Search

In the US, building sector consumes approximately 41% of all U.S. primary energy and 70% of all generated electricity. Office building uses the largest percentage of primary and derived energy in the commercial buildings sector. Therefore, energy saving is the primary target of building renovation and equipment retrofit. To estimate energy savings after a renovation or equipment retrofit, measurement and verification (M&V) must be conducted based on energy use models or benchmark tools to track and assess savings. Although some methods and modeling tools are applied more often, there is no well-accepted model formulation methodology and some methods have high uncertainty. This paper discusses a method to formulate the energy use model as an inverse regression model via an advanced and robust high-dimensional data analysis method. According to the inverse regression model, independent variables determined to be most influential to the energy consumption should be metered prior to building retrofit or audit. To select the most influential variables, this research considers a comprehensive set of potential key variables to avoid underspecified model issue. The models established by this method are observed to have great power in predicting the building energy consumption. More importantly, through the variable selection procedure, the method identifies key variables that should be monitored to continuously improve the building energy performance. A simulation study and a case study are presented to show the effectiveness of the new approach. [ABSTRACT FROM AUTHOR]

This paper investigates factors associated with variation in daily total (electricity and gas) energy consumption in domestic buildings using linked pre-COVID-19 smart meter, weather, building thermal characteristics, and socio-technical survey data covering appliance ownership, demographics, behaviours, and attitudes for two nested sub-samples of 1418 and 682 British households selected from the Smart Energy Research Laboratory (SERL) Observatory panel. Linear mixed effects modelling resulted in adjusted R2 between 63% and 80% depending on sample size and combinations of contextual data used. Increased daily energy consumption was significantly associated (p -value < 0.05, VIF < 5) with: households living in buildings with more rooms and bedrooms, that are older, more detached, have air-conditioning, and experience colder (more heating degree days) or less sunny weather; households with more adult occupants, more children, older adult occupants, higher heating temperature setpoints, and that do not try to save energy. The results demonstrate the value of smart meter data linked with contextual data for improving understanding of energy demand in British housing. Accredited UK researchers are invited to apply to access the data, which has recently been updated to include over 13,000 households from across Great Britain. This paper provides guidance on appropriate methods to use when analysing the data. [ABSTRACT FROM AUTHOR]

• Temporal variation of environmental impacts related to buildings electricity consumption is modelled. • Short term (e.g. peak demand) and long term aspects (e.g. variation of production capacities) are accounted for. • The method was applied in a case study, addressing uncertainties. • Consequences of electrification in the building sector can be evaluated. • Electrification does not necessarily reduce greenhouse gases emissions. The building stock is a major contributor to energy consumption and greenhouse gases emissions (GHG), which can be evaluated using life cycle assessment (LCA). Electrification of buildings, e.g. replacing fuel and gas boilers with heat pumps, in order to reduce these emissions is often seen as an option, but this will have short term effects by increasing peak demand, and long term effects by requiring more electricity production capacities. In this paper, a methodology to account for such interaction in LCA is presented. It connects three models addressing: market allocation on a national scale over a long term period, short term variation (i.e. seasonal, daily and hourly) of the electricity mix also on a national scale, and building energy simulation at the scale of one building. This methodology has been applied to a case study including a sample of buildings in the French context, but it can be used in other countries. Six buildings have been studied over 100 years considering 50 energy transition scenarios. Results show that the environmental impacts vary more depending on the scenarios than on the types of the building. Marginal mixes considered in consequential LCA are mainly composed of coal, gas, nuclear and peak technology production which explains the highest values of the different impacts compared to average mixes used in attributional LCA. This approach allows to address uncertainties related to electricity production. [ABSTRACT FROM AUTHOR]

• End-use of electricity consumption in residential buildings in Gulf Cooperation Council countries was presented. • Discrepancies in certain indicators have been observed by the end-use of electricity consumption. • Improving the efficiency of air conditioners and thermal insulation of the walls are the best measures to conserve electricity in residential buildings. • The results can be used in areas with a similar climate, living standard, buildings types, and the inhabitants' behavior. Energy conservation and improvement in energy efficiency yield multiple technical, economic, environmental, and social benefits and realize comfort and sustainability of residential buildings (RBs). This review paper presents the end-use of electricity consumption in RBs and the results of economic analysis. In addition, a description and discussion of studies on energy conservation measures, Net Zero Energy Building, and renewable energy in RBs are discussed. The percentage of end-used energy consumption for different purposes obtained in many studies are often not consistent. Moreover, discrepancies in certain indicators have been observed, necessitating the need to clarify the factors in the consumption of electricity in RBs. Further, a few studies used the term energy consumption in buildings (total or electrical); however, specifying the type of buildings to identify and use the necessary indicators of energy consumption in each type of building are desirable. Furthermore, most studies emphasized improving the efficiency of air conditioners and thermal insulation of the walls as these are the best measures to conserve electricity. [ABSTRACT FROM AUTHOR]