Search

This paper presents a different Finite Control Set – Model Predictive Control (FCS-MPC) for grid-connected three-phase bidirectional power inverters. These are typically used in dc or ac renewable-based microgrids (MGs), where bidirectional operation and fast dynamic response is required. The bidirectional grid-connected inverters are an essential part of MG, which inject energy into the ac grid or demand energy from it. The dynamic behavior of the system is a major concern since the current can suddenly change depending on the hierarchical controller. This paper proposes a different cost function using sliding mode theory, which offers a good dynamic response, reduced computational burden, and a parameter-free control model. The operation principle of the proposed controller is given and evaluated using a Hardware-In-the-Loop (HIL) system, but also experimentally with a 1kW laboratory prototype. The final results demonstrate the advantages of using this approach in grid-connected three-phase bidirectional power inverters in terms of dynamic response and reduced computational burden, making this solution technically attractive and viable. [ABSTRACT FROM AUTHOR]

This paper proposes a multifunctional control strategy and associated control algorithms for distributed wind-turbine (WT) based nano-grids connected to a distorted utility-grid. The contribution is on a new strategy with innovative control algorithms to coordinate multiple converters for a multitasking operation of the nano-grids. The novelty is on a unique control design with feasibilities: maximizing the generated power from WT, maintaining power quality in both ac- and dc-sides under critical conditions of the power grid, and improving power quality against distortion from local nonlinear loads under a reduced switching frequency. A robust fast-dynamic predictive control method is developed for current controllers to fulfil the multifunction. Unconstrained deadbeat control inputs are derived in twofold targets: ensuring fast dynamic response and significantly reducing both the computation and switching frequency for finite predictive control. The control system is applied on a permanent-magnet synchronous generator (PMSG) WT-based nano-grid connected to a distorted utility-grid. An OPAL-RT-based real-time platform is used for comparative studies among the proportional integration (PI) control, finite predictive control (FS-MPC), and proposed control method. The performance verification exhibits the power quality improvement in both the nano- and utility-grids under critical conditions via high-performed regulation of currents, voltages, reactive power, and rotor-speed of the PMSG-WT. [ABSTRACT FROM AUTHOR]

The implementation of finite-control-set model predictive control (FCS-MPC) in voltage source inverters (VSIs) can make the system suffer from poor current harmonics performance, which may complicate the design of the required AC filter. To overcome this shortcoming, a carrier-based modulated model predictive control (CB-MMPC) strategy is proposed in this paper. This method enables the utilization of existing PWM modulation techniques with FCS-MPC, where a modulation waveform with zero-sequence signal injection is generated and compared to a triangular carrier wave, while optimizing the selection of the switching states. As it is shown, the studied CB-MMPC strategy not only considerably improves the current total harmonic distortion (THD) but also attains the performance of fast current dynamic response and robustness as the traditional FCS-MPC. Herein, the detailed implementation of the CB-MMPC control strategy is given, while considering its application to the current feedback control loop of a three-phase three-wire two-level VSI modulated at constant switching frequency. Finally, PLECS circuit simulation and a 3-kW VSI prototype are used to verify the superiority and the effectiveness of the presented CB-MMPC strategy. This is also benchmarked to the FCS-MPC and dead-beat based controllers. [ABSTRACT FROM AUTHOR]