Search

The recently introduced photothermoelectric (PTE) effect is proposed as an alternative for measuring dynamic thermal parameters of solid samples. The front PTE configuration, together with the thermal-wave resonator cavity method as a scanning procedure, was used to measure the value of thermal effusivity. The back PTE configuration, together with the chopping frequency of incident radiation as a scanning parameter, leads to the direct measurement of thermal diffusivity. A theory based on the above two detection configurations was developed and its application to solids, covering a large range of typical values of thermal parameters (aluminum and copper alloys, glass, teflon, polyethylene, LiTaO3), was described in order to demonstrate the suitability of the method. Experimental support for other well-known techniques (photopyroelectric and infrared lock-in thermography) has validated the results obtained with the novel method. [ABSTRACT FROM AUTHOR]

The photothermal radiometry (PTR) signal is analyzed in order to simultaneously obtain the thermal diffusivity and effusivity of solid materials. Analytical procedures that allow the determination of the thermal parameters via a frequency scan of the amplitude or the phase of the PTR signal are presented. The measurement procedures do not involve a multiparameter-fit optimization algorithm. The methods have been used for the measurement of thermophysical properties of vitreous carbon and lead-itanate-zirconate ceramic samples. [ABSTRACT FROM AUTHOR]

A photothermal radiometry configuration that allows the measurement of the temperature dependence of thermal parameters of solid materials is described. Two procedures are proposed. The first one is based on a combination of phase and amplitude signal data collected at a single frequency and the second one makes use of the information contained in the phase signal data, obtained at two different chopping frequencies. The methods are recommended for calorimetric studies requiring temperature scans at a constant chopping frequency. [ABSTRACT FROM AUTHOR]

We present the depolarization field effects (Maxwell-Wagner-Sillars effect) for the thermal transport properties of polymer dispersed liquid crystal composites under a frequency-dependent electric field. The experiments were conducted on polystyrene/4-Cyano-4'-pentylbiphenyl (PS/5CB) PDLCs of 73 vol.% and 85 vol.% liquid crystal (LC) concentrations. A self-consistent field approximation model is used to deduce the electrical properties of polymer and LC materials as well as the threshold electric field. Electric field-varying (at constant frequency) experiments were also conducted to calculate the interfacial thermal resistance between the LC droplets and polymer matrix as well as to find the elastic constant of LCs in droplet form. [ABSTRACT FROM AUTHOR]

The growing awareness of the environment and sustainable development has prompted the search for solutions involving the development of bio-based composite materials for insulating applications, offering an alternative to traditional synthetic materials such as glass- and carbon-reinforced composites. In this study, we investigate the thermal and microstructural properties of new biocomposite insulating materials derived from flaxseed-gum-filled epoxy, with and without the inclusion of reinforced flax fibers. A theoretical approach is proposed to estimate the thermal conductivity, while the composite's microstructure is characterized using X-ray Computed Tomography and image analysis. The local thermal conductivity of the flax fibers and the flaxseed gum matrix is identified by using effective thermal conductivity measurements and analytical models. This study provides valuable insight into the thermal behavior of these biocomposites with varying compositions of flaxseed gum and epoxy resin. The results obtained could not only contribute to a better understanding the thermal properties of these materials but are also of significant interest for advanced numerical modeling applications.

A new and accurate method for the thermal characterization of thermoelectric liquids is proposed. The experiment is based on a self-generated voltage due to the Seebeck effect. This voltage is provided by the sample when one of its two faces is thermally excited using a modulated laser. The sample used is tetradodecylammonium nitrate salt/1-octanol mixture, with high Seebeck coefficient. The thermal properties of the used sample (thermal diffusivity, effusivity, and conductivity) are found and compared to those obtained by other photothermal techniques. In addition to this, a study of the electrolyte thermal parameters with the variation of tetradodecylammonium nitrate concentration was also carried out. This new method is promising due to its accuracy and its simplicity.

Polyanilines (PANI)/reduced graphene oxide (RGO) nanocomposites are chemically synthesized. Their structure and morphology are characterized by scanning and transmission electron microscopies, x-ray diffraction and Raman spectroscopy. In addition, the nanocomposites' electrical, thermal and thermoelectric (TE) transport characteristics are investigated as a function of RGO content. The power factor and figure of merit (ZT) of PANI/RGO hybrids are deduced from measurements of the electrical conductivity (σ), Seebeck coefficient (α) and thermal conductivity (κ). Experimental results reveal that the properties of PANI/RGO composites are inherently dependent on the volume fraction of RGO. It is observed that electrical percolation follows a 2D conduction process which takes place for samples having 0.099 vol% RGO content. Unlike electrical conductivity, the thermal conductivity of PANI/RGO increases only slightly with the RGO fraction and is successfully fitted using a modified MG-EMA model which provides an interfacial (PANI/RGO nanoplatelets) resistance (Rk) of 4.9 × 10(-10) m(2) K W(-1). This low Rk value is attributed to good interactions between the planar geometry of RGO platelets and PANI aromatic rings through π-π stackings as evidenced by Raman spectroscopy and x-ray studies. Compared to that of pure PANI, the TE performance of PANI/RGO composites exhibits a ZT enhancement of two orders of magnitude.