Search

Megavolt-class pulsed gas switches play an important role in large pulsers as transfer switches. This article analyzes the breakdown process and characteristics of a megavolt self-triggered preionized switch under 100-ns pulses based on the optical diagnosis. It is discovered that the triggering spark illumination targeting the main cathode or anode can separately preionize the main gap. The discharge channel is likely to first form between trigger electrodes and the main anode. Based on the above deduction, the streamer velocity is calculated to be $0.54 \times 10^{6}$ – $2.34 \times 10^{6}$ m/s, proportional to the electric field. Also, parameters of the empirical formula for calculating the gas heating time are amended. Influence mechanisms of the switch jitter are also studied. Under pulsed preionization mode, the trigger gap breaks down when the main gap electric field is high enough, and the switch jitter is mainly determined by the self-triggering jitter. Nonetheless, the self-triggering jitter can be partly offset during the breakdown process if the changing rate of mean reduced electric field $d(E/p)$ / dt at the self-triggering time is higher than 1.0 $1.0\left(\mathrm{kV} \cdot \mathrm{ns}^{-1} \cdot \mathrm{cm}^{-1} \cdot \mathrm{MPa}^{-1}\right)$. Under sustaining preionization mode, the trigger gap breaks down prematurely, and the continuous arcing driven by switch leak current preionizes the main gap. Therefore, the influence of the self-triggering jitter on the switch jitter can be eliminated. [ABSTRACT FROM AUTHOR]

Due to its low-loss and high dielectric strength, polypropylene is widely used as electrical insulation material in pulse capacitors. In order to study its breakdown characteristics for nanosecond voltage pulses, an experimental setup was designed to generate voltage pulses with a 10%–90% rise time of 38 ns and a full width at half maximum of about 90 ns. Tests of the three polypropylene films with thicknesses of 12, 15, and $18~\mu \text{m}$ were performed. In addition, hundreds of nanoseconds pulse and dc voltage were also applied for comparison. The experimental results reveal that most of the breakdown occurs during the front edge of the pulse for tens of nanoseconds pulse, and the breakdown strengths of the three kinds of polypropylene films are almost identical for different applied voltages, which show a weak correlation between the thickness of the dielectric and the breakdown field. The expected breakdown strength of tens of nanoseconds pulse defined in this paper is not significantly higher than the mean value of the hundreds of nanoseconds pulse and the dc condition, suggesting that the breakdown of a thin polypropylene film is mainly determined by the electrical field but not the voltage-time cumulative effect. All these observations strengthen the conclusion that the breakdown of a thin polypropylene film is an intrinsic phenomenon. [ABSTRACT FROM AUTHOR]