1, 5, 10, 20, 50, 100 mg L(-1), were constructed for the 54 target allergens, with satisfactory linearity observed in all cases. Absolute quantification was performed by using extracted ions; target analyte identification was performed through measurement of ion ratios (qualifier/quantifier), full-scan MS database matching and the use of linear retention indices. Additional analytical figures of merit subjected to measurement were intra-day repeatability, accuracy at the 25 and 5 mg L(-1) levels, and limits of detection and quantification. The number of data points per peak, along with mass spectral skewing, was also subjected to evaluation. Finally, the FM GC×GC-qMS method was used not only for the quantification of target allergens in five commercial perfumes, but also for general qualitative profiling.

The present research is specifically based on the use of greatly-reduced gas flows, in flow-modulator (FM) comprehensive two-dimensional gas chromatography systems. In particular, focus of the present research is directed to FM devices characterized by an accumulation stage, and a much briefer re-injection step. It has been widely accepted that the operation of such FM systems requires high gas flows (≥20 mL/min), to re-inject the gas-phase contents of sample (or accumulation) loops, onto the second column. On the contrary, it will be herein demonstrated that much lower gas flows (≈ 6–8 mL/min) can efficiently perform the modulation step of re-injection. The possibility of using such improved operational conditions is given simply by a fine optimization of the processes of accumulation and re-injection. The application of lower gas flows not only means that second-dimension separations are carried out under better analytical conditions, but, even more importantly, greatly reduces problems which arise when using mass spectrometry (i.e., sensitivity and instrumental pumping capacity).

The present manuscript reports a comparative study between conventional and split-flow comprehensive GC×GC-MS. Conventional GC×GC-MS was performed by using a single GC oven, and with a widely employed apolar (30 m × 0.25 mm id)-polar (1 m × 0.10 mm id) column combination. Split-flow GC×GC-MS experiments were carried out by using the same first and second analytical columns, and by diverting part of the primary-capillary flow to waste, via a waste line. The latter was located at the conjunction point between the two dimensions. The measurement of fundamental gas chromatography parameters (efficiency, resolution), in both dimensions and under different experimental conditions, enabled the attainment of detailed information related to GC×GC-MS method optimization. Finally, the results derived from the present investigation highlight an important GC×GC issue, namely the efficiency of band reinjection onto the second-dimension capillary.

The present manuscript is focused on the evaluation of a novel high-speed triple quadrupole mass spectrometer (QqQ MS), carried out under extreme GC conditions, namely those generated by a flow-modulated (FM) comprehensive two-dimensional GC (GC × GC) system. The novel QqQ MS system is capable of operation under high speed conditions, in both full-scan (maximum scan speed: 20,000 amu/s) and multiple reaction monitoring (MRM) modes. Moreover, the QqQ MS instrument can generate simultaneous full scan/MRM data, also in a very rapid manner. An FM GC × GC–MSMS method was developed for the simultaneous full-scan qualitative analysis of untargeted essential oil compounds, and MRM quali/quantitative analysis of targeted ones, namely three preservatives [ o -phenylphenol (OPP), butylated hydroxytoluene (BHT), butylated hydroxyanisole (BHA)]. The QqQMS system generated a sufficient number of data points per peak, for both qualitative and quantitative purposes. The degree of sensitivity, reached through the MRM analysis, widely exceeded current-day regulations. Method validation, related to the MRM analysis, was performed considering retention time, peak area and ion ratio repeatability, limits of detection and quantification, and accuracy. Additionally, a spearmint essential oil was spiked with 5 phytosanitary compounds at the 1 ppb level, and analysed through an MRM-only GC × GC–MSMS application. Emphasis was devoted not only on sensitivity (satisfactory for all the contaminants), but also on the importance of precursor ion selection, and of the GC × GC separation process. Finally, sensitivity was compared between the MRM and SIM modes, in scan/MRM, MRM, scan/SIM and SIM analyses, performed on a mixture of 22 phytosanitary products, at a concentration level in the 50–150 ppb range.