Search

In this study, a minimizing inverter capacity design is proposed, and the characteristics and performance of static VAR compensator (SVC) coupling hybrid active power filters (SVC-HAPFs) are analyzed. The cost of the SVC part is much lower than that of the active inverter part, and thus, the reduction of inverter part capacity can lead to a decrease in the total cost of SVC-HAPF. To demonstrate the advantages of the proposed minimizing inverter capacity design of SVC-HAPF, comparisons are given between the conventional and the proposed SVC-HAPF designs. Comparisons are also provided among active power filters (APFs), HAPFs, and the proposed SVC-HAPF in terms of dc-link voltage, compensation range, and performance. Finally, simulation and laboratory-scale experimental results are given to validate the minimizing inverter capacity design, and to verify the characteristics and compensation performances of APF, HAPF, and the proposed SVC-HAPF. [ABSTRACT FROM AUTHOR]

This paper proposes a hybrid static synchronous compensator (hybrid-STATCOM) in a three-phase power transmission system that has a wide compensation range and low dc-link voltage. Because of these prominent characteristics, the system costs can be greatly reduced. In this paper, the circuit configuration of hybrid-STATCOM is introduced first. Its V–I characteristic is then analyzed, discussed, and compared with traditional STATCOM and capacitive-coupled STATCOM (C-STATCOM). The system parameter design is then proposed on the basis of consideration of the reactive power compensation range and avoidance of the potential resonance problem. After that, a control strategy for hybrid-STATCOM is proposed to allow operation under different voltage and current conditions, such as unbalanced current, voltage dip, and voltage fault. Finally, simulation and experimental results are provided to verify the wide compensation range and low dc-link voltage characteristics and the good dynamic performance of the proposed hybrid-STATCOM. [ABSTRACT FROM PUBLISHER]

This paper proposes an adaptive low-dc-link-voltage-controlled LC coupling hybrid active power filter (LC-HAPF) with a neutral inductor, which can compensate both dynamic reactive power and current harmonics in three-phase four-wire distribution power systems. Due to its adaptive low-dc-link-voltage characteristic, it can obtain the least switching loss and switching noise and the best compensating performances, compared with the conventional fixed and newly adaptive dc-voltage-controlled LC-HAPFs. The design procedures of the dc-link voltage controller are discussed, so that the proportional and integral gains can be designed accordingly. Moreover, the general design procedures for the adaptive dc-voltage-controlled LC-HAPF with a neutral inductor are also given. The validity and effectiveness of the adaptive dc-link voltage-controlled LC -HAPF with a neutral inductor are confirmed by experimental results obtained from a 220-V 10-kVA laboratory prototype compared with the conventional fixed and adaptive dc-link voltage-controlled LC-HAPFs without a neutral inductor. [ABSTRACT FROM AUTHOR]

The capacitive-coupling grid-connected inverter (CGCI) is coupled to the point of common coupling via a second-order LC branch. Its operational voltage is much lower than that of a conventional inductive-coupling grid-connected inverter (IGCI) when it serves as a multifunctional inverter to compensate reactive power and transfer active power simultaneously. It is a promising solution for microgrid and building-integrated distributed generator systems. A quasi-proportional-resonant (quasi-PR) controller is applied to reduce the steady-state current tracking errors of the CGCI in this paper. The quasi-PR controller generates the voltage reference for use of carrier-based pulse-width modulation, which can effectively reduce output current ripples. The second-order coupling impedance of the CGCI causes its modeling and controller design to differ from that of the conventional IGCI. A comprehensive design method for the quasi-PR controller in a CGCI is developed. The quasi-PR controller is also compared with a proportional-integration current controller. Simulation results are provided to verify the effectiveness of the quasi-PR controller and its design method in a CGCI. The current tracking errors are greatly reduced when the quasi-PR controller rather than the proportional-integration controller is applied. Experimental results are also provided to validate the CGCI as a multifunctional grid-connected inverter. [ABSTRACT FROM PUBLISHER]

Single-phase traction transformers are widely used in traction power supply systems due to their characteristics such as a low cost and a simple structure. Railway power conditioners (RPCs) could increase the loading capacity of substations and improve the supply quality. In this paper, a hybrid RPC (HRPC) is applied to reduce reactive power, relieve system unbalance, and suppress harmonics. The operational voltage of the HRPC is much lower than that of a conventional RPC. A method named partial compensation was used to reduce the current rating of the RPC, in which the compensating currents are expressed as a function of the power factor target at the grid side. When this method is used in the HPRC, the operational voltage varies with the compensating currents over a wide range. A comprehensive design procedure is proposed so that both the current and voltage ratings of the HRPC are reduced with partial compensation. A reduction of more than 50% is achieved by compensating the power factor at the grid side to 0.95 instead of to unity. The control block diagram for the HRPC with partial compensation is presented. The design and control of the HRPC are validated by simulation and experimental results. [ABSTRACT FROM PUBLISHER]