Search

The possibility of operating distributed generation (DG) in islanded mode brings several benefits but still faces some problems, especially related to the transition from a grid-connected to an islanded operating condition. When connected to the main grid, DG units operate in PQ mode. During this transition, their controls must be changed to regulate frequency and voltage. The delay for islanding detection, associated with abrupt changes in the control references, may result in large and detrimental transients. This paper proposes a new control structure for a distributed synchronous generator (DSG) to allow a smooth transition from the grid-connected to the islanded operation mode. The proposed control structure uses a compensation loop that was conceived based on the main ideas of the anti-windup bumpless transfer (AWBT) theory (although it is not, strictly speaking, an AWBT controller). The results show that the proposed structure ensures smaller excursions of the DSG variables during the transition and, therefore, the possibility of a successful formation of the islanded system is extended to a wider range of operating conditions. Moreover, with the proposed control, the success of this transition does not depend on the islanding detection time, which is the main contribution of this paper. [ABSTRACT FROM AUTHOR]

This paper tackles key industry needs in the scope of the AC Security-Constrained Optimal Power Flow (SCOPF) framework, specifically two major challenging requirements regarding generators’ post-contingency behavior: the (droop-based) frequency response and the voltage control mechanism (including PV/PQ switching). To this end, and to obtain a sufficiently accurate solution with a reasonable computational burden, we propose an approximation approach to SCOPF which extends significantly an existing algorithm with novel modelling elements: a continuous formulation to model generators’ post-contingency responses based on successive approximations, a technique to evaluate the viability of contingencies with respect to the base case set-points, and the complexity reduction of all post-contingency states through network compression and power flow piecewise linearization. All new features are validated both separately and in unison, to monitor the improvement of the solution time and the potential degradation of the solution's quality. The proposed approach is successfully applied to three power system network models, the largest of which consists of 2,000 buses and more than 3,000 contingencies. Finally, the trade-off between the limitations in terms of solution quality and the benefits in terms of computational effort are assessed for all proposed approximations. [ABSTRACT FROM AUTHOR]

This paper presents the development of a wind switched-reluctance generator (SRG) with interleaved interface dc–dc converter. First, the power circuit and control scheme of the SRG are properly designed. The hysteresis current-controlled pulse width modulation (PWM) scheme is designed to achieve good winding current tracking control, and the robust voltage control scheme is developed to yield well-regulated dc output voltage under varying prime mover driving speed and load conditions. Moreover, the voltage regulation and the developed power performances of SRG are further enhanced using the proposed commutation shift approach. Next, an interleaved current-fed push–pull interface dc–dc converter with two modules is developed to establish the boosted common dc bus voltage of a dc microgrid from the SRG output having fault-tolerant capability. The rating analysis and circuit component design are conducted in detail. Similarly, well-regulated voltage with lower ripples is also yielded via the properly designed schematic and control scheme. [ABSTRACT FROM AUTHOR]