Search

The application of supported liquid membrane (SLM) extraction for the enrichment of short peptides is presented. The extraction efficiency is dependent on the pH of donor phase and salt concentration in acceptor phase. Moreover, the extraction efficiency is also influenced by the peptide amino-acid sequence and hydrophobicity.

A solid phase extraction (SPE) technique has been developed for the quantitative determination of polyaromatic hydrocarbons (PAHs) in aqueous samples. The SPE technique involved extraction of PAHs froma 100 mL sample containing 10 % methanol as a modifier onto C18 cartridges. 40 % methanol in water was used as conditioning solvent, and 3 mL acetone:THF (1:1) as eluting solvent. After eluting, the extract was reduced to 1 mL under nitrogen and then analyzed by GC-MS. The extraction was optimized for the addition of organic modifier, sample load volume, conditioning solvent, washing solvent and eluting solvent. In order to evaluate the practical applicability of SPE technique, water samples were spiked with the PAHs to give final sample concentrationsbetween 3 and 7 μg L–1. Enrichment factors of 81–135 were achieved with relative standard deviations (RSDs) of less than 6 %. Recoveries obtained ranged from 81 to 135 %. Detection limits ranged from 20.0–52.0 ng L–1. The optimized method was validated by analyzing certified reference materials. The optimized method was then applied to spiked real river samples in and around the Johannesburg area, South Africa. The concentrations obtained varied from 22.0 to 1040.0 ng L–1. The RSDs were between 2.3 and 13 %. The overall order of PAHs levels was: phenanthrene > acenaphthene > naphthalene > fluoranthene > pyrene.Keywords: Solid phase extraction, polycyclic aromatic hydrocarbons, water samples, Johannesburg, South Africa

This paper presents a comprehensive experimental analysis of lateral forces generated by single pedestrians during continuous walking on a treadmill. Two different conditions are investigated; initially the treadmill is fixed and then it is laterally driven in a sinusoidal motion at varying combinations of frequencies (0.33–1.07 Hz) and amplitudes (4.5–48 mm). The experimental campaign involved 71 male and female human adults and covered approximately 55 km of walking distributed between 4954 individual tests. When walking on a laterally moving surface, motion-induced forces develop at the frequency of the movement and are herewith quantified through equivalent velocity and acceleration proportional coefficients. Their dependency on the vibration frequency and amplitude is presented, both in terms of mean values and probabilistically to illustrate the randomness associated with intra- and inter-subject variability. It is shown that the motion-induced portion of the pedestrian load (on average) inputs energy into the structure in the frequency range (normalised by the mean walking frequency) between approximately 0.6 and 1.2. Furthermore, it is shown that the load component in phase with the acceleration of the treadmill depends on the frequency of the movement, such that pedestrians (on average) subtract from the overall modal mass for low frequency motion and add to the overall modal mass at higher frequencies.