Search

In this study, a minimizing inverter capacity design is proposed, and the characteristics and performance of static VAR compensator (SVC) coupling hybrid active power filters (SVC-HAPFs) are analyzed. The cost of the SVC part is much lower than that of the active inverter part, and thus, the reduction of inverter part capacity can lead to a decrease in the total cost of SVC-HAPF. To demonstrate the advantages of the proposed minimizing inverter capacity design of SVC-HAPF, comparisons are given between the conventional and the proposed SVC-HAPF designs. Comparisons are also provided among active power filters (APFs), HAPFs, and the proposed SVC-HAPF in terms of dc-link voltage, compensation range, and performance. Finally, simulation and laboratory-scale experimental results are given to validate the minimizing inverter capacity design, and to verify the characteristics and compensation performances of APF, HAPF, and the proposed SVC-HAPF. [ABSTRACT FROM AUTHOR]

This paper proposes an adaptive low-dc-link-voltage-controlled LC coupling hybrid active power filter (LC-HAPF) with a neutral inductor, which can compensate both dynamic reactive power and current harmonics in three-phase four-wire distribution power systems. Due to its adaptive low-dc-link-voltage characteristic, it can obtain the least switching loss and switching noise and the best compensating performances, compared with the conventional fixed and newly adaptive dc-voltage-controlled LC-HAPFs. The design procedures of the dc-link voltage controller are discussed, so that the proportional and integral gains can be designed accordingly. Moreover, the general design procedures for the adaptive dc-voltage-controlled LC-HAPF with a neutral inductor are also given. The validity and effectiveness of the adaptive dc-link voltage-controlled LC -HAPF with a neutral inductor are confirmed by experimental results obtained from a 220-V 10-kVA laboratory prototype compared with the conventional fixed and adaptive dc-link voltage-controlled LC-HAPFs without a neutral inductor. [ABSTRACT FROM AUTHOR]

Single-phase traction transformers are widely used in traction power supply systems due to their characteristics such as a low cost and a simple structure. Railway power conditioners (RPCs) could increase the loading capacity of substations and improve the supply quality. In this paper, a hybrid RPC (HRPC) is applied to reduce reactive power, relieve system unbalance, and suppress harmonics. The operational voltage of the HRPC is much lower than that of a conventional RPC. A method named partial compensation was used to reduce the current rating of the RPC, in which the compensating currents are expressed as a function of the power factor target at the grid side. When this method is used in the HPRC, the operational voltage varies with the compensating currents over a wide range. A comprehensive design procedure is proposed so that both the current and voltage ratings of the HRPC are reduced with partial compensation. A reduction of more than 50% is achieved by compensating the power factor at the grid side to 0.95 instead of to unity. The control block diagram for the HRPC with partial compensation is presented. The design and control of the HRPC are validated by simulation and experimental results. [ABSTRACT FROM PUBLISHER]

In high-power applications, different multilevel voltage source converter (VSC) topologies are usually applied. The hybrid parallel multiconverters, which is a combination of multiactive and hybrid VSCs connecting in parallel, can be a promising solution in a high-power grid. In this article, the fusion VSC topology concept is proposed in which fusion VSC takes the advantages of both active (inductive coupling) VSC and hybrid (capacitive coupling) VSC. It corresponds to overcoming the insufficient-capacity problems when active VSCs are employed alone and vice versa. This article proposes fusion active power filter topology by combing active and hybrid power VSC through their equivalent model for power quality compensation. With the proposed VSC's equivalent model, it can reduce the converter rating by 17%–80% compared with the conventional approaches. Additionally, the corresponding control algorithm is proposed for the FAPF for power quality compensation. Finally, the simulation and real-time digital simulator hardware-in-the-loop experimental results of the proposed FAPF topology are given to demonstrate the validity and effectiveness for reducing its capacity and power loss compared with the conventional multi-VSC in power quality compensation. [ABSTRACT FROM AUTHOR]