Search

Focusing optics operating in the soft gamma-ray photon energy range can advance a range of scientific and technological applications that benefit from the large improvements in sensitivity and resolution that true imaging provides. An enabling technology to this end is multilayer coatings. We show that very short period multilayer coatings deposited on super-polished substrates operate efficiently above 0.6 MeV. These experiments demonstrate that Bragg scattering theory established for multilayer applications as low as 1 eV continues to work well into the gamma-ray band. (C) 2014 Optical Society of America

A soft X-ray, beam-splitting, multilayer optic has been developed for the Bragg Reflection Polarimeter (BRP) on the NASA Gravity and Extreme Magnetism Small Explorer Mission (GEMS). The optic is designed to reflect 0.5 keV X-rays through a 90 degree angle to the BRP detector, and transmit 2-10 keV X-rays to the primary polarimeter. The transmission requirement prevents the use of a thick substrate, so a 2 micron thick polyimide membrane was used. Atomic force microscopy has shown the membrane to possess high spatial frequency roughness less than 0.2 nm rms, permitting adequate X-ray reflectance. A multilayer thin film was especially developed and deposited via magnetron sputtering with reflectance and transmission properties that satisfy the BRP requirements and with near-zero stress. Reflectance and transmission measurements of BRP prototype elements closely match theoretical predictions, both before and after rigorous environmental testing., Comment: 18 pages, 16 figures, accepted for publication in Experimental Astronomy

A soft X-ray, beam-splitting, multilayer optic has been developed for the Bragg Reflection Polarimeter (BRP) on the NASA Gravity and Extreme Magnetism Small Explorer Mission (GEMS). The optic is designed to reflect 0.5 keV X-rays through a 90 degree angle to the BRP detector, and transmit 2-10 keV X-rays to the primary polarimeter. The transmission requirement prevents the use of a thick substrate, so a 2 micron thick polyimide membrane was used. Atomic force microscopy has shown the membrane to possess high spatial frequency roughness less than 0.2 nm rms, permitting adequate X-ray reflectance. A multilayer thin film was especially developed and deposited via magnetron sputtering with reflectance and transmission properties that satisfy the BRP requirements and with near-zero stress. Reflectance and transmission measurements of BRP prototype elements closely match theoretical predictions, both before and after rigorous environmental testing., Comment: 18 pages, 16 figures, accepted for publication in Experimental Astronomy

NuSTAR is a hard X-ray satellite experiment to be launched in 2012. Two optics with 10.15 m focal length focus Xrays with energies between 5 and 80 keV onto CdZnTe detectors located at the end of a deployable mast. The FM1 and FM2 flight optics were built at the same time based on the same design and with very similar components, and thus the performance of both is expected to be very similar. We provide an overview of calibration data that is being used to build an optics response model for each optic and describe initial results for energies above 10 keV from the ground calibration of the flight optics. From a preliminary analysis of the data, our current best determination of the overall HPD of both the FM1 and FM2 flight optics is 52", and nearly independent of energy. The statistical error is negligible, and a preliminary estimate of the systematic error is of order 4". The as-measured effective area and HPD meet the toplevel NuSTAR mission sensitivity requirements.

NuSTAR is a hard X-ray satellite experiment to be launched in 2012. Two optics with 10.15 m focal length focus Xrays with energies between 5 and 80 keV onto CdZnTe detectors located at the end of a deployable mast. The FM1 and FM2 flight optics were built at the same time based on the same design and with very similar components, and thus the performance of both is expected to be very similar. We provide an overview of calibration data that is being used to build an optics response model for each optic and describe initial results for energies above 10 keV from the ground calibration of the flight optics. From a preliminary analysis of the data, our current best determination of the overall HPD of both the FM1 and FM2 flight optics is 52", and nearly independent of energy. The statistical error is negligible, and a preliminary estimate of the systematic error is of order 4". The as-measured effective area and HPD meet the toplevel NuSTAR mission sensitivity requirements.

NuSTAR is a hard X-ray satellite experiment to be launched in 2012. Two optics with 10.15 m focal length focus Xrays with energies between 5 and 80 keV onto CdZnTe detectors located at the end of a deployable mast. The FM1 and FM2 flight optics were built at the same time based on the same design and with very similar components, and thus the performance of both is expected to be very similar. We provide an overview of calibration data that is being used to build an optics response model for each optic and describe initial results for energies above 10 keV from the ground calibration of the flight optics. From a preliminary analysis of the data, our current best determination of the overall HPD of both the FM1 and FM2 flight optics is 52", and nearly independent of energy. The statistical error is negligible, and a preliminary estimate of the systematic error is of order 4". The as-measured effective area and HPD meet the toplevel NuSTAR mission sensitivity requirements.