Search

Background: The aim of this study was to evaluate the impact of intravenous palonosetron compared to ondansetron on hypotension induced by spinal anesthesia in women undergoing cesarean section. Methods: Fifty-four women scheduled for elective cesarean section were, randomly allocated to ondansetron group (n = 27) or palonosetron group (n = 27). Ten minutes prior to the administration of spinal anesthesia, participants received an intravenous injection of either ondansetron or palonosetron. A prophylactic phenylephrine infusion was initiated immediately following the intrathecal administration of bupivacaine and fentanyl. The infusion rate was titrated to maintain adequate blood pressure until the time of fetal delivery. The primary outcome was total dose of phenylephrine administered. The secondary outcomes were nausea or vomiting, the need for rescue antiemetics, hypotension, bradycardia, and shivering. Complete response rate, defined as the absence of postoperative nausea and vomiting and no need for additional antiemetics, were assessed for up to 24 hours post-surgery. Results: No significant differences were observed in the total dose of phenylephrine used between the ondansetron and palonosetron groups (387.5 μg [interquartile range, 291.3–507.8 μg versus 428.0 μg [interquartile range, 305.0–507.0 μg], P = 0.42). Complete response rates also showed no significant differences between the groups both within two hours post-spinal anesthesia (88.9% in the ondansetron group versus 100% in the palonosetron group; P = 0.24) and at 24 hours post-surgery (81.5% in the ondansetron group versus 88.8% in the palonosetron group; P = 0.7). In addition, there was no difference in other secondary outcomes. Conclusion: Prophylactic administration of palonosetron did not demonstrate a superior effect over ondansetron in mitigating hemodynamic changes or reducing phenylephrine requirements in patients undergoing spinal anesthesia with bupivacaine and fentanyl for cesarean section. [ABSTRACT FROM AUTHOR]

Guanyl-urea phosphate (GUP) was introduced into furfurylated wood in order to improve fire retardancy. Modified wood was produced via vacuum-pressure impregnation of the GUP–furfuryl alcohol (FA) aqueous solution, which was then polymerized at elevated temperature. The water leaching resistance of the treated wood was tested according to European standard EN 84, while the leached water was analyzed using ultra-performance liquid chromatography (UPLC) and inductively coupled plasma–sector field mass spectrometry (ICP-SFMS). This new type of furfurylated wood was further characterized in the laboratory by evaluating its morphology and elemental composition using optical microscopy and electron microscopy coupled with energy-dispersive X-ray spectrometry (SEM-EDX). The chemical functionality was detected using infrared spectroscopy (FTIR), and the fire resistance was tested using cone calorimetry. The dimensional stability was evaluated in wet–dry soaking cycle tests, along with the mechanical properties, such as the Brinell hardness and bending strength. The fire retardancy of the modified furfurylated wood indicated that the flammability of wood can be depressed to some extent by introducing GUP. This was reflected in an observed reduction in heat release rate (HRR2) from 454.8 to 264.9 kW/m2, without a reduction in the material properties. In addition, this leaching-resistant furfurylated wood exhibited higher fire retardancy compared to conventional furfurylated wood. A potential method for producing fire-retardant treated furfurylated wood stable to water exposure has been suggested. [ABSTRACT FROM AUTHOR]

Furfurylated wood has been used widely for exterior purposes due to its superior dimensional stability and biological durability, though its fire resistance is not enhanced. Here, the introduction of the fire-retardant additive guanyl-urea phosphate (GUP) into furfurylated wood is reported. The treatment improved both the thermal and fire stabilities of the modified wood, as supported by the results of thermal gravimetric analysis (TGA) and limiting oxygen index (LOI) before and after accelerated ageing testing (according to EN 84) to determine the water resistance of the treatment. The results indicated that the hydroscopic GUP remained within the wood structure and provided superior thermal and fire properties. The work suggests the idea of combining GUP and furfuryl alcohol (FA), which has the prospective to impart substantial fire-retardancy to the furfurylated wood, thus increasing the potential for exterior applications. [ABSTRACT FROM AUTHOR]

Many studies have demonstrated that heavy metals existing as a mixture in the atmospheric environment cause adverse effects on human health and are important key factors of cytotoxicity; however, little investigation has been conducted on a toxicological study of a metal mixture from atmospheric fine particulate matter. The objective of this study was to predict the combined effects of heavy metals in aerosol by using in vitro human cells and obtain a suitable mixture toxicity model. Arsenic, nickel, and lead were selected for mixtures exposed to A549 human lung cancer cells. Cell proliferation (WST-1), glutathione (GSH), and interleukin (IL)-8 inhibition were observed and applied to the prediction models of mixture toxicity, concentration addition (CA) and independent action (IA). The total mixture concentrations were set by an IC10-fixed ratio of individual toxicity to be more realistic for mortality and enzyme inhibition tests. The results showed that the IA model was statistically closer to the observed results than the CA model in mortality, indicating dissimilar modes of action. For the GSH inhibition, the results predicted by the IA and CA models were highly overestimated relative to mortality. Meanwhile, the IL-8 results were stable with no significant change in immune reaction related to inflammation. In conclusion, the IA model is a rapid prediction model in heavy metals mixtures; mortality, as a total outcome of cell response, is a good tool for demonstrating the combined toxicity rather than other biochemical responses. [ABSTRACT FROM AUTHOR]

