Search

Optimal nutrition care is important in the management of cystic fibrosis (CF). This paper summarises the '2017 Nutrition Guidelines for Cystic Fibrosis in Australia and New Zealand (NZ)'. CF dietitians formulated 68 practice questions which were used to guide a systematic literature search and review of the evidence for nutrition in CF. Identified papers underwent quality and evidence assessment using the American Dietetic Association quality criteria checklist and the National Health and Medical Research Council of Australia (NHMRC) rankings. Evidence statements, graded recommendations and practice points were developed covering core nutrition topics (assessment and nutrition interventions including oral, enteral and micronutrient supplementation); nutrition-related co-morbidities (including pancreatic insufficiency, CF-related diabetes, bone health and distal intestinal obstruction syndrome); and key new topic areas (genetic modulator therapies, overweight/obesity and complementary therapies). This paper showcases highlights from the guidelines, focussing on new topic areas and geographic and climate considerations for vitamin D, salt and hydration. • This paper summarises the 2017 Nutrition guidelines for CF for Australia and NZ • A systematic approach to evidence appraisal and guideline development was used • Nutrition assessment, nutrition support and micronutrient supplementation are covered • Nutrition-related topics including CF-related co-morbidities and PERT are covered • Novel topic areas include genetic modulators, overweight/obesity and probiotics [ABSTRACT FROM AUTHOR]

This paper presents experimental and numerical investigations into the post-fire cross-section compressive behaviour and resistances of circular recycled aggregate concrete-filled stainless steel tube (RACFSST) stub columns. Twelve stub column specimens, fabricated from concretes with three recycled coarse aggregate replacement ratios (0%, 35% and 70%), were tested after exposure to the ISO-834 standard fire for 0 min (i.e. at ambient temperature), 15 min, 30 min and 45 min. The experimental investigation included heating and cooling of specimens, cylinder tests and post-fire tensile coupon tests and stub column tests. The test results, including load–end shortening curves, failure loads and failure modes, were fully reported and the initial compressive stiffnesses and confinement effect were discussed. The numerical investigation was subsequently conducted, where thermal and mechanical finite element models were developed and validated against the test results and then used to perform parametric studies to generate further numerical data. Given the absence of design codes for stainless steel–recycled aggregate concrete composite structures after exposure to fire, the relevant design rules for circular natural aggregate concrete-filled carbon steel tube stub columns at ambient temperature, as set out in the European code, Australia/New Zealand standard and American specification, were assessed, using post-fire material properties, for their applicability to circular RACFSST stub columns after exposure to fire, based on the test and numerical data. The assessment results generally revealed that the European code and the Australian/New Zealand standard led to an acceptable level of design accuracy and consistency, while the American specification resulted in rather conservative and scattered post-fire cross-section compression resistance predictions. • The compressive behaviour of circular RACFSST stub columns after exposure to fire is investigated. • Post-fire compression tests on twelve circular RACFSST stub column specimens are conducted. • The influences of heating durations and RCA replacement ratios are analysed. • Thermal and mechanical FE models are validated against test results and then used to conduct parametric studies. • The relevant design codes are assessed against the test and FE data. [ABSTRACT FROM AUTHOR]

Abstract: This paper reviews the development of ecological economics in Australia and New Zealand since its beginnings in the late 1970s. A historical account is presented that focuses particularly on the activities of the Australia New Zealand Society for Ecological Economics and key ecological economics research activities. Achievements of ecological economics in Australia and New Zealand are assessed, using a range of quantitative and qualitative data. The main areas of expertise developed by Australian and New Zealand ecological economists were found to be: theoretical foundations and visions for ecological economics; biodiversity and resilience; input–output analysis; heterodox valuation approaches; analysis of economy–environment interactions; sustainability indicators; sustainable agriculture, fisheries and oceans; and energy/thermodynamics. Both countries are ranked at the top (or near the top) of the world rankings in terms of per capita ISEE membership and publication rates in Ecological Economics. A defining feature of ecological economics in Australia and New Zealand has also been its practical and problem-solving focus and the level of end-user engagement. The paper concludes by discussing the challenges that face the future development of ecological economics in Australia and New Zealand. [Copyright &y& Elsevier]

Cold-formed steel (CFS) Tab connections are popular due to their rapid fastening and ease of installation, and their applications have increased recently in Pacific countries, including Australia and New Zealand. This type of connection consists of a Tab plate formed from the web of the supporting beam and is screwed to the joist web, providing a dependable load path from the joist to the galvanized C-section supporting beam. However, no studies have been reported in the literature for the shear capacity of such connections. This paper presents a shear test program designed to determine the shear capacity of CFS Tab connections and to identify their failure mechanism. The experimental program included three different beam sizes, C-150, C-190 and C-240. Each test was repeated three times, resulting in nine tests in total. All the specimens failed in plate yielding and plate tearing, which occurred on the tension side of the plate (top region). Nonlinear finite element (FE) models were then developed and verified against the test results. The FE results showed good agreement with the test results in terms of connection stiffness, connection strength and failure modes. Finally, it was shown that the design equations given in the Australia/New Zealand standard (AS/NZS 4600) and American Iron and Steel Institute (AISI S100) for predicting the combined bending and shear capacity could predict the ultimate shear capacity of CFS Tab connections investigated in this study. • The results of monotonic shear tests of a novel CFS Tab connection are reported. • CFS Tab connections failed in plate yeailding and tearing. • A nonlinear FE model is developed. Results showed good agreement with the test results. • A design procedure is proposed for predicting the shear capacity of CFS Tab connections. [ABSTRACT FROM AUTHOR]

Abstract: The construction of high resolution chronologies of sediment profiles corresponding to the last 50–100 years usually entails the measurement of fallout radionuclides 210Pb and 137Cs. The anthropogenic radionuclide, 137Cs, originating from atmospheric nuclear weapons testing can provide an important “first appearance” horizon of known age (1954–1955), providing much-needed validation for the sometimes uncertain interpretations associated with 210Pb geochronology. However, while 137Cs usually provides a strong signal in sediment in the northern hemisphere, total fallout of 137Cs in the southern hemisphere was only 25% that of the north and the low activities of 137Cs seen in Australian and New Zealand sediments can make its horizon of first appearance somewhat arguable. Low 137Cs fallout also limited the size of the 1963–1964 fallout peak, a peak that is usually seen in northern hemisphere sediment profiles but is often difficult to discern south of the equator. This paper shows examples of the use of nuclear weapons fallout Pu as a chronomarker in sediment cores from Australia (3 sites) and New Zealand (1 site). The Pu profiles of five cores are examined and compared with the corresponding 137Cs profiles and 210Pb geochronologies. We find that Pu has significant advantages over 137Cs, including greater measurement sensitivity using alpha spectrometry and mass spectrometric techniques compared to 137Cs measurements by gamma spectrometry. Moreover, Pu provides additional chronomarkers associated with changes in the Pu isotopic composition of fallout during the 1950s and 1960s. In particular, the 238Pu/239+240Pu activity ratio shows distinct shifts in the early 1950s and the mid to late 1960s, providing important known-age horizons in southern hemisphere sediments. For estuarine and near-shore sediments Pu sometimes has another significant advantage over 137Cs due to its enrichment in bottom sediment relative to 137Cs resulting from the more efficient scavenging of dissolved Pu in seawater by sediment particles. [Copyright &y& Elsevier]

Abstract: Worldwide 30 food plants deliver 95% of human daily intake of plant food calories and around 300 other plant species are delivering the last 5%. These some 300 food plants are likely to be considered traditional in Europe, while the nearly 7000 other plant species traditionally used in the human food supply in other parts of the world may be considered novel in Europe. Novel food regulation is already in force in the European Community, Australia/New Zealand and in Canada where the novel plant foods need to go through a premarket assessment procedure. This paper propose criteria and definitions to be used in determining novelty of a plant food and also propose a safety assessment approach for novel plant food with no or limited documented history of safe consumption. A 2-step management procedure is recommended for a smooth introduction of fruits and vegetables; first to establish the novelty and second to define and commit resources for the safety assessment. The procedure builds upon the use of a worldwide network of global, regional, local and ethnobotanical positive lists for food plants to guide the decision on novelty at the first step and to enable the safety assessment at the second step. [Copyright &y& Elsevier]

• Flat-ended circular hollow sections were tested in tension. • Three bolt configurations were established in flattened ends. • Bearing failure and net-section fracture were observed. • The test load increased with increase in the number of bolts. • An adjusted bearing coefficient is suggested for bearing. Experiments were performed to investigate the behaviour of 28 circular hollow sections (CHSs) in tension, with flat ends and three bolt configurations (2, 3 and 4 bolts). The length of the members between the flat ends was kept constant at 1500 mm for all CHSs, and the sizes of the sections ranged from 60.3x2.0 to 101.6x4.5. Two modes of failure were observed, viz; bearing failure (BF) and net-section fracture (NSF). CHSs connected with 2 bolts failed in bearing, whilst net-section fracture was dominant in sections with 3 and 4 bolts. The notion that the change in the number of bolts can lead to different behaviours of the connections is a significant contribution to knowledge, particularly if flat-ended CHSs are used as structural truss elements. This paper demonstrates that the sections are capable of supporting large loads, however, the capacity of the tested specimen did not reach the full yield strength. It is apparent from the tensile strengths that a larger increase in strength was accomplished when the number of bolts was increased from 2 to 3 bolts than from 3 to 4 bolts. A comparison of the tensile strength with the strengths predicted by the North American standard (AISI S100-16w/S1-18), Australia/New Zealand standard (AS/NZS-4600:2018) and European standard (EN 1993–1-3) confirm that both standards provides a reasonable assessment of the strength of the 3 and 4 bolt configuration, which failed purely by net-section fracture. However, for the 2-bolted connections, which failed in bearing, it is proposed to use AS/NZS 4600:2018, with a bearing coefficient of C = 2.85, instead of C = 3.0, to increase the accuracy of the bearing strength expression for these specimens. [ABSTRACT FROM AUTHOR]

The rotation of beaches is important and should be more pronounced under high energy conditions with significant changes in wave direction. Shoreline rotation occurs when one end of a beach accretes, while the opposite retreats. This phenomenon is attributed to periodic or long-term changes in wave climate. To simulate the variability of the shoreline orientation in a simple and efficient way, the aim of this paper is to present a new equilibrium-based shoreline rotation model derived from a shoreline migration formulation. This model assumes that beach rotation is induced by the incoming wave power and direction. The proposed model was applied to two embayed beaches with different hydrodynamic and morphodynamic contexts located in the South Pacific Ocean. Almost fifteen years of shoreline positions extracted from hourly time-averaged images captured at Tairua Beach, New Zealand, and thirty-seven years of shoreline position data acquired from beach profile surveys at Narrabeen Beach, Australia, were used to evaluate the model performance. The results from the last beach have been compared and discussed with respect to an existing semi-empirical model, which has shown to successfully reproduce the time-varying shoreline rotation on embayed beaches. Overall, the results demonstrate that the proposed model successfully represents the general shoreline orientation variability both qualitatively and quantitatively. Nevertheless, observations from different sites with diverse beach characteristics and wave conditions are needed to broadly validate the proposed model. • A new equilibrium-based shoreline rotation model is presented. • An analytical Equilibrium Wave Direction Function (EWDF) is obtained. • The model successfully represents the shoreline orientation variability at two embayed beaches of the South Pacific Ocean. [ABSTRACT FROM AUTHOR]