Search

Huaguangjiao І is a Chinese ancient wooden shipwreck of South Song Dyansty (1127–1279 AD). Wood samples from Huaguangjiao І were analyzed in order to evaluate the preservation state of the waterlogged wood. Samples were studied from the anatomical, physical and chemical point of view. Thin slides of cross and longitudinal sections from samples were observed by optical microscope, micromorphological decay was classified into class 3 or class 4 according to the anatomical characters. Water content and basic density were measured. Maximum water content (MWC) of the wood samples is between 300% and 600%, residual basic density is about 50%. The proportion of the α-cellulose decreased to 25% of the normal value, and the content of the ash increased greatly. These results indicate the degradation of the wood is very high. In addition, there is a plenty of inorganic deposit in the wood structure. The inorganic compounds deposited in wood samples were analyzed by XRD and ICP qualitatively and quantitatively. The morphology and composition of the inorganic deposit was characterized through SEM-EDS, the majority were iron sulfide, including pyrite and marcasite (FeS 2 ), and fluorite (CaF 2 ). [ABSTRACT FROM AUTHOR]

Waterlogged archaeological wood (WAW) artifacts, made of natural biodegradable polymers, are important parts of many precious cultural heritages. It is of great importance to understand the hygroscopic behavior of WAW in different deterioration states for the development of optimal drying processes and choices of safe storage in varying conditions. This was investigated in a case-study using two Hopea (Giam) and two Tectona (Teak) WAW samples collected from the Xiaobaijiao No.1 shipwreck. The deterioration state of WAW was evaluated by the maximum water content (MWC) method and by the cell morphological structure. Both Hopea and Tectona WAW could be classified into moderately and less decayed WAW. The hygroscopic behavior of moderately and less decayed WAW was then comparatively investigated using Dynamic Vapor Sorption (DVS) measurements alongside two sorption fitting models. Compositional analysis and hydroxyl accessibility measurements of WAW cell walls were shown to correlate with the hygroscopicity of WAW in different deterioration states. It was concluded that moderately decayed WAW possessed higher hygroscopicity and hysteresis than less decayed WAW because of the lower relative content of polysaccharides and the higher relative content of lignin, including the slow hydrolysis of O-acetyl groups of xylan and the partial breakage of β-O-4 interlinks, accompanied by an increased hydroxyl accessibility. This work helps in deciding on which consolidation measures are advised for shipwreck restauration, i.e., pretreatments with specific consolidates during wood drying, particularly for wooden artifacts displayed in museums. [ABSTRACT FROM AUTHOR]

Structural and chemical deterioration and its impact on cell wall mechanics were investigated for visually intact cell walls (VICWs) in waterlogged archaeological wood (WAW). Cell wall mechanical properties were examined by nanoindentation without prior embedding. WAW showed more than 25% decrease of both hardness and elastic modulus. Changes of cell wall composition, cellulose crystallite structure and porosity were investigated by ATR-FTIR imaging, Raman imaging, wet chemistry, 13C-solid state NMR, pyrolysis-GC/MS, wide angle X-ray scattering, and N2 nitrogen adsorption. VICWs in WAW possessed a cleavage of carboxyl in side chains of xylan, a serious loss of polysaccharides, and a partial breakage of β-O-4 interlinks in lignin. This was accompanied by a higher amount of mesopores in cell walls. Even VICWs in WAW were severely deteriorated at the nanoscale with impact on mechanics, which has strong implications for the conservation of archaeological shipwrecks. [ABSTRACT FROM AUTHOR]

Multidisciplinary diagnostic methods were applied to evaluate the preservation state of waterlogged archaeological wood (WAW) from ancient Chinese shipwreck Nanhai No.1. The characterisation combines micromorphological, physical, and Fourier transform infrared (FTIR) analyses to overcome limitations of using a single analysis. The micromorphological analysis used the whole-slide imaging (WSI) method to identify wood species and determine the decay class. The collected samples were graded as Class 2 (moderate decay) or Class 3 (severe decay). Bacterial and fungal attacks on wood tissues were evident, and the decay pattern of erosion bacteria (EB) was verified. The maximum water content obtained from the oven-drying and freeze-drying methods confirmed that the micromorphological features can be used to grade the decay class. In tandem with hierarchical cluster analysis, FTIR measurements classified four clusters, including moderate and severe decay groups. FTIR also revealed that the chemical alteration of WAW was mainly due to the depletion of polysaccharides. Increased knowledge of WAW degradation and feasible diagnostic methods are beneficial for further conservation strategies. [ABSTRACT FROM AUTHOR]