Search

The possibility of operating distributed generation (DG) in islanded mode brings several benefits but still faces some problems, especially related to the transition from a grid-connected to an islanded operating condition. When connected to the main grid, DG units operate in PQ mode. During this transition, their controls must be changed to regulate frequency and voltage. The delay for islanding detection, associated with abrupt changes in the control references, may result in large and detrimental transients. This paper proposes a new control structure for a distributed synchronous generator (DSG) to allow a smooth transition from the grid-connected to the islanded operation mode. The proposed control structure uses a compensation loop that was conceived based on the main ideas of the anti-windup bumpless transfer (AWBT) theory (although it is not, strictly speaking, an AWBT controller). The results show that the proposed structure ensures smaller excursions of the DSG variables during the transition and, therefore, the possibility of a successful formation of the islanded system is extended to a wider range of operating conditions. Moreover, with the proposed control, the success of this transition does not depend on the islanding detection time, which is the main contribution of this paper. [ABSTRACT FROM AUTHOR]

This paper proposes a multifunctional control strategy and associated control algorithms for distributed wind-turbine (WT) based nano-grids connected to a distorted utility-grid. The contribution is on a new strategy with innovative control algorithms to coordinate multiple converters for a multitasking operation of the nano-grids. The novelty is on a unique control design with feasibilities: maximizing the generated power from WT, maintaining power quality in both ac- and dc-sides under critical conditions of the power grid, and improving power quality against distortion from local nonlinear loads under a reduced switching frequency. A robust fast-dynamic predictive control method is developed for current controllers to fulfil the multifunction. Unconstrained deadbeat control inputs are derived in twofold targets: ensuring fast dynamic response and significantly reducing both the computation and switching frequency for finite predictive control. The control system is applied on a permanent-magnet synchronous generator (PMSG) WT-based nano-grid connected to a distorted utility-grid. An OPAL-RT-based real-time platform is used for comparative studies among the proportional integration (PI) control, finite predictive control (FS-MPC), and proposed control method. The performance verification exhibits the power quality improvement in both the nano- and utility-grids under critical conditions via high-performed regulation of currents, voltages, reactive power, and rotor-speed of the PMSG-WT. [ABSTRACT FROM AUTHOR]

This paper presents the development of a wind interior permanent-magnet synchronous generator (IPMSG)-based dc microgrid and its operation control. First, the derated characteristics of PMSG systems with various ac/dc converters and operation controls are comparatively analyzed. Then, the IPMSG followed by a three-phase Vienna switch-mode rectifier is developed to establish the common dc bus of dc microgrid. Good developed power and voltage regulation characteristics are achieved via the proposed commutation tuning, robust current, and voltage controls. Second, a single-phase three-wire inverter is constructed to serve as the test load. Good ac 220 V/110 V output voltage waveforms under unknown and nonlinear loads are preserved by the developed robust waveform tracking control scheme. Third, a battery energy storage system is established, and the fast energy storage support response is obtained via the proposed droop control approach with adaptive predictive current control method. In addition, a chopped dump load is equipped to enhance the energy balance control flexibility. [ABSTRACT FROM AUTHOR]