Search

Voltage rise caused by high levels of distributed generation is manifesting as voltage regulation challenges for many electricity network service providers. In this environment it would be ideal to reduce supply voltage magnitudes, however, many network operators are hesitant to do so due to concerns related to consumer appliance performance at reduced supply voltage magnitudes. Voltage regulation requirements are defined by network standards and network service providers must ensure voltages remain within specified limits. Through an evaluation of domestic appliance performance when supplied at various voltage magnitudes, this paper examines the impact of varying voltage levels on residential appliances. Equipment energy demand, operation and actuation were monitored for each applied voltage magnitude. While no equipment failures were recorded, appliance behaviour varied significantly with applied voltage magnitude. Individual appliance conservation voltage reduction (CVR) factors have also been established. The results highlight the importance of good voltage regulation and provide substantiated appliance performance figures for future studies. The outcomes of this paper allow electricity network service providers to understand the implications of supply voltage magnitude on domestic appliance performance, whether it be understating of the impact of higher voltage magnitudes caused by distributed generation or implications of reducing voltage magnitudes to provide headroom for distributed generation integration. [ABSTRACT FROM AUTHOR]

This paper proposes a novel reactive power-based control strategy for single-phase PV inverters (PVIs) to simultaneously improve voltage unbalance (VU) and voltage regulation (VR) in low-voltage distribution networks. The proposed strategy relies on communication links between neighboring PVIs to exchange limited data. In this strategy, each PVI finds communication paths between itself and the closest neighboring ones connected to other phases. Then, using the obtained paths and the maximum and the minimum voltage magnitude of the grid, PVIs improve both VU and VR at the same time. The performance of the proposed control strategy is evaluated by various simulation studies using the IEEE European low-voltage test feeder and considering different operational conditions. In addition, the impacts of moving clouds and a failure in the communication links have been assessed. The simulation results exhibit that using the proposed control strategy, the voltage magnitude of all the nodes will remain within the allowed limits and at the same time, the phase voltage unbalance factor will be also significantly improved. [ABSTRACT FROM AUTHOR]

This paper proposes a novel data driven framework for detecting topology transitions in a distribution network. The framework analyzes data from phasor measurement units (PMUs) and relies on the fact that changes in network topology results in changes in the structure and admittance of the network. Using voltage and current phasors recorded by PMUs, the proposed method approximates network parameters using an ensemble-based deep learning model and thus, it does not require any knowledge of network parameters and load models. Using the prediction error of the proposed model, a connectivity matrix which shows the status of switches is constructed. In contrast to other methods, this proposed framework does not require a library of voltage and current transients associated with possible network transitions. It can also detect simultaneous switching actions and is robust to noise and load variations. The model yields a lower error detection rate, and its performance is validated using a modified version of the IEEE 33 bus network and a real feeder located in Queensland, Australia, under full and partial observability conditions. The proposed model has also been compared with another data driven method in terms of inference time and error detection rates. [ABSTRACT FROM AUTHOR]

With the advancements of the battery energy storage systems (BESSs), reduction of their manufacturing costs and government subsidies, the BESS uptake is likely to increase rapidly in power distribution networks. This paper investigates the effects of residential BESSs on low-voltage (LV) networks using the actual household load profiles equipped with BESS and solar-photovoltaic (PV) systems. The electricity consumption data collected via smart meters (2200 households with PV/BESS, 1950 households with PV only and 1000 households without a PV or a BESS) at different solar-PV penetration levels and network types are used to simulate real network operating scenarios. A real LV distribution network in Australia is analysed in DIgSILENT PowerFactory under different scenarios, such as, customers with and without a solar-PV/BESS, with a solar-PV but without a BESS, and without a solar-PV, by using both the power flow and quasi-dynamic simulation studies under balanced and the unbalanced network loading conditions. According to the study, customers experience large voltage excursions from solar-PV power exports, which could be resolved by the household BESS, provided that the BESS charging is coordinated with the solar-PV production. Moreover, quasi-dynamic simulation shows that the BESS could reduce the violation of the over-voltage limit during the solar peak hours (midday) by lowering the worst-case feeder voltage by 3%. Finally, extreme-event (high solar PV generation scenario) simulation shows that the implementation of the BESS controller to facilitate charging BESS during afternoon solar-PV export may reduce the negative grid impact and will assist to avoid network upgrades. [ABSTRACT FROM AUTHOR]

As residential PV generation penetrates in the low-voltage distribution network (LVDN), the unbalance issue may be intensified due to the asymmetry of generations/loads in different phases. Phase-reconfiguration device (PRD), which can reconfigure connected phases of residential customers, provides an effective method to address this issue. Noting that although the benefit brought by PRDs can vary if they are placed at different locations in the network, little literature has been reported on this topic. To bridge the research gap, this paper presents a novel method to optimally place PRDs in an LVDN aiming at minimizing the power unbalance running through the distribution transformer. The problem considers both installation, operational constraints, and boils down to a challenging mixed-integer non-convex programming problem, which is then reformulated as an efficient solvable mixed-integer linear programming problem. Moreover, operational constraints are relaxed with slack variables penalized in the objective function, which makes sure a feasible solution is always available without or with minimal operational violations. Case studies based on a modified IEEE system and a practical system in Australia demonstrate that an efficient strategy can be provided to address the unbalance issue while improving the network's power supply qualities. [ABSTRACT FROM AUTHOR]

As rooftop solar PVs installed by residential customers penetrate in low voltage distribution network (LVDN), some issues, e.g. over/under voltage and unbalances, which may undermine the network's operational performance, need to be adequately addressed. To mitigate unbalances in LVDN, phase-switching devices (PSDs) and static var compensator (SVC) are two equipment that is cost-effective and efficient. However, most existing research on operating PSDs is based on inflexible heuristic algorithms or without considering the network formulation, which may lead to strategies that violate operational requirements. Moreover, few pieces of literature have been reported on mitigating unbalances in LVDN via SVC and PSDs together. This paper formulates the decision-making process as a mixed-integer non-convex programming (MINCP) problem after developing an SVC model for dispatch purpose. Compared with existing work, the proposed method aims at minimizing current unbalance based on their phasor values and takes the network's operational requirements into account. To efficiently solve the challenging problem, the MINCP is reformulated as a mixed-integer second order-cone programming (MISOCP) problem based on either exact reformulations or accurate approximations, making it possible to employ efficient off-the-shelf solvers. Simulations based on two modified IEEE systems and a practical Australian LVDN demonstrates the efficiency of the proposed method in mitigating unbalances in LVDN. [ABSTRACT FROM AUTHOR]