Search

The heat transfer characteristic of supercritical water is one of the crucial issues in SuperCritical Water-Cooled Reactors (SCWRs). The efficiency and safety of the SCWR system are largely dependent on the local heat transfer performance. This paper establishes the numerical model for supercritical water in a long vertical circular loop (inside diameter = 10 mm) and analyzes the flow and heat transfer mechanism during the transition process from subcritical to supercritical states under various heat fluxes (uniform and nonuniform). The results reveal that the difference in thermophysical properties between the boundary layer and the core region is the main reason for the heat transfer behavior, especially during the transition from subcritical to supercritical and liquidlike to gaslike. The flow structure on the buffer layer is a dominating factor for heat transfer deterioration. The cases under variable nonuniform heat fluxes have a higher heat transfer coefficient compared with uniform heat fluxes. But, this will cause large changes of the parameter locally. The dominating factors of heat transfer deterioration under these conditions are also identified. [ABSTRACT FROM AUTHOR]

The boiler equipment should be able to adapt to the load requirements and overcome the interference of various external conditions. By establishing a one-dimensional single-channel general numerical calculation model suitable for flow instability analysis of ultra-supercritical boilers at 700 °C, the rules of flow in the tubes are calculated. The 7th loop and the 22nd loop of the boiler water wall are selected as typical loops, and the dynamic characteristics of the two loops are calculated. The results show that after applying different multiples of heat flux disturbance, regardless of whether metal heat storage is considered, the inlet and outlet mass flow rates of the two circuits show inverse dynamic responses and eventually return to a steady state. When considering heat storage, it takes about 63 s for the 7th loop to return to stability. The recovery and stabilization time of the 22nd loop is about 60 s. Metal thermal storage has a positive effect on the settling time of the pipe section after heat flux disturbance. And when the maximum heat flux disturbance is applied, the maximum wall temperatures of the two loops are 443.9 °C and 446.5 °C, and the boiler can operate safely and stably. [ABSTRACT FROM AUTHOR]

A numerical study is conducted to investigate heat transfer characteristics of supercritical water flowing upward in an inclined smooth tube under uniform heating conditions. In this study, model verification was performed under the conditions of low heat flux and high heat flux to ensure the accuracy of experimental data. Inner wall temperature and heat flux distribute non-uniformly on the circumference due to the influence of natural convection. The increase of heat flux enhances the non-uniform circumferential distribution, while the increase of mass flux reduces the non-uniform circumferential distribution. Heat transfer of upward vertical and inclined flows is compared under low and high heat flux conditions. Radial distributions of fluid temperature, density, specific heat capacity, velocity, and turbulent kinetic energy are presented and analyzed. The analysis shows that the increase of heat flux reduces radial turbulence and heat-absorbing capacity of the boundary fluid, while increases radial temperature and density gradient. Three dimensionless buoyancy parameters are used to evaluate the buoyancy effect of inclined flow. [ABSTRACT FROM AUTHOR]