Search

Summary: In this paper, for standalone and grid‐connected PV systems, a three‐phase simplified split‐source inverter (SSI) is proposed and controlled using a model‐predictive control (MPC). The maximum power point tracking (MPPT) approach used is an incremental conductance method based on a PI controller for both systems. The standalone system is composed of PV modules, a three‐phase SSI, and a bidirectional power DC–DC converter that connects a battery bank and a DC‐side capacitor. The output AC voltages of SSI are controlled using MPC. The bidirectional power DC–DC converter regulates the DC‐link voltage (DCLV). The grid‐connected system consists of PV modules, a three‐phase SSI, and an AC‐side L‐filter. The DC‐link PI controller generates reference currents for the MPC algorithm. The MPC uses these reference currents to adjust and deliver the PV power to the grid while regulating the DCLV. The PI controllers' parameters are selected for both systems using the Harris Hawks optimization method. Both PV systems simulation results show that under various operating conditions, they have succeeded in fixing a DCLV and producing a high‐quality AC output voltage and current at low THD. Experimental results for the three‐phase standalone PV system used to verify the system's performance. [ABSTRACT FROM AUTHOR]

Summary: Bridgeless ac‐dc converters are the optimal choice for many applications, as they offer many advantages such as low distorted supply current, high power factor, and improved efficiency. This paper presents a new topology for a single‐phase bridgeless ac‐dc converter. The proposed hybrid topology is based on integrating the inverting and non‐inverting buck‐boost dc‐dc converters that are connected to the ac supply through an LC filter. To insure sinusoidal supply current, the proposed hybrid bridgeless ac‐dc converter is operated in discontinuous current mode. The proposed converter has many merits, such as a reduced number of components, enhanced efficiency, and soft start‐up capability. The operation modes and design of the proposed converter are presented. In addition, a design method is proposed for the input LC filter to minimize the voltage stress across switches. Moreover, a small signal model for the proposed converter is developed. The proposed converter topology is simulated to evaluate the dynamic behavior and verify the accuracy of the presented small signal model. Furthermore, an 850 W prototype is developed to validate the features of the proposed converter experimentally. Tight voltage regulation, sinusoidal supply current, and near‐to‐unity power factor operation are observed from the results, regardless of supply or load disturbances. [ABSTRACT FROM AUTHOR]