Citrate-coated AgNPs (c-AgNPs) have negatively charged surfaces and their surface interactions with heavy metals can affect metal toxicity in aquatic environments. This study used Daphnia magna to compare the acute toxicities and bioaccumulation of As(V), Cd, and Cu when they interact with c-AgNPs. The 24-h acute toxicities of As(V) and Cu were not affected by the addition of c-AgNPs, while bioaccumulation significantly decreased in the presence of c-AgNPs. In contrast, both the 24-h acute toxicity and bioaccumulation of Cd increased in the presence of c-AgNPs. These toxicity and bioaccumulation trends can be attributed to the interactions between the AgNP surface and the heavy metals. As(V) and c-AgNPs compete by negative charge, decreasing As(V) toxicity. Copper adheres readily to c-AgNP citrate, decreasing Cu bioavailability, and thus reducing Cu toxicity and bioaccumulation. Citrate complexes with divalent cations such as Ca and Mg reduce the competition between divalent cations and Cd on biotic ligand, increasing toxicity and bioaccumulation of Cd. This study shows that surface properties determine the effect of c-AgNPs on heavy metal toxicities and bioaccumulations; hence, further studies on the effect of nanoparticle by it surface properties are warranted. [ABSTRACT FROM AUTHOR]

In this study, the wood–water interactions in Scots pine sapwood modified with maleic anhydride (MA) and sodium hypophosphite (SHP) was studied in the water-saturated state. The water in wood was studied with low field nuclear magnetic resonance (LFNMR) and the hydrophilicity of cell walls was studied by infrared spectroscopy after deuteration using liquid D2O. The results of LFNMR showed that the spin–spin relaxation (T2) time of cell wall water decreased by modification, while T2 of capillary water increased. Furthermore, the moisture content and the amount of water in cell walls of modified wood were lower than for unmodified samples at the water-saturated state. Although the amount of accessible hydroxyl groups in modified wood did not show any significant difference compared with unmodified wood, the increase in T2 of capillary water indicates a decreased affinity of the wood cell wall to water. However, for the cell wall water, the physical confinement within the cell walls seemed to overrule the weaker wood–water interactions. [ABSTRACT FROM AUTHOR]

Simple Summary: This study proposed a methodology to simulate ecological damage in a toluene spill situation by coupling AQUATOX, an established ecological assessment model, and EFDC, a Lagrangian fluid diffusion model. TheAQUATOX-EFDC simulation showed a significant ecological impact, especially the greatest damage on the fish species group, the top predators. In this study, an ecological impact was assessed for the short-term leak scenario through the AQUATOX-EFDC model, which combines the proven ecological model AQUATOX with the hydrodynamic model EFDC. A case study of the coupled AQUATOX-EFDC model was conducted for 30–30,000 kg toluene leak scenarios in the Jeonju River in South Korea. A 21-day scenario simulation was conducted, and the impact of the toluene spill accident was evaluated by comparing the biomass between the control simulation and the perturbed simulation. As a result of the simulation, it was found that in the scenario in which 3000 kg of toluene was leaked for a day, a substantial change was expected in the range of 0–640 m from the accident site. Additionally, for a 30,000 kg leak, a substantial change was expected in the range of 0–2300 m from the accident site, and the greatest damage was observed for the fish species group, the top predators. As a result, the AQUATOX-EFDC simulation showed a significant ecological impact, and the proposed model will be helpful to understand the ecological impact and establish the management strategy for the ecological risk of the chemical spill. [ABSTRACT FROM AUTHOR]

A large quantity of volatile organic compounds (VOCs) can be released into water environments from oil spills and chemical exposure accidents. A recently developed solid ceramic dosimeter (SCD) could be used for long-term measuring of low VOCs concentrations in water. However, calibration and field testing of these SCDs have thus been far insufficient to apply for VOCs monitoring in a water environment in a chemical industrial area. We conducted laboratory calibration experiments and stability tests of the SCD. The mass accumulation of 14 target VOCs from 2 to 100 μg/L was increased linearly with time in the sampler. The absorption rate of the VOCs was related to Henry's law constant. The average diffusion coefficient of the 14 VOCs in the SCD wall was 1.02 × 10−9 m2/s. The SCD was utilized in a petrochemical plant complex in South Korea with an industrial wastewater reservoir. After a total of 7 days of deployment, chloroform, ethylbenzene, and toluene were detected by both passive sampling and grab sampling at the same VOC concentrations. [ABSTRACT FROM AUTHOR]

Increasing evidence suggests that the toxicity of fine dust particles (PM 2.5) is linked to specific components rather than their mass. However, research on the chemical composition and health risk of PM 2.5 is insufficient. This study analyzed the metals, polycyclic aromatic hydrocarbon (PAHs), organochlorine pesticides (OCPs), and polychlorinated biphenyls (PCBs) present in PM 2.5 and evaluated their risk to health during outdoor activities. The concentration of metals was one order of magnitude higher than that of PAHs and the concentration and detection frequency of OCPs and PCBs were considerably lower than those of metals and PAHs. The lifetime excess cancer risk (LECR) for carcinogens in PM 2.5 exceeded de minimis risk (1 × 10−6) as 1.33–3.44 × 10−6 (at 5th–95th percentile) as Cr(VI), As, and Cd showed high contributions. Children in the 2 < years <18 age group had a high risk of cancer due to early-life susceptibility. The proportion of ∑Metals to LECR was approximately 95%, while ∑PAHs attributed to 5% of total LECR. The effects of ∑OCPs and 2,3′,4,4′,5′-Pentachlorobiphenyl (PCB-123) on LECR were negligible. The hazard quotient (HQ) for non-carcinogens was <1, and non-carcinogenic effects were not expected. Mn, BaP, Pb, As, and Cd were the key determinants of the HQ values and among the identified PM 2.5 sources they are closely related to industrial activities, oil combustion, and gasoline exhaust. Therefore, control strategies for these sources can effectively reduce PM 2.5 risk. This study measured the concentrations of toxic compounds in ambient PM 2.5 and considered only PM 2.5 exposure during outdoor activities. PM 2.5 health risk during the entire day would be higher than the PM 2.5 risk determined in this study, and further research is required for this evaluating this risk. Unlabelled Image • LECR was 1.33–3.44 × 10−6 (5th–95th percentile); this cannot be ignored. • Non-carcinogenic effects are not expected by acute exposure of PM2.5 (HQ < 1). • The major contributors to PM 2.5 risk were As, Cr(VI), Cd, Mn, BaP, and Pb. • Related sources were industrial activities, combustion of oil, and vehicle exhaust. [ABSTRACT FROM AUTHOR]

Assessing environmental impacts on health in the Pacific Basin is challenged by significantly varying data types - quantities, qualities, and paucities - because of varying geographic sizes, environments, biodiversity, ecological assets, and human population densities, with highly varied and unequal socio-economic development and capacity to respond to environmental and health challenges. We discuss three case-based methodological examples from Pacific Basin environmental health impact assessments. These methods could be used to improve environmental health evidence at all country and regional levels across a spectrum of big data availability to no data. These methods are, 1) a risk assessment of airborne particulate matter in Korea based on the chemical composition of these particulates; 2) the use of system dynamics to appraise the influences of a range of environmental health determinants on child health outcomes in remote Solomon Islands; and 3) precision environmental public health methodologies based on comprehensive data collection, analyses, and modelling (including Bayesian belief networks and spatial epidemiology) increasing precision for good environmental health decision making to prevent and control a zoonotic disease in Fiji Islands. We show that while a common theme across the three examples is the value of high quality and quantity data to support stronger policy decisions and appropriate prioritizing of investment, it is also clear that for many countries in the Pacific Basin, sufficient data will remain a challenge to inform decision makers about environmental impact on health., Competing Interests: The authors have no competing interests to declare., (Copyright: © 2022 The Author(s).)

This study investigated the toxicity changes and sorption of pharmaceuticals and endocrine disrupters in the presence of humic acid (HA). For the sorption experiment, a dead end filtration (DEF) system was used to separate bound and free-form target compounds. An algae growth inhibition test and E-screen assay were conducted to estimate the toxic effect of pharmaceutically active compounds (PhACs) and endocrine disrupting chemicals (EDCs), respectively. The permeate concentration was confirmed using liquid chromatography-mass spectrometry. In the sorption test, we observed significant sorption of PhACs and EDCs on colloidal HA, except for sulfamethoxazole (SMX). The values of log KCOC derived from DEF determinations ranged from 4.40 to 5.03. The removal efficiency varied with the HA concentration and the target chemical properties. Tetracycline and 4-octylphenol showed the highest sorption or removal efficiency (≈50%), even at 5 mg C/L HA. The algal growth inhibition of PhACs and the estrogenic effects of EDCs were significantly decreased in proportion to HA concentrations, except for SMX. In addition, the chemical analysis results showed a positive relationship with the bioassay results. Consequently, the sorption of PhACs and EDCs onto colloidal HA should be emphasized in natural environments because it significantly reduces bioavailable concentrations and toxicity to aquatic organisms.