Search

The emissions control regulations introduced by governments are set to improve engine quality and reduce the impact automobiles have on the planet. The regulations imposed on the manufactures have proven very difficult to meet. To this effect some of the leading names in the industry were pushed to invest significant funding in research, development and optimisation of combustion, powertrain and tribology inside the ICE. Their goal is reduction of fuel consumption and emissions while increasing performance and durability. The piston-ring and cylinder-liner interaction is the major source of frictional losses for reciprocating ICEs and so, it is important to avoid any failure of piston-rings to effectively control lubricant transport from the sump onto the cylinder walls and further to the combustion chamber. This lubricant will participate in the emissions through absorption and desorption of fuel in the oil film at the cylinder walls, also resulting in lubricant contamination and consumption. The objective of this project is to assist with the investigation of phenomena occurring in the cylinder liner and piston-ring interaction under different operating conditions. The following investigations have been carried out, flow and cavitation visualisation in a model lubricant rig and cavitation visualisation in a newly designed optical engine.

Both in engines and test rigs, cavitation in piston-ring lubrication is a subject studied by many researchers in the past. Although there is no sufficient evidence of cavitation erosion on the surface of the liner, this phenomenon is studied as part of the lubricant transport process. During the transport process the lubricant enters the combustion chamber. The combustion products of consumed oil might contribute to exhaust gas emissions and with emission legislation becoming more stringent, it is important that oil consumption is reduced to the lowest level possible. The role of the piston-rings is becoming more complex with the imposed requirements for lower oil consumption and friction. The piston-ring pack role on engine performance, durability and wear, is becoming on the other hand, more demanding. Between the piston-ring and cylinder liner, cavitation occurs as a result of two-phase liquid flow. Cavitation has long been recognized to degrade performances in most engineering applications and its effect in piston-ring lubrication is that it alters the oil film pressure profile, generated at the converging-diverging wedge of the piston-ring. An area of the piston-ring surface is void, corresponds to subatmospheric pressures and thus, the piston-ring load capacity is altered. Two experimental rigs were used, a simplified single-ring test rig that simulates the piston-ring liner movement at speeds corresponding to idle but the movement is reversed and a single cylinder diesel engine that was used for visualization results only, after the necessary modifications.