Search

This paper deals with the system oriented analysis, design, modeling, and implementation of active clamp HF link three phase converter. The main advantage of the topology is reduced size, weight, and cost of the isolation transformer. However, violation of basic power conversion rules due to presence of the leakage inductance in the HF transformer causes over voltage stresses across the cycloconverter devices. It makes use of the snubber circuit necessary in such topologies. The conventional RCD snubbers are dissipative in nature and hence inefficient. The efficiency of the system is greatly improved by using regenerative snubber or active clamp circuit. It consists of an active switching device with an anti-parallel diode and one capacitor to absorb the energy stored in the leakage inductance of the isolation transformer and to regenerate the same without affecting circuit performance. The turn on instant and duration of the active device are selected such that it requires simple commutation requirements. The time domain expressions for circuit dynamics, design criteria of the snubber capacitor with two conflicting constrains (over voltage stress across the devices and the resonating current duration), the simulation results based on generalized circuit model and the experimental results based on laboratory prototype are presented. [ABSTRACT FROM PUBLISHER]

Based on a general critical condition of subharmonic oscillation in terms of the loop gain, many closed-form critical conditions for various control schemes in terms of converter parameters are derived. Some previously known critical conditions become special cases in the generalized framework. Given an arbitrary control scheme, a systematic procedure is proposed to derive the critical condition for that control scheme. Different control schemes share similar forms of critical conditions. For example, both V^2 control and proportional voltage mode control have the same form of critical condition. A peculiar phenomenon in average current mode control where subharmonic oscillation occurs in a window value of pole can be explained by the derived critical condition. A ripple amplitude index to predict subharmonic oscillation proposed in the past research has limited application and is shown invalid for a converter with a large pole comparable to the switching frequency. [ABSTRACT FROM PUBLISHER]

A dual modulation technique to improve power conversion efficiency with minimal increase in output voltage ripple is presented. The worsening switching noise caused by parasitic resistance and inductance due to high-switching operation can also be alleviated by the proposed ac ripple detector. Furthermore, the dual modulation method can speed up the load transient response since the switching frequency can increase to 5 MHz during the transient period. At very light loads, the switching frequency is always kept higher than the acoustic frequency to avoid noisy sound. Experiment results show that the converter operates at 5 MHz using a small inductor of 1 \mu \H. The load transient response time is shorter than 3 \mu \s when load current changes from 150 to 450 mA or vice versa. Power efficiency is kept higher than 85% over a wide load current range. Specifically, light efficiency can be raised to about 45% above that of the conventional design. [ABSTRACT FROM PUBLISHER]