Search

Here we use off-axis electron holography combined with advanced transmission electron microscopy techniques to understand the opto-electronic properties of AlGaN tunnel junction (TJ)-light-emitting diode (LED) devices for ultraviolet emission. Four identical AlGaN LED devices emitting at 290 nm have been grown by metal-organic chemical vapour deposition. Then Ge doped n-type regions with and without InGaN or GaN interlayers (IL) have been grown by molecular beam epitaxy onto the top Mg doped p-type layer to form a TJ and hence a high quality ohmic metal contact. Off-axis electron holography has then been used to demonstrate a reduction in the width of the TJ from 9.5 to 4.1 nm when an InGaN IL is used. As such we demonstrate that off-axis electron holography can be used to reproducibly measure nm-scale changes in electrostatic potential in highly defected and challenging materials such as AlGaN and that systematic studies of devices can be performed. The LED devices are then characterized using standard opto-electric techniques and the improvements in the performance of the LEDs are correlated with the electron holography results., (Creative Commons Attribution license.)

Optically pumped whispering-gallery mode (WGM) lasing is observed from a thin-film GaN microdisk processed from GaN-on-Si InGaN/GaN multi-quantum well wafers by selective wet-etch removal of the substrate. Compared with thin-film microdisks processed from GaN-on-sapphire wafers through laser lift-off of the sapphire substrate, the exposed surface is significantly smoother as laser-induced damage is avoided, with a root-mean-square roughness of 1.3 nm compared with 5.8 nm of the latter wafer. The ∼8- μ m diameter microdisks, fabricated by pattern transfer from a silica microsphere and dry etching, benefit from the surface smoothness to offer superior optical confinement within the cavity. WGM lasing thresholds of ∼2.9 mJ/cm 2 and ∼3.5 mJ/cm 2 with quality (Q)-factors of ∼3100 and ∼1700 are observed at the peak lasing wavelengths of ∼453 nm and ∼532 nm, respectively, which are significantly better than thin-film microdisks processed from GaN-on-sapphire wafers despite lower internal quantum efficiency, highlighting the importance of surface smoothness in such optical cavities.

Microdisks fabricated with III-nitride materials grown on GaN substrates are demonstrated, taking advantage of the high material quality of homoepitaxial films and advanced micro-fabrication processes. The epitaxial structure consists of InGaN/GaN multi-quantum wells (MQWs) sandwiched between AlGaN/GaN and InAlN/GaN superlattices as cladding layers for optical confinement. Due to lattice-matched growth with low dislocations, an internal quantum efficiency of ∼40% is attained, while the sidewalls of the etched 8 µm-diameter microdisks patterned by microsphere lithography are optically smooth to promote the formation of whispering-gallery modes (WGMs) within the circular optical cavities. Optically pumped lasing with low threshold of ∼5.2 mJ/cm 2 and quality (Q) factor of ∼3000 at the dominant lasing wavelength of 436.8 nm has been observed. The microdisks also support electroluminescent operation, demonstrating WGMs consistent with the photoluminescence spectra and with finite-difference time-domain (FDTD) simulations.

A multi-microscopy investigation of a GaN tunnel junction (TJ) grown on an InGaN-based light emitting diode (LED) has been performed. The TJ consists of a heavily Ge-doped n-type GaN layer grown by ammonia-based molecular-beam epitaxy on a heavily Mg-doped p-type GaN thin layer, grown by metalorganic vapor phase epitaxy. A correlation of atom probe tomography, electron holography and secondary ion mass spectrometry has been performed in order to investigate the nm-scale distribution of both Mg and Ge at the TJ. Experimental results reveal that Mg segregates at the TJ interface, and diffuses into the Ge-doped layer. As a result, the dopant concentration and distribution differ significantly from the nominal values. Despite this, electron holography reveals a TJ depletion width of ∼7 nm, in agreement with band diagram simulations using the experimentally determined dopant distribution.

Ultraviolet microdisk lasers are integrated monolithically into photonic circuits using a III-nitride-on-silicon platform with gallium nitride (GaN) as the main waveguide layer. The photonic circuits consist of a microdisk and a pulley waveguide, terminated by out-coupling gratings. In this Letter, we measure quality factors up to 3500 under continuous-wave excitation. Lasing is observed from 374 to 399 nm under pulsed excitation, achieving low-threshold energies of 0.14 m J / c m 2 per pulse (threshold peak powers of 35 k W / c m 2 ). A large peak-to-background dynamic of around 200 is observed at the out-coupling grating for small gaps of 50 nm between the disk and the waveguide. These devices operate at the limit of what can be achieved with GaN in terms of operation wavelength.

On-chip microlaser sources in the blue constitute an important building block for complex integrated photonic circuits on silicon. We have developed photonic circuits operating in the blue spectral range based on microdisks and bus waveguides in III-nitride on silicon. We report on the interplay between microdisk-waveguide coupling and its optical properties. We observe critical coupling and phase matching, i.e. the most efficient energy transfer scheme, for very short gap sizes and thin waveguides (g = 45 nm and w = 170 nm) in the spontaneous emission regime. Whispering gallery mode lasing is demonstrated for a wide range of parameters with a strong dependence of the threshold on the loaded quality factor. We show the dependence and high sensitivity of the output signal on the coupling. Lastly, we observe the impact of processing on the tuning of mode resonances due to the very short coupling distances. Such small footprint on-chip integrated microlasers providing maximum energy transfer into a photonic circuit have important potential applications for visible-light communication and lab-on-chip bio-sensors.

Nanophotonic circuits using group III-nitrides on silicon are still lacking one key component: efficient electrical injection. In this paper we demonstrate an electrical injection scheme using a metal microbridge contact in thin III-nitride on silicon mushroom-type microrings that is compatible with integrated nanophotonic circuits with the goal of achieving electrically injected lasing. Using a central buried n-contact to bypass the insulating buffer layers, we are able to underetch the microring, which is essential for maintaining vertical confinement in a thin disk. We demonstrate direct current room-temperature electroluminescence with 440 mW/cm 2 output power density at 20 mA from such microrings with diameters of 30 to 50 μm. The first steps towards achieving an integrated photonic circuit are demonstrated.

We demonstrate low-loss GaN/AlGaN planar waveguides grown by molecular beam epitaxy on sapphire substrates. By using a proper AlGaN cladding layer and reducing surface roughness we reach <1dB/cm propagation losses at 633nm. These low propagation losses allow an efficient second harmonic generation using modal phase matching between a TM0 pump at 1260nm and a TM2 second harmonic at 630nm. A maximal power conversion of 2% is realized with an efficiency of 0.15%·W -1 cm -2 . We provide a modelling that demonstrates broadband features of GaN/AlGaN platform by showing second harmonic wavelengths tunability from the visible up to the near-infrared spectral region. We discuss drawbacks of modal phase matching and propose a novel solution which allows a drastic improvement of modal overlaps with the help of a planar polarity inversion. This new approach is compatible with low propagation losses and may allow as high as 100%·W -1 cm -2 conversion efficiencies in the future.

We demonstrate phase-matched second harmonic generation in gallium nitride on silicon microdisks. The microdisks are integrated with side-coupling bus waveguides in a two-dimensional photonic circuit. The second harmonic generation is excited with a continuous wave laser in the telecom band. By fabricating a series of microdisks with diameters varying by steps of 8 nm, we obtain a tuning of the whispering gallery mode resonances for the fundamental and harmonic waves. Phase matching is obtained when both resonances are matched with modes satisfying the conservation of orbital momentum, which leads to a pronounced enhancement of frequency conversion.

We have developed a nanophotonic platform with microdisks using epitaxial III-nitride materials on silicon. The two-dimensional platform consists of suspended waveguides and mushroom-type microdisks as resonators side-coupled with a bus waveguide. Loaded quality factors up to 80000 have been obtained in the near-infrared spectral range for microdisk diameters between 8 and 15 μm. We analyze the dependence of the quality factors as a function of coupling efficiency. We have performed continuous-wave second harmonic generation experiments in resonance with the whispering gallery modes supported by the microdisks.