Search

The present paper covers a review of documents that specify measurement methods of voltage waveform distortion. It also presents measurement stages of waveform components that are uncommon in the classic fundamentals of electrotechnics and signal theory, including the creation process of groups and subgroups of harmonics and interharmonics. Moreover, the paper discusses selected distortion factors of periodic waveforms and presents analyses that compare the values of these distortion indices. The measurements were carried out in the cycle per cycle mode and the measurement methodology that was used complies with the IEC 61000-4-7 norm. The studies showed significant discrepancies between the values of analyzed parameters. [ABSTRACT FROM AUTHOR]

Electrical grid modernization concept promotes the use of DC subgrids in order to improve efficiency, minimizing energy conversion count in the source-to-load chain. The present paper discusses an average current sensorless control algorithm for proposed bidirectional AC/DC converter, which is based on a dual half-bridge topology with common neutral wire that is not commutating during converter operation. The proposed current sensorless control algorithm has been obtained analytically for rectification, grid-tied and stand-alone inverter modes. The average value of inductor current tracks the reference current signal with constant switching frequency. Two control functions for inductor's discontinuous and continuous current modes have been defined for each of the operation modes, and a sensorless transition between DCM and CCM modes has been stated. The proposed sensorless control algorithm has been also adapted for use with LCL input filter. The results of simulation in the PSIM software approved the analytical model, keeping the average inductor current to follow the reference value in inductor discontinuous and continuous conduction modes. Experimental investigation of the proposed current control algorithm provided similar results confirming the discussed theory. [ABSTRACT FROM AUTHOR]

Any loss of power in converters is dissipated as heat in the components of the circuit. The article presents a new approach to measuring heat dissipation in a bridge power converter with hard switches using infrared thermography. Parallel measurements by thermocouples have been carried out. The experimental results are compared and used from the both cases. The proposed approach can be used for various circuit implementations of the converters in a similar manner. [ABSTRACT FROM AUTHOR]