Search

Among the various cell balancing circuits for series-connected batteries, the bidirectional cell-to-cell balancing structure using two switches per cell shows good balancing ability. However, an increase in the number of switches leads to an increase in both cost and size. To reduce the number of switches, this paper proposes a new cell-to-cell balancing circuit with a center-cell concentration structure. The proposed circuit collects the charges of an overcharged cell into the center cell, and then the collected charges are redistributed to the other cells. The proposed circuit has a unidirectional balancing structure with single switch per cell. However, it can achieve competitive balancing ability when compared with the bidirectional structure. In this paper, the operational principles of the proposed circuit are analyzed, and a comparison between the conventional and proposed circuits is shown. To verify the validity of the proposed circuit, experiments with 15.5-Ah batteries are carried out, and the experimental results demonstrate the improved cell balancing ability although a single switch is used per cell. [ABSTRACT FROM AUTHOR]

Among various active cell balancing circuits, a switched capacitor circuit is promising because it can be implemented with low cost and small size. However, when the switched capacitor is applied in the lithium-ion battery, cell balancing speed is generally slow when the number of batteries is high. Therefore, this paper proposes the chain structure of the switched capacitor to increase balancing speed, particularly among outer cells. In this paper, the cell balancing principle of the conventional switched capacitor is explained, and the reason why slow cell balancing of the switched capacitor is shown in the lithium-ion battery is analyzed. To improve cell balancing speed, two circuits with chain structure are proposed. The balancing performance of the proposed circuits is confirmed by computer simulation, and a comparison between conventional and proposed circuits is presented. The theoretical analysis on the cell balancing speed of conventional structures and the proposed chain structure is also shown in this paper. Experimental tests were carried out to verify the validity of the proposed structures, and the experimental results show an improved balancing performance of the proposed circuit. [ABSTRACT FROM PUBLISHER]

This paper presents a hierarchical balancing algorithm for use in large-scale reconfigurable ac battery packs. Using a decentralized battery management system, the pack is organized in control layers with each layer controller responsible for a small number of slave controllers, thereby significantly reducing communication and centralized processing requirements. The hierarchical balancing algorithm uses all available voltage steps in the pack ensuring a high-quality sinusoidal output voltage while balancing the objects of different layers. Balancing priority can be swapped dynamically between layers according to the maximum state of charge (SoC) variation between the objects of each layer while also ensuring that the output voltage reference is always met even when a cell failure occurs, as long as there are an adequate number of cells available in the pack. An experimental demonstration of the proposed balancing algorithm is presented using an ac battery pack comprising 144 20-Ah lithium–titanate cells. Cell balancing to within 2 mV of the cell open-circuit voltage is achieved between cells with 20% initial SoC variation and 5% capacity difference. [ABSTRACT FROM PUBLISHER]

In lithium-ion battery system for hybrid electric vehicle, charge equalizer is essential to enhance the battery life cycle and safety. However, for a large number of battery cells, a conventional equalizer has the difficulty of individual cell balancing and the implementation size problem as well as the cost. Moreover, it shows high voltage stress of electrical elements in the equalization converter due to the high voltage of battery pack. To improve these drawbacks, this paper proposes a modularized two-stage charge equalizer with cell selection switches. The proposed circuit employs the two-stage dc-dc converter to reduce the voltage stress of equalization converter. Contrary to conventional method, the proposed equalizer can achieve the individual cell balancing only through the cell selection switches. With the two-stage converter and the cell selection switches, the proposed equalizer leads to the great size reduction with lower cost which brings advancement of individual cell balancing in a large number of battery cells. In this paper, a prototype for 88 lithium-ion battery cells is optimally designed and implemented. Experimental results are presented to verify that the proposed equalization method has a good cell balancing performance showing the low voltage stress and small size with the lower cost. [ABSTRACT FROM AUTHOR]