Search

Penetration of distributed energy resources (DERs) such as wind, solar and battery units are rapidly increasing in distribution power system (DPS). In view of power grid reliability and efficiency, cyber and physical secure of these units are highly important since it can directly impact power system operations. This paper investigates the dynamic behavior of power distribution during cyber, physical and natural strikes on reactive power control in DER units. Various fault scenarios including modifications in voltage-reactive power (Volt-Var) curve pattern such as slope of the curve, dead band; and changes in capacitive or/and inductive reactive power delivery to the power grid are presented. Further, fault scenarios are investigated with the presence of dynamic VAR (volt-ampere reactive) compensation (DVC) units in the system. A southern California 140-bus commercial distribution power system is selected as a test system and faults are analyzed in both Matlab/Simulink and ETAP simulation platforms. The results evidence that the modifications in reactive power control values at DER units significantly affects the voltage quality/security of the system and affect the number of switching actions of voltage regulators (VRs). In contrast, DPS connected with DVCs improves voltage quality and reduces the number of switching actions of VRs, also voltage quality/security is maintained during the faults. [ABSTRACT FROM AUTHOR]

Traditionally voltage control in distribution power system (DPS) is performed through voltage regulating devices (VRDs) including on load tap changers (OLTCs), step voltage regulators (SVRs), and switched capacitor banks (SCBs). The recent IEEE 1547-2018 from March 2018 requires inverter fed distributed energy resources (DERs) to contribute reactive power to support the grid voltage. To accommodate VAR from DERs, well-organized control algorithm is required to use in this mode to avoid grid oscillations and unintended switching operations of VRDs. This paper presents two voltage control strategies (i) static voltage control considering voltage-reactive power mode (IEEE 1547-2018), (ii) dynamic and extensive voltage control with maximum utilization of DER capacity and system stability. Further, effective time-graded control is implemented between VRDs and DER units to reduce the simultaneous and negative operation. The proposed voltage control strategies are tested in a realistic 140-bus southern California distribution power system through extensive time-domain simulation studies. The results show that voltage quality in a distribution system is effectively achieved through the proposed voltage control strategies with a significantly reduction in the number of switching operations of VRDs. In addition, proposed voltage control strategies increase reliability and security of the DPS during unexpected failures. [ABSTRACT FROM AUTHOR]

In this paper, a highly efficient isolated resonant converter with a novel modulation method is proposed for delivering power from photovoltaic (PV) modules to the dc microgrid. The proposed modulation method allows the converter to boost low input voltages and regulate a wide input voltage range. The converter design is based on a series resonant converter (SRC) that operates at the resonant frequency to achieve highest efficiency under nominal input voltage condition. Under shadowed or low irradiance conditions of PV panels, the converter will operate with the proposed “double-pulse duty cycle” modulation method to step up the voltage for the dc microgrid connection. With the proposed modulation method, the output switches serve for both synchronous rectification and voltage boost function. This method enables a higher voltage boost ratio than the SRC without adding additional switches while operating at the resonant frequency. A 300-W hardware prototype with gallium-nitride devices is built to verify the performance of the proposed converter and modulation method. The converter achieved a peak efficiency of 98.9% and a California Energy Commission weighted efficiency of 98.7% under nominal input voltage condition. [ABSTRACT FROM AUTHOR